Philips FC8139 Bedienungsanleitung
FC8139-FC8130
2
3
11
12
8
7
9
10
3
13
16
14
15
2 5
20
21
17
22
23
24
25
26
19
27
28
29
18
41 6
1
4
6
11
16
21
한국어 26
31
37
ภาษาไทย 43
48
繁體中文 53
简体中文 58
67
72
6
Congratulations on your purchase and welcome to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.com/welcome.
Cover
On/off button
Dustbag full indicator
Electronic suction power control
Cord rewind button
Rear wheel
Hose connector
Hose connection opening
Cover release tab
Handle
Dustbag holder
Dustbag
Motor protection lter
Swivel wheel
Type plate
Storage slot
HEPA exhaust lter
Rocker switch for carpet/hard oor settings
Combination nozzle
Parking slot
Mains cord with plug
Exhaust lter grille
Crevice nozzle
Small nozzle
Hard oor nozzle (specic types only)
Small brush
Accessory holder
Telescopic tube
Hose with handgrip and suction power slide
Read this user manual carefully before you use the appliance and save it for future reference.
- Never suck up water or any other liquid. Never suck up ammable substances and do not suck
up ashes until they are cold.
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
- Do not use the appliance if the mains cord, the plug or the appliance itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by
Philips or similarly qualied persons in order to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Do not point the hose, the tube or any other accessory at the eyes or ears nor put it in your
mouth when it is connected to the vacuum cleaner and the vacuum cleaner is switched on.
- Do not suck up large objects as this may cause the air passage in the tube or hose to become
obstructed.
- When you use the vacuum cleaner to vacuum ashes, ne sand, lime, cement dust and similar
substances, the pores of the dustbag and the motor protection lter become clogged. If you
notice a strong decrease in suction power, replace the dustbag and clean the motor protection
lter.
- Always unplug the appliance before you replace the dustbag or clean the lters.
- Never use the appliance without a dustbag or the motor protection lter. This could damage the
motor and shorten the life of the appliance. We advise you to use Philips s-bag ® double-layer
paper dustbags.
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.
1 To connect the hose, push it into the appliance (‘click’) (Fig. 2).
2 To disconnect the hose, press the release buttons (1) and pull the hose connector out of the
hose connection opening (2). (Fig. 3)
1 To connect the tube to the handgrip of the hose, insert the narrow section into the wider
section while turning a little (Fig. 4).
To disconnect the tube, pull while turning a little.
2 Adjust the telescopic tube to the length you nd most comfortable during vacuuming. Press
the slide on the tube (1) and push the lower tube part downwards or pull it upwards
(2) (Fig. 5).
You can use the combination nozzle on carpet (with the brush strips folded in) or on hard oors
(with the brush strips folded out).
- To clean hard oors, push the rocker switch on top of the combination nozzle with your foot to
make the brush strips come out of the nozzle housing. (Fig. 6)
- To clean carpet, push the rocker switch on the other side to make the brush strips disappear
into the housing. (Fig. 7)
- The hard oor nozzle is designed for gentle cleaning of hard oors (Fig. 8).
You can store two accessories in the accessory holder at the same time.
1 Connect the accessory holder to the tube (1) and then connect the hose to the accessory
holder (2) (Fig. 9).
7
2 To store accessories in the accessory holder, push them onto the holder (Fig. 10).
1 Connect the crevice nozzle, small nozzle or small brush to the handgrip of the hose or to
the tube. To do this, insert the handgrip or tube into the accessory while turning a
little. (Fig. 11)
- Use the crevice nozzle to clean narrow corners or hard-to-reach places.
- Use the small nozzle to clean small areas, e.g. the seats of chairs and sofas.
- Use the small brush to clean computers, bookshelves etc.
1 Pull the cord out of the appliance and insert the mains plug into the wall socket.
2 Press the on/off button on top of the appliance with your foot to switch on
the appliance. (Fig. 12)
Note: If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to park the
tube in a convenient position (Fig. 13).
Note: You can carry the vacuum cleaner by the handle at the front of the appliance (Fig. 14).
You can adjust the suction power with:
- the suction power slide on the handgrip (Fig. 15).
- the electronic suction power control on the vacuum cleaner (Fig. 16).
1 Switch off and unplug the appliance before you remove and clean any parts.
2 Clean the appliance and its parts with a damp cloth.
Do not clean any part of the vacuum cleaner in the dishwasher.
To maintain optimal performance, clean the HEPA lter each time you replace the dustbag.
1 To open the HEPA exhaust lter grille, grab the tabs and pull the grille upwards to remove it
from the appliance (Fig. 17).
2 Remove the HEPA exhaust lter.
3 Rinse the pleated side of the HEPA exhaust lter under a hot slow-running tap.
- Hold the lter in such a way that the pleated side points upwards and the water ows parallel
to the pleats. Hold the lter at an angle so that the water washes away the dirt inside the
pleats (Fig. 18).
- Turn the lter 180° and let the water ow along the pleats in the opposite direction (Fig. 19).
- Continue this process until the lter is clean.
Never clean the HEPA exhaust lter with a brush (Fig. 20).
