Ubiquiti LiteBeam M5 LBE-M5-23 Bedienungsanleitung

5 GHz, 23 dBi airMAX®CPE

with InnerFeed™Technology

Model: LBE-M5-23

Introduction

Thank you for purchasing the Ubiquiti Networks® LiteBeam™.

This Quick Start Guide is designed to guide you through

installation and also includes warranty terms.

Package Contents

Antenna Feed Center Reflector

Panel

Side Reflector Panels

(Qty. 2)

Feed Receiver Ball Joint Mount Metal Strap

5 GHz 23 dBi airMAX®CPE

with InnerFeed™Technology

Model: LBE-M5-23

PoE Adapter

(25V, 0.2A)

Power Cord Quick Start Guide

Products may be different from pictures and are subject to change without notice.

cable and earth grounding must be used as conditions of product warranty. TOUGHCable™is

designed for outdoor installations. It is the customer’s responsibility to follow local country

regulations, including operation within legal frequency channels, output power, and Dynamic

Frequency Selection (DFS) requirements.

Installation Requirements

• 7 mm socket wrench or screwdriver

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from the

harshest environments and devastating ESD attacks with

industrial‑grade shielded Ethernet cable from Ubiquiti

Networks. For more details, visit www.ubnt.com/toughcable

Application Examples

The LiteBeam mounted outdoors with the reflector

installed provides directional outdoor coverage (gain

reflector‑dependent).

The LiteBeam mounted outdoors without the reflector

installed provides outdoor‑to‑indoor coverage using the 3 dBi

Antenna Feed only.

Hardware Overview

Bottom View

Technology

Reset

Button

Lock Nut

Antenna Feed

Securing

Arms

Port Cover

Reflector Assembly

Feed Receiver

Ball Joint Mount

Ethernet

Port

Ports

Ethernet Port Supports 10/100 connections and passive PoE.

This port should be connected to the LAN and DHCP server.

Reset Button To reset to factory defaults, press and hold the

Reset button for more than 10 seconds while the LiteBeam is

already poweredon. Alternatively, the LiteBeam may be reset

remotely via a Reset button located on the bottom of the

PoEAdapter.

LEDs

Wireless Connection The LED will light green

when a wireless connection is established.

Ethernet The LED will light steady green when

an active Ethernet connection is made and flash

when there is activity.

Power The LED will light green when the device

is connected to a power source.

Hardware Installation

1. Assemble the antenna reflector by attaching the Side

Reflector Panels to the Center Reflector Panel:

a. Insert the heads of the two mounting studs on the

Center Reflector Panel into the large opening of the

slotted holes of a Side Reflector Panel.

b. Slide the Side Reflector Panel down until the top edges

of the panels align. The Side Reflector Panel is captured

when both heads of the mounting studs are positioned

over the narrow opening of the slotted holes.

c. Repeat the assembly for the other Side Reflector Panel.

2. Hold the reflector assembly by hand (do not use a tabletop

or flat surface) and insert the Feed Receiver into the

reflector assembly to secure the panels:

a. Align the arrows on the Center Reflector Panel and the

Feed Receiver, and insert both edges of the Side Reflector

Panels and Center Reflector Panels into the securing

arms of the Feed Receiver.

Arrows

Securing Arms

b. Insert the Feed Receiver into the Center Reflector Panel by

pressing the top and bottom snap hooks into the slots

of the Center Reflector Panel.

WARNING: Do not install the Feed Receiver into the

reflector assembly by pushing down onto a tabletop or

other flat surface as this can deform the panels. Hold the

reflector assembly by hand.

3. (Optional) For additional support, attach four M3x4

self‑tapping screws (not included) to the antenna

assembly.

4. Attach the Ball Joint Mount to the Feed Receiver by turning

the lock nut clockwise by hand. Do not tighten the nut.

5. Insert the Antenna Feed into the Feed Receiver until the feed

locks into place.

6. Press both sides of the Port Cover and detach it from the

Feed Receiver.

7. Connect an Ethernet cable to the Ethernet Port.

Inhaltsverzeichnis

Andere Ubiquiti Drahtloser Zugangspunkt Handbücher

Ubiquiti

Ubiquiti M2 GPS Rocket M Series Bedienungsanleitung

Ubiquiti

Ubiquiti Lite Beam AC LR LBE-5AC-LR Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AP AC Lite Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM365 Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation M2 Bedienungsanleitung

Ubiquiti

Ubiquiti BulletAC-IP67 Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-IW-HD Bedienungsanleitung

Ubiquiti

Ubiquiti Rocket 5AC PTP Bedienungsanleitung

Ubiquiti

Ubiquiti airCube ISP Bedienungsanleitung

Ubiquiti

Ubiquiti M900 Bedienungsanleitung

Ubiquiti

Ubiquiti RocketM Series Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP--AC--HD Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-AC-SHD Bedienungsanleitung

Ubiquiti

Ubiquiti NBE-M5-16 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-FlexHD Bedienungsanleitung

Ubiquiti

Ubiquiti PowerBeam PBE-5AC-400-ISO Bedienungsanleitung

Ubiquiti

Ubiquiti QCA9994 Anwendungshandbuch

Ubiquiti

Ubiquiti NanoStation loco Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStationM Series Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF 60 Bedienungsanleitung

Ubiquiti

Ubiquiti U-Installer Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AC AP Mesh Pro Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-IW-HD Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation AC Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung

Draytek

Draytek VIGORAP 902 Bedienungsanleitung

EnGenius

EnGenius EAP350 Bedienungsanleitung