2. FILTER
6. BOLT
SPECIFICATIONS
OPERATING CONDITIONS
S060032R
TROUBLESHOOTING
"MONO" THERMOSTAT BATH & SHOWER SET TX449SM
3
5
7
Body
Fillter
4
6
Adjust the safety knob on the handle with number 40 in the body, then install the handle
If get the water temper ature at 40ºC, release the
handle. Make sure the spindle not rotated.
Handle
Spindle
Bolt
Handle
40oC
Safety Knob
Open full the stop valve and check the water
temperature 40ºC. When water temperature not
40ºC, set the water temperature until get 40ºC
then follow step 6 and 7.
Bolt
Cap
Cap
Screw
Hand
Shower
Fexible Hose
7. BOLT
3. STRAINER
2 XØ8
Holes
Sleeve
Anchor
MAINTENANCE
Check leg position with template
Template Leg
CHECK
POINT
Unsatisfactory spray 1 Clean
Flow rate unsatisfactory 2 , 3 Remove and clean
Water leaks around the handle 4, 5 Tighten
Handle is loose 6 , 7 Tighten
All Finishes: Clean the finish with mild soapand warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toiletcleaneretc. which could adversely affect the finish and
are not recommended for cleaning
1. Don t use abrasive cleaners or solvents on faucets and fittings.
Press safety knob turn left to increasetemperature over 40oC.
Please don't open the thermostat cartridge, because it cause to
unstabilize temperature in this product.
FlowRegulator should not be remove because it could damage
the system
As the product model is constantly updated, the actual product
maynot lookthe same as it shown in the diagram, but the basic
installation principles are the same.
2.
3.
4.
5.
Hot & Cold Water supply pressure :
Minimum 0.05 MPa. - Maximum 0.75 MPa.
Hot water supply temperature shall be higher by 10oC. at
least,than desired temperature ofmixed water.
(Recommendation: Hot water supply temperature = 60oC)
Hot water supply pressure shall be the sameor lowerthan
cold water supply .
Ensure that water supply is clean( No Sand,Dirt, Etc.).
1.
2.
3.
4.