Note: Cleaning does not restore the original colour of the lter, but does restore its ltration power.
4 Carefully shake the water from the surface of the HEPA exhaust lter. Let the HEPA exhaust
lter dry completely before you put it back into the vacuum cleaner.
5 Place the dry HEPA exhaust lter back into the appliance.
8
6 To close the HEPA exhaust lter grille, rst align the lugs on the top of the grille with the
slots in the appliance (1). Then press the tabs downwards until the grille locks into place
(2) (‘click’) (Fig. 21).
To maintain optimal performance, clean the motor protection lter at least once a year.
1 Pull the cover upwards to open it (Fig. 22).
2 Lift the dustbag holder out of the appliance. (Fig. 23)
Make sure you hold the dustbag upright when you lift it out of the appliance.
3 Pull the lter holder with the motor protection lter out of the appliance. (Fig. 24)
4 Take the motor protection lter out of the holder. Shake the motor protection lter over a
dustbin to clean it.
5 Put the lter in the lter holder and slide the lter holder back into the appliance.
6 Put the dustbag holder back into the appliance.
- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the oor (Fig. 25).
1 Switch off and unplug the appliance.
2 Pull the cover upwards to open it.
3 Lift the dustbag holder out of the appliance.
Make sure you hold the dustbag upright when you lift it out of the appliance.
4 Pull at the cardboard tag to remove the full dustbag from the holder (Fig. 26).
,When you do this, the dustbag is sealed automatically.
5 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder as
far as possible. (Fig. 27)
6 Put the dustbag holder back into the vacuum cleaner (Fig. 28).
Note: If no dustbag has been inserted, you cannot close the cover.
7 Push the cover downwards to close it.
Always unplug the appliance before you replace a lter.
Replace the HEPA exhaust lter every 12 months.
- To remove the old lter and place the new lter, follow the instructions for removing and
placing the lters in section ‘Cleaning the HEPA exhaust lter’ in chapter ‘Cleaning and
maintenance’.
- Philips Classic s-bag ® synthetic dustbags are available under type number FC8021.
- Philips Clinic s-bag ® high ltration synthetic dustbags are available under type number FC8022.
- Philips Anti-odour s-bag ® synthetic dustbags are available under type number FC8023.
- Reusable dustbags (some countries only) are available under code number 4322 004 93370.
9
Note: Please visit www.s-bag.com for more information about the s-bag.
- HEPA exhaust lters are available under type number FC8070.
1 Switch off and unplug the appliance.
2 Press the cord rewind button to rewind the cord (Fig. 29).
3 Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge on
the nozzle into the storage slot.
Note: To ensure stable storage of the telescopic tube, adjust the tube to the shortest length.
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the
environment (Fig. 30).
If you need service or information or if you have a problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer Care Centre in your country (you nd its phone
number in the worldwide guarantee leaet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
1 The suction power is insufcient
- Perhaps the dustbag is full.
If necessary, empty the dustbag.
- Perhaps the lters need to be cleaned or replaced.
If necessary, clean or replace the lters.
- Perhaps the suction power slide on the handgrip is open.
Close the slide.
- Perhaps the electronic suction power control is set to a low setting.
Set the control to a higher setting.
- Perhaps the nozzle, tube or hose is blocked up. (Fig. 31)
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the
other way round. Switch on the vacuum cleaner to force the air through the blocked-up item in
opposite direction.
10
Andere Handbücher für FC8139
2
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere Philips Staubsauger Handbücher
Philips
Philips FC8459 Bedienungsanleitung
Philips
Philips FC9018/01 Bedienungsanleitung
Philips
Philips Ledino 41621/48/16 Bedienungsanleitung
Philips
Philips FC8820 Bedienungsanleitung
Philips
Philips FC9170/02 Bedienungsanleitung
Philips
Philips HR 8901 Bedienungsanleitung
Philips
Philips FC8148 Bedienungsanleitung
Philips
Philips FC8796 Bedienungsanleitung
Philips
Philips FC8219 Bedienungsanleitung
Philips
Philips FC9557/09 Bedienungsanleitung
Philips
Philips FC8137/01 Bedienungsanleitung
Philips
Philips Impact-plus FC 8388 Bedienungsanleitung
Philips
Philips FC8715 Bedienungsanleitung
Philips
Philips Impact HR8353/01 Bedienungsanleitung
Philips
Philips FC6409 Bedienungsanleitung
Philips
Philips FC6723 Bedienungsanleitung
Philips
Philips FC6050 Bedienungsanleitung
Philips
Philips HomeRun Aqua 7000 Series Bedienungsanleitung
Philips
Philips Marathon FC9200 Bedienungsanleitung
Philips
Philips FC9522/09 Bedienungsanleitung
Beliebte Staubsauger Handbücher anderer Marken
Bissell
Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung
Panasonic
Panasonic MC-YL637S147-AE Bedienungsanleitung
NEFF
NEFF N17XH10 0 Series Bedienungsanleitung
LG
LG A9 Series Bedienungsanleitung
Oreck
Oreck Cordless Captura BK51700 Series Bedienungsanleitung
Kogan
Kogan KAVACROBVWA Bedienungsanleitung
