Sirius Satellite Radio SUT950 Bedienungsanleitung

INSTALLATION

INSTRUCTIONS

Models covered by this instructions:

SUT950 - SUT951 - SUT958 - SUT968

*** BEFORE INSTALLATION ***

ENSURE THERE IS NO VISIBLE OR HIDDEN DAMAGE SUSTAINED DURING SHIPPING

*** SHIPPING DAMAGE ***

MUST BE REPORTED WITHIN 5 DAYS OF RECEIPT

Ceiling Hood

CARE AND USE MANUAL FOR:

WARNING

Thank you for purchasing a Sirius Range Hood.

Please read all the instructions in this manual before

installing the appliance.

Save these instructions for future reference.

Only use this appliance as an exhaust ventilation system for the re-

moval of cooking vapors. DO NOT use to expel ammable substan-

ces or any other materials or vapors.

The installation procedures in this manual are intended for quali-

ed installers, service technicians or persons with similar qualied

background.

DO NOT attempt to install this appliance yourself.

Ensure that electrical power is turned off at source before commen-

cing installation. All electrical wiring must be properly installed, insula-

ted and grounded and conform to all applicable codes and standards.

Make sure all existing duct work is clean of grease build up, or duct

work should be replaced, if necessary, to avoid the possibility of a

grease re. Check all joints on ductwork to ensure proper connec-

tion and all joints should be properly taped. Be careful when cutting

through ceilings or walls not to damage any hidden pipes or electrical

wiring. Ensure your kitchen has sufcient air return vents to replace

the exhausted air.

Fan ducts should always be vented to the outside of your home and

never into spaces within walls, ceilings, lofts or attics. Only use rigid,

smooth steel for ducting. The exhaust point of the blower requires a

6” round or 8” connection.

TABLE OF CONTENTS

BEFORE YOU BEGIN 4

DUCTING 4

ELECTRICAL

Electrical Supply 5

INSTALLATION

Before the installation 6

Panels opening 6

Installation 6

OPERATING PROCEDURES

General Advice 11

Technical data 12

Standard conguration 12

Generating a new transmission code 12

Learning the new transmission code 12

MAINTENANCE

Cleaning the Filter 14

Cleaning the Hood 14

Substitution of the LED bar 14

WARRANTY SERVICE 16

BEFORE YOU BEGIN: It is advisable to

test run the range hood before installa-

tion.

BEFORE STARTING – please read this

entire document and ensure you are fully

conversant with the require-ments and li-

mitations. These units weigh approximately

125lbs and therefore require a minimum of

two people to install.

Recommended height from cook top to un-

derside of hood = 30” for gas, 25” for elec-

tric.

BEFORE YOU BEGIN

The manufacturer declines all responsibility

in the event of failure to observe the instruc-

tions given here for installation, maintenan-

ce and suitable operation of the product. The

manufacturer further declines all responsibi-

lity for injury due to negligence and the war-

ranty of the unit automatically expires due

to improper maintenance and/or installation.

Use the shortest most direct ductwork rou-

te possible. Only use metal ducting - plastic

ducting is generally not permitted by code.

Do not use exible metal ducting as the rid-

ges of the ducting cause severe air turbulen-

ce and will signicantly reduce the efcien-

cy of any hood -THIS TYPE OF DUCTING

WILL REDUCE EFFICIENCY BY 50%.

Vent hoods may interrupt the proper ow of

exhaust gases from re-places, gas furna-

ces and gas water heaters. To minimize the

risk of drawing these lethal gases back into

the home please follow the heating equip-

ment manufacturers safety standards and

guidelines. Refer to NFPA and ASHRAE for

additional information.

DUCTING

If vented externally, 6” / 150mm round duc-

ting must be available for the hood through

the ceiling, in line with the central vertical

axis of the range hood.

This unit must have it’s own ductwork. Do

not under any circumstances vent this unit

into any other ductwork or exhaust ducting

in the building.

Furthermore, please read carefully all of the

following installation instructions.

- Use an exhausting pipe whose maximum

length does not exceed 5 meters.

- Limit the no. of elbows in the piping, since

each elbow reduces the air capacity

of 1 linear meter. (Ex.: if you use no. 2 x 90 °

elbows, the length of piping must not exceed

3 meters).

- Avoid abrupt direction changes.

- Use a 6”/8” mm constant diameter pipe for

the whole length.

- Use piping approved by standards in force.

Electrical Supply.

This appliance requires 120V/60Hz, 3amp

electrical supply - ensure an appropriately

qualied person completes the electrical ho-

ok-up. The connection point for the electrical

supply is at the top of the unit, therefore the

electrical supply must be run down from the

ceiling alongside the ductwork.

All electrical and venting hook-ups must be in

place before commencing installation of the

hood-fan.

ELECTRICAL

WARNING: All electrical work must be

performed by a qualied electrician.

Please ensure that the appropriate electrical

codes or prevailing local building codes and

ordinances are adhered to.

Ensure that the electricity supply is discon-

nected at source. Do not use an extension

cord or adapter plug with this appliance.

This appliance must be grounded. Connect

to a properly grounded branch circuit, pro-

tected by a 15 amp circuit breaker.

BEFORE THE INSTALLATION

This models can be used only if connected

with external motors produced by the same

manufacturer.

PANELS OPENING

It is possible to open the steel panels, which

cover the grease lters, by slightly pulling on

a side of the panel itself, as shown in Fig. 1.

INSTALLATION

SUT958: 34” 4/64 x 15” 60/64

distance of 12” between the ceiling and the

false ceiling.

SUT968: 41” 15/16 x 26” 3/16

distance of 12” between the ceiling and the

false ceiling.

After having chosen the most suitable posi-

tion, prepare the ducting: an air outlet con-

nection piece, with a diameter of 6” to be in-

stalled in the side selected, is provided with

the appliance.

Leave any unused exhaust outlets closed.

As shown in g. 2.

To achieve the complete opening of panels,

you need to release the safety chains, by

using the appropriate spring catches.

For proper working, it is recommended to in-

stall the appliance at a distance of 83” from

the oor.

Before starting the appliance installation, ple-

ase check that all components are not dama-

ged, in such a case contact your retailer and

do not carry out installation.

INSTALLATION

Fit a false ceiling with an opening that has the

following dimensions:

SUT950: 57” 43/64 x 37” 63/64

distance of 12” between the ceiling and the

false ceiling;

SUT951: 41” 59/64 x 26” 12/64

distance of 12” between the ceiling and the

false ceiling;

Draw the outline of the hole to house the

ceiling-mounted hood on the solid ceiling as

shown in Fig. 3 according to the model cho-

sen.

Make 4 holes in the ceiling according to the

dimensions as shown in Fig. 4, place the

metric plugs provided in the holes.

Open the stainless steel panels and remove

the grease lters in order to avoid damaging

them in any way and too allow installation;

screw the threaded bars provided into the

plugs as shown in g. 5.

SUT950 SUT951 SUT958:

The threaded bars are 9” 27/32 long and ser-

ve to install the ceiling-mounted hood at a

distance from the solid ceiling of between

10” 40/64 and 14” 9/16 as shown in g. 6.

MAX

10” 40/64 MAX

14” 36/64

SUT951

SUT950

SUT958

SUT968

in case of a larger gap between the hood

and the ceiling, you need to use longer th-

readed bars.

Connect the power supply into the metal box

placed inside the hood as shown in g. 7.

and connect the air outlet pipe.

Do not x the ducting to the outlet with

screws - use DUCT TAPE; place the ceiling-

mounted hood into the niche, the outer edge

of the hood needs to be perfectly ush with

the false ceiling. Insert the plates and nuts

provided on the threaded bars, making sure

to tighten them securely, as shown in Fig. 8;

ret the grease lters and lter cover panels.

FOR SUT968 MODEL ONLY:

The appliance has the motor air out-let po-

sitioned on its short side; nevertheless you

can choose the side of the hood from which

collected air is to be discharged as follows:

open the panel, following the instructions

given in the ‘PANELS OPENING’ section

and remove the grease lters. Remove the

4 screws, as shown in gure 7. Remove the

lower plate , as shown in gure 8. Remove

the motor xing screws, as shown in gure

9. Make a hole either in the center of the

hood top side (g. 10) or long side (g. 11).

Fix the metal cover where the motor was

previously placed using the four screws sup-

plied. (g. 12). If you choose to install the

motor with the air outlet directed upwards,

installation will not entail the use of the mo-

tor supporting metal plate , as the motor will

be xed directly on the hood body, as shown

in gure 13.

If you choose to have the air outlet on the

hood short side, the exhaust duct xing ope-

rations can be made easier by removing the

cover shown in g. 14.

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

Fig. 13

Fig. 14

Andere Handbücher für SUT950

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sirius Satellite Radio Dunstabzugshaube Handbücher

Sirius Satellite Radio

Sirius Satellite Radio SLTC 111 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL906 DL Series Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL85 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL906 Series Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL920 FRESCO Series Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio Valentina SLT958EM Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUT950 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio 9351116001063 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio FSED Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SIU3 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SU1 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL906 L 1500 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUF6 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SUF1 Handbuch

Sirius Satellite Radio

Sirius Satellite Radio ALFRESCO SL83 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SIL-EM490X Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC EM 97 900 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SM923L520 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT976 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLT960 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SM923 520 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SL909 Kurzanleitung

Sirius Satellite Radio

Sirius Satellite Radio SLTC EM 107 G900 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SM927 Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch