Ubiquiti PBE-M5-300-US Bedienungsanleitung

Reﬂector Antenna Feed Rear Housing

Mounting Bracket Pole Clamp U-Bolt

Flange Nuts (Qty. 2) Washers (Qty. 2) PoE (24V, 0.5A) with Mounting

Bracket

Power Cord

Package Contents

PBE-M5-300 Quick Start Guide

Ethernet

Installation Requirements

10 mm wrench

Shielded Category 5 (or above) cabling should be used for all wired Ethernet

connections and should be grounded through the AC ground of the PoE.

We recommend that you protect your networks from harmful outdoor environments

and destructive ESD events with industrial-grade, shielded Ethernet cable from

Ubiquiti. For more details, visit ui.com/toughcable

Hardware Overview

This Ethernet port is used to connect the power and should be connected to the

PBE-M5-300 Quick Start Guide

Reset Button

Release Button

Signal LEDs

Ethernet LED

Power LED

LAN and DHCP server.

To reset to factory defaults, press and hold the Reset button for more than 10

seconds while the device is powered on. Alternatively, the device may be reset

remotely via a Reset button located on the bottom of the PoE adapter.

After you assemble the device, check the Release button; it should be fully

engaged in the Release Button Slot of the Rear Housing. This ensures that the

Antenna Feed is locked into place. If you need to remove the Antenna Feed, you

must depress the Release button ﬁrst.

In airOS®, you can modify the threshold values for the wireless signal strength

LEDs on the Advanced tab under Signal LED Thresholds. The default values are

shown below:

The Ethernet LED will light steady green when an active Ethernet connection is

made and ﬂash when there is activity.

The Power LED will light green when the device is connected to a power source.

Application Examples

The PowerBeam mounted outdoors with the Reﬂector installed provides directional

outdoor coverage (gain is reﬂector-dependent).

PBE-M5-300 Quick Start Guide

The PowerBeam mounted outdoors without the Reﬂector installed provides outdoor-

to-indoor coverage using the 3 dBi Antenna Feed only.

Installation

PBE-M5-300 Quick Start Guide

Connecting Power

WARNING: The switch port must comply with the power speciﬁcations

listed in this Quick Start Guide.

PBE-M5-300 Quick Start Guide

Optional

Accessing airOS

Verify connectivity in the airOS Conﬁguration Interface.

1. Make sure that your host system is connected via Ethernet to the device.

2. Conﬁgure the Ethernet adapter on your host system with a static IP address on

the 192.168.1.x subnet.

3. Launch your web browser and type https://192.168.1.20 in the address ﬁeld.

Press enter (PC) or return (Mac).

4. Enter ubnt in the Username and Password ﬁelds. Select your Country and

Language. You must agree to the Terms of Use to use the product. Click Login.

The airOS Conﬁguration Interface will appear, allowing you to customize your

settings as needed. For details, refer to the User Guide available at

ui.com/download/airmax

You can also manage your device using the Ubiquiti Internet Service Provider

Application. Setup using the UISP™ app requires the U-Installer, sold separately.

Installer Compliance Responsibility

Devices must be professionally installed and it is the professional installer’s

responsibility to make sure the device is operated within local country regulatory

requirements.

Antenna

PBE-M5-300 Quick Start Guide

Select your antenna from the list. If Calculate EIRP Limit is enabled, transmit output

power is automatically adjusted to comply with the regulations of the applicable

country. Note the requirements and antenna types listed below.

Cable Loss (When applicable)

Enter the cable loss in dB. Output power is adjusted to compensate for loss

between the radio and the antenna.

Certiﬁed Antenna Types

This radio transmitter FCC ID: SWX-PBE5M / IC: 6545A-PBE5M has been approved

by FCC / ISED Canada to operate with the antenna types listed below with the

maximum permissible gain for each antenna type indicated. Antenna types not

included in this list or having a gain greater than the maximum gain indicated for that

type, are strictly prohibited for use with this device.

Antenna Frequency Gain

Dish 5 GHz 22 dBi

Speciﬁcations

PBE-M5-300

Dimensions 325 x 325 x 256 mm

(12.8 x 12.8 x 10.1")

Weight (Mount Included) 1.203 kg

(2.65 lb)

Gain 22 dBi

Networking Interface (1) 10/100 Ethernet Port

Enclosure Outdoor UV Stabilized Plastic

Max. Power Consumption 6W

Max. TX Power 26 dBm

Power Supply 24V, 0.5A PoE Adapter (Included)

Power Method Passive PoE (Pairs 4, 5+; 7, 8 Return)

Wind Survivability 200 km/h

(125 mph)

Wind Loading 200.2 N @ 200 km/h

(45 lbf @ 125 mph)

Mounting Pole Mounting Kit Included

Salt Fog Test IEC 68-2-11 (ASTM B117),

Equivalent: MIL-STD-810 G Method 509.5

Vibration Test IEC 68-2-6

PBE-M5-300 Quick Start Guide

PBE-M5-300

Temperature Shock Test IEC 68-2-14

UV Test IEC 68-2-5 at 40° C (104° F)

Equivalent: ETS 300 019-1-4

Wind-Driven Rain Test ETS 300 019-1-4

Equivalent: MIL-STD-810 G Method 506.5

Operating Temperature -40 to 70° C (-40 to 158° F)

Operating Humidity 5 to 95% Noncondensing

Certiﬁcations CE, FCC, IC

Operating Frequency (MHz)

Worldwide 5150 - 5875

US/CA U-NII-1 5150 - 5250

U-NII-2A 5250 - 5350

U-NII-2C 5470 - 5725

U-NII-3 5725 - 5850

Safety Notices

1. Read, follow, and keep these instructions.

2. Heed all warnings.

3. Only use attachments/accessories speciﬁed by the manufacturer.

WARNING: Do not use this product in location that can be submerged by water.

WARNING: Avoid using this product during an electrical storm. There may be a remote

risk of electric shock from lightning.

Electrical Safety Information

1. Compliance is required with respect to voltage, frequency, and current requirements

indicated on the manufacturer’s label. Connection to a different power source than those

speciﬁed may result in improper operation, damage to the equipment or pose a ﬁre hazard if

the limitations are not followed.

2. There are no operator serviceable parts inside this equipment. Service should be provided

only by a qualiﬁed service technician.

3. This equipment is provided with a detachable power cord which has an integral safety

ground wire intended for connection to a grounded safety outlet.

a. Do not substitute the power cord with one that is not the provided approved type. Never

use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the

grounding wire.

b. The equipment requires the use of the ground wire as a part of the safety certiﬁcation,

modiﬁcation or misuse can provide a shock hazard that can result in serious injury or

death.

PBE-M5-300 Quick Start Guide

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Ubiquiti Drahtloser Zugangspunkt Handbücher

Ubiquiti

Ubiquiti BulletAC-IP67 Bedienungsanleitung

Ubiquiti

Ubiquiti M5 GPS Rocket M Series Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-11FX Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Wifi BaseStationXG Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber 24 HD Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-AC-LITE Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation5 Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Ubiquiti

Ubiquiti Bullet M5 HP Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Dream Machine Beacon Bedienungsanleitung

Ubiquiti

Ubiquiti PowerBeam PBE-5AC-400-ISO Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Enterprise AP Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-AC-PRO Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-11 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-nanoHD Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AP AC EDU Bedienungsanleitung

Ubiquiti

Ubiquiti Rocket2AC Prism Bedienungsanleitung

Ubiquiti

Ubiquiti GigaBeam GBE Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AP-AC PRO Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi USW-Flex-Mini Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi Stadium XG Bedienungsanleitung

Ubiquiti

Ubiquiti Edge Point EP-R8 Bedienungsanleitung

Ubiquiti

Ubiquiti M900 Bedienungsanleitung

Ubiquiti

Ubiquiti Rocket5AC R5AC-PTP Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung

Draytek

Draytek VIGORAP 902 Bedienungsanleitung

EnGenius

EnGenius EAP350 Bedienungsanleitung