Siemens FUG1010 IP65 NEMA 4X Bedienungsanleitung

Ultrasonic flowmeters

SITRANS FUG1010 IP65 NEMA 4X

Instruction Manual - September 2008

SITRANS F

Field Manual CQO:1010GCNFM-3

September 2007

For use with Operating System

Software Version 3.01.05E or later

This equipment contains components that are

susceptible to electrostatic discharge (ESD).

Please observe ESD control measures during

the handling and connection process.

Printed September 2007

SITRANS FUG 1010GCN/GCDN

CLAMP-ON MUTI-FUNCTION

GAS FLOWMETER

Prepared By Date

Reviewed By Date

IMPORTANT NOTICE

Controlotron is now part of:

Siemens Energy & Automation, Inc.

Process Instrumentation Business Unit (PI BU)

CoC Ultrasonic Flow

Manual Changes

NOTE: For the latest updates and revisions to this field manual go to:

http://support.automation.siemens.com/ and check the Product Manual listing.

E-1

1010FMA-46

Errata

Digital Pgen Function and Wiring Procedure Update

ERRATA

NOTE: The following applies to System 1010GN, 1010GCN and 1010GCSN Gas Flowmeter instal-

lation manuals.

Replace the PGEN menu cell description and set up procedure in the Data Span/Set/Cal menu Span Data

option list including any related menu graphics and text throughout the manual with the following:

1010GUDN,1010GCCDN, 1010GCSCDN

(Expanded 1010N-7 I/O Module)

Installation Drawing 1010N-7-7 (Sheet 3 of 3)

(Ultra Performance Flowmeters)

PGEN

The [PGEN P/Unit Volume] menu cell entry controls a digital output pulse function and is available in

Custody Transfer units only (designated by a “C” or “U” in their part number). It allows the assigning of

PGEN digital signal pulses per unit of volume. For example, 1000 output pulses per cubic foot of gas.

The default PGEN value is configured to provide a 5000 Hz output frequency at a flow velocity of 100 ft/

sec (30 meters/sec).

NOTE: The unit of volume is determined by the Volume Units initially selected from the [Total

Volume Units] menu cell option list.

(continued on next page)

PIN# SIGNAL FUNCTION NOTES

9 PG1 PRIMARY FREQUENCY OUTPUT / OPEN COLLECTOR Digitally Synthesized

10 PG2 PRIMARY FREQUENCY OUTPUT / TTL Pulse Waveform

11 PG3 QUADRATURE FREQUENCY OUTPUT / OPEN COLLECTOR

12 PG4 QUADRATURE FREQUENCY OUTPUT / TTL

TB2

E-2

1010FMA-46Errata

PGEN Wiring Diagram

The unit must be wired as shown below before assigning PGEN output pulses.

1. TB2-9 & TB2-11 are Open Collector Outputs that

require external pull up resistors for operation.

See table on next page for External Supply Voltage

and suggested resistor value and ratings.

Maximum current into the transistor is 100mA.

Maximum Voltage is +36Vdc.

CAUTION: Negative voltages with respect ground will

permanently damage the transistors.

2: TB2-10 & TB2-12 are TTL/CMOS compatible outputs.

No pullup resistor is required.

CAUTION: Application of any external voltage, even

via a resistor, could permanently damage this circuit.

NOTES

+5V

PG1

PG3

PG4

3 2

PG2

DPGEN_1-Ø1

DPGEN_1-Ø2

DPGEN_2-Ø2

OC PGEN SIGNAL

GROUND

OC PGEN SIGNAL

TTL PGEN SIGNAL

TB2-2 GND

[VO1-]

DPGEN_2-Ø1 2

TTL/CMOS

TB2-2 GND

[VO1-]

TB2-4 GND

[VO2-]

TTL/CMOS

SEE TABLE

TTL PGEN SIGNAL

TO END USER

EQUIPMENT

GROUND

TO END USER

EQUIPMENT

SEE TABLE

TO END USER

EQUIPMENT

TB2-4 GND

[VO2-]

GROUND

TO END USER

EQUIPMENT

GROUND

TB2-09 DPGEN_1-Ø1

OPEN COLLECTOR

REFERENCE PHASE

5-36VDC, 15-20mA

NOMINAL CURREN

CONSUMPTION

TB2-10 DPGEN_2-Ø1

TTL LOGIC

REFERENCE PHASE

TB2-11 DPGEN_1-Ø2

OPEN COLLECTOR

QUADRATURE PHASE

TB2-12 DPGEN_2-Ø2

TTL LOGIC

QUADRATURE PHASE

5-36VDC, 15-20mA

NOMINAL CURREN

CONSUMPTION

1010N-1

MAIN BOARD 1010N-7K, -7K2 OR -7K3

I/O CONNECTION BOARD

1010N-7K, -7K2 or 7K3 I/O MODULES WITH ULTRA PRECISION FLOWMETERS

OPEN COLLECTOR USER RESISTOR RECOMMENDATIONS

USER SUPPLY

VOLTAGE

[Vdc]

EXTERNAL

R1 OR R2

[Ohms]

270

510

680

1000

1500

1800

2400

EXPECTED

CURRENT DRAW

[mA]

18.5

17.6

15.5

RECOMMENDED

RESISTOR WATTAGE

[WATTS]

1/2

3/4

1-1/4

E-3

1010FMA-46

Errata

REFERENCE

QUADRATURE LEADS

FOR NEGATIVE FLOW

QUADRATURE LAGS

FOR POSITIVE FLOW

PG3 and PG4 LAGS PG1 and PG2 by 90º

PG1 or PG2

PG3 or PG4

FOR NEGATIVE FLOW

PG3 and PG4 LEADS PG1 and PG2 by 90º

PG1 or PG2

PG3 or PG4

To change the default PGEN settings:

From the [Span Data] menu press

From the [PGEN P/Unit Volume] menu cell, press to activate the numeric entry.

Use the numeric keys to enter the desired number of PGEN pulses per unit volume.

NOTE: Ensure that the number entered will provide sufficient resolution while remaining within

the 20 Hz to 5000 Hz pulse frequency range. Note that the PGEN output will stop send-

ing pulses at flow rates corresponding to frequencies less than 20 Hz. In this case the

PGEN value must be increased.

To store the data press ENT

MANUAL

ADDENDUM

Manual Addendum

September 2008

1010FMA-56

Operating System Software

Version Update

Andere Handbücher für FUG1010 IP65 NEMA 4X

Inhaltsverzeichnis

Andere Siemens Messgerät Handbücher

Siemens

Siemens SITRANS F US SONOFLO Bedienungsanleitung

Siemens

Siemens SITRANS F MAG 6000 I Bedienungsanleitung

Siemens

Siemens Opdima MAMMOMAT 1000 Anleitungen und Rezepte

Siemens

Siemens Milltronics A-40 Bedienungsanleitung

Siemens

Siemens SITRANS LR 300 Gebrauchsanweisung

Siemens

Siemens SITRANS F M Leitfaden

Siemens

Siemens Sitrans LR200 Benutzerhandbuch

Siemens

Siemens SICAM Q80 Bedienungsanleitung

Siemens

Siemens 9510 Bedienungsanleitung

Siemens

Siemens ULTRAMAT 6 Bedienungsanleitung

Siemens

Siemens 5SV8000-6KK Bedienungsanleitung

Siemens

Siemens SICAM 7KG85X Bedienungsanleitung

Siemens

Siemens SIPROCESS GA700 Bedienungsanleitung

Siemens

Siemens SITRANS F TRANSMAG 2 Bedienungsanleitung

Siemens

Siemens SITRANS LR 400 Bedienungsanleitung

Siemens

Siemens SITRANS FC430 Kurzanleitung

Siemens

Siemens Sitrans F Series Bedienungsanleitung

Siemens

Siemens sitrans lr 460 Bedienungsanleitung

Siemens

Siemens SMART 7KT Bedienungsanleitung

Siemens

Siemens SITRANS AID IQ Bedienungsanleitung

Siemens

Siemens SITRANS FX300 Verdrahtungsschema

Siemens

Siemens 13-xx-ST-SBT Series Bedienungsanleitung

Siemens

Siemens 5SV8 200-6KK Service-Handbuch

Siemens

Siemens SENTRON PAC3120 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

KLINGER

KLINGER CMF V Series Bedienungsanleitung

Keysight

Keysight M8290A Bedienungsanleitung

Acterna

Acterna MS1400 Bedienungsanleitung

R&S

R&S ZPH Bedienungsanleitung

Datacolor

Datacolor ColorReader DC10-2 Bedienungsanleitung

Konica Minolta

Konica Minolta BC-10 Plus Bedienungsanleitung