Sirius Satellite Radio SLTC919 520 Bedienungsanleitung

Congratulations on your purchase!

Thank you for choosing a Sirius product.

www.siriusbrand.com

SLTC919

UNDERMOUNT RANGEHOOD INSTALLATION INSTRUCTIONS

SLTC919 520 EAN # 9351116002244

SLTC919 580 EAN # 9351116002251

The symbol on the product or on its packaging indicates that this product

may not be treated as house-hold waste. Instead it shall be handed

over to the applicable collection point for the recycling of electrical and

electronic equipment. By ensuring this product is disposed of correctly,

you will help prevent potential negative consequences for the environment

and human health, which could otherwise be caused by inappropriate

waste handling of this product. For more detailed information about

recycling of this product, please contact your local city office, your

household waste disposal service or the shop where you purchased the

product. This appliance is marked according to the European directive

2002/96/EC on waste electrical and electronic equipment (WEEE).

BEFORE YOU INSTALL – please read

Sirius warranty covers only Sirius product. If you choose to install a non-Sirius

branded accessory such as flexible ducting, Sirius will only warrant the hood

and motor. If installation is found to be the cause of failure or issue then charges

will apply for service and parts.

Flexible ducting is not permitted under any circumstances. Flexible ducting has

been found to increase noise levels, increase vibration and reduce airflow.

Sirius Semi-rigid or solid ducting can be used in lieu. There is a range available

to suit any application.

Ducting available at www.siriusbrand.com

A reduction in the duct diameter from stated ducting size will void warranty.

If you are in doubt about the ducting, please contact Sirius on 1300 762 219 prior to installation

CAUTION

Min. 600mm - Max. 650mm for induction cooktops.

Min. 600mm - Max. 750mm gas cooktops.

If the rangehood is positioned above the max height

recommended, warranty may be compromised

as performance of the rangehood will be affected.

Measurement is taken from the top of the trivets to

the underside of the hood. (Fig.1)

• The air being drawn can’t be conveyed through

or into a duct used to let out fumes from

appliances fed by energy other than electric

power (eg. centralized heating, radiators, water

heaters, etc.).

• Attention: remove any possible PVC film from the

stainless steel, including the filters.

• To externally vent, please comply with the

pertaining rules given by competent authorities.

• Provide the room with an adequate ventilation

when a rangehood and appliances fed by energy

other than electric power (gas, oil, or coal stoves,

etc.) are used simultaneously. The rangehood,

when evacuating the air, could generate a

negative pressure in the room which can’t exceed

the limit of 0.04 mbar, in order to avoid the

suck of exhausts deriving from the heat source.

Therefore the room should be provided with air

intakes to allow a constant flow of fresh air.

If the rating label in the rangehood shows the symbol

, the appliance is built in class II° and it does not

need any earth connection.

If the rating label in the rangehood does not show

the symbol , the appliance is built in class I° and it

needs the earth connection.

When performing the electrical connections on the

appliance, please make sure that the current-tap

is provided with earth connection and that voltage

values correspond to those indicated on the label

placed inside the appliance itself.

Before carrying out any cleaning or maintaining

operations, the appliance needs to be switched off.

If the appliance is not provided with a non-separable

When ducting rangehood, options are as follows:

Roof vent - EASYROOF 150T/M

*Kit includes roof flashing

Download installation guide

Eave vent - EASYEAVE 150

Download installation guide

Wall vent - EASYWALL 150

Download installation guide

flexible cable and plug, or with another device

ensuring omnipolar disconnections from the grid,

with an opening distance between the contacts of at

least 3mm, then such disconnecting devices must be

supplied within the fixed installation.

If the fixed appliance is endowed with a supply cord

and a plug, the appliance has to be put in a place

where the plug can be reached easily.

The use of materials which can burst into flames

should be avoided in close proximity of the appliance.

When frying, please pay particular attention to fire

risk due to oil grease. Being highly flammable, hot

oil is especially dangerous. Do not use uncovered

electric grills. In order to avoid possible fire risk, all

instructions for grease-filter cleaning and for removing

eventual grease deposits should be strictly followed.

WARNING

600 - 650mm (induction)

600 - 750mm (gas)

600 - 650mm (induction)

600 - 750mm (gas)

(Fig. 1)

(Fig. 2a)

(Fig. 2b)

(Fig. 2c)

Dome

featured on

200mm kit

only

SIDE VIEW FRONT VIEW

Remove the grease filters before installing the

product, in order to avoid to damage the appliance.

Open the glass by rotating it as shown in fig. 3; then

remove the grease filters by acting on their specific

handle and rotate them to remove them from their

seating.

Make an opening on the kitchen cabinet bottom of

the following sizes:

SLTC919 520: 265mm x 498mm

SLTC919 850: 265mm x 835mm

To install the appliance please respect the follow

instructions:

• The appliance must be installed by qualified

technicians, or where possible use a Sirius

recommended installer. See siriusbrand.com. In

order to avoid damage to the electronic parts

of the appliance, please do not use additional

screws.

• Essential precautions to respect before installing

the appliance are the following:

To have made a cutout on the bottom of the

cabinet which is suitable to hold the appliance in

position (fig. 4):

• Prepare the power supply - 240 volt.

• Prepare a hole for the ducting - 160 mm

diameter.

• Maximum length of ducting should not exceed 7

metres to atmosphere.

• Do not use screws to fix the outlet pipe to the

rangehoods as they will prevent the movement of

non-return valves.

• Limit the number of elbows in the ducting, since

each elbow reduces the duct efficiency by 1

metre. (i.e. if you use two 90° elbows, the length

of ducting must not exceed 5 metres.)

• Avoid abrupt direction changes.

• Use 150mm constant diameter ducting for the

whole length for the single motor.

• The use of Sirius ducting will increase the

warranty of the unit to 4 years.

(Fig.4)

(Fig.5)

SLTC919 series INSTALLATION

Before installing the appliance, make sure that

none of the parts are damaged in any way. In

case of damaged parts, contact your retailer

and do not proceed with installation. Read all

of the following instructions with care before

installing the appliance.

• 10AMP GPO required at head unit.

• Use ducting within the min/max specifications

• Limit the number of ducting bends.

• Do not make any changes in ducting diameter

(recommended constant diameter: Ø 150 mm or

equal surface area).

NOTE

(Fig.3)

• Rotate the steel bar, including the LED bar, to

remove it from its seating (Fig. 6 - 7). You can

electronically disconnect the bar by disconnecting

the specific connector.

• Refit the stainless steel bar previously removed,

connect the LED bar electrically by means of the

specifc connector, and then refit the grease filter.

• Place the appliance inside the cabinet and fix it

by inserting the screws supplied into the holes, as

shown in Fig.8.

(Fig.6)

(Fig.7)

(Fig.8)

(Fig.7a) (Fig.7b)

CAUTION

Before connecting any ducting to the motor,

make sure the non-return valves - which are on

the air outlet of the motor - can swing open.

External venting

• Connect the flange to the exhaust hole with the

appropriate ducting. Connect the rangehood with

the electrical mains through the supply cord.

Rear vented version

• All the models with one motor can be rear

vented; if the customer wants to use this option,

it is necessary to remove the 18 screws from

the motor group support. Then take the metal

support with motor included out (fig.7a). Turn

the motor to have the air outlet on the rear side

(fig.7b) and fix the scews previously removed.

• Accurate maintenance guarantees good

functioning and long-lasting performance.

• Particular care is due to the grease filter panel. It

can be removed by pushing its handle toward the

back side of the rangehood and pulling the filter

downwards so to unfasten it from its slot (Fig.3).

To insert the filter just perform the opposite

operation.

• After 30 hours of operation, the push button

control panel will flash, signaling the filters are due

for cleaning. Press the timer button to reset.

The grease filter needs cleaning by regular

handwashing or in dishwashers every two

months at least, depending on its use.

• To clean the appliance itself, water and detergent

are recommended, while abrasive products

should be avoided. For steel appliances

specialized detergents are recommended (please

follow the instructions indicated on the product

itself to obtain the desired results).

MAINTENANCE

LED Bar replacement

To remove the LED, it is recommended to remove the

steel bar as shown in Fig.6 and 7, then disengage the

LED bar by acting on the specific fastening springs.

Replace the LED bar with one of the same

characteristics.

Refit the Steel bar.

If the supply cord is damaged, it must be

replaced by the manufacturer or its service

agent or a similarly qualified person in order to

avoid a hazard.

SLTC919 series

A: Light switch on/off

B: Motor OFF / Reduce speed

C: Fan-speed indictor

D: Motor ON / Increase speed

E: 10 minute shut-off timer

If the electrical power supply to the product SLTC is

cut, 15 seconds are needed for self-diagnostics after

the functions are restored.

Internal motor models, with maximum air capacity

higher than 650m3/h, are equipped with a timer

device that automatically switches the suction speed

from 4th to 3rd speed, after 5 minutes of operation.

The energy consumption of the appliance in standby

mode is lower than 0.5W.

OPERATION

A B CDE

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sirius Satellite Radio Dunstabzugshaube Handbücher

Sirius Satellite Radio

Sirius Satellite Radio SILT18 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT972 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC93 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUT950 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL913 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUF1 Handbuch

Sirius Satellite Radio

Sirius Satellite Radio SUTC919 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SILT-21 B Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL926 Series Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUM Series Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL906 L 1500 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC919 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC EM 97 900 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio ALFRESCO SL83 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT955 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio S-DDH3 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio S-DD2-L EMIC 880 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC928 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL85 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SEM1 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio Valentina SLT977EMEL Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT960 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT105 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio S900 Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch