Ubiquiti PowerBeam PBE-5AC-Omni Bedienungsanleitung

High-Performance

airMAX®ac Omni

Model: PBE-5AC-Omni

Introduction

Thank you for purchasing the Ubiquiti Networks®

PowerBeam®ac Omni. This Quick Start Guide is designed

to guide you through installation and also includes

warrantyterms.

Package Contents

Antenna

Feed with Omni

Rear

Housing

Mounting

Bracket

Pole Clamp

U-Bolt Bolts (Qty. 4) Flange Nuts (Qty. 2) Washers (Qty. 2)

High-Performance

airMAX®acOmni

Model:PBE-5AC-Omni

Gigabit PoE Adapter (24V, 0.5A)

with Mounting Bracket

Power

Cord

Quick Start

Guide

Installation Requirements

• Phillips screwdriver

• 10 mm wrench

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks

with industrial-grade shielded Ethernet cable from Ubiquiti

Networks. For more details, visit www.ubnt.com/toughcable

cable and earth grounding must be used as conditions of product warranty. TOUGHCable™

is designed for outdoor installations. It is the customer’s responsibility to follow local country

regulations, including operation within legal frequency channels, output power, and Dynamic

Frequency Selection (DFS) requirements.

Hardware Overview

Bottom View

Reset Button

Release Button

Ethernet Port

Reset Button To reset to factory defaults, press and hold the

Reset button for more than 10 seconds while the PowerBeam

is already poweredon. Alternatively, the PowerBeam may be

reset remotely via a Reset button located on the bottom of the

Gigabit PoE Adapter.

Release Button After you assemble the PowerBeam, check

the Release button; it should be fully engaged in the Release

Button Slot of the Rear Housing. This ensures that the Antenna

Feed is locked into place. If you need to remove the Antenna

Feed, you must depress the Release button first.

LEDs

Signal The default values (from left to right) are

shown below:

LED will light blue when the wireless signal

strength is equal to or above -65 dBm.

LED will light blue when the wireless signal

strength is equal to or above -73 dBm.

LED will light blue when the wireless signal

strength is equal to or above -80 dBm.

LED will light blue when the wireless signal

strength is equal to or above -94 dBm.

Ethernet The Ethernet LED will light steady blue

when an active Ethernet connection is made and

flash when there is activity.

Power The Power LED will light blue when the

device is connected to a power source.

Installation

1. Push in the sides of the Cable Door and detach it from the

Rear Housing.

2. Insert the Antenna Feed with Omni into the Rear Housing,

and push until it locks into place with a click.

3. Connect an Ethernet cable to the Ethernet Port of the

Antenna Feed, and re-attach the Cable Door to the Rear

Housing.

*640-12345-01*

640-12345-01

4. Attach the Rear Housing to the Mounting Bracket with

fourBolts.

5. Insert the U-Bolt into the Pole Clamp and Mounting

Bracket.Secure each end of the U-Bolt with a Washer and

a FlangeNut.

Note: The mounting assembly can accommodate a

Ø 32 - 56 mm pole.

6. Connect the other end of the Ethernet cable from the

PowerBeam to the Ethernet port labeled POE on the

Gigabit PoEAdapter.

7. Connect an Ethernet cable from your LAN or computer to

the Ethernet port labeled LAN on the adapter.

8. Connect the Power Cord to the power port on the adapter.

Connect the other end of the Power Cord to a power outlet.

Mounting the PoE Adapter (Optional)

1. Slide the PoE Mounting Bracket down to remove it from the

Gigabit PoE Adapter.

2. Place the PoE Mounting Bracket at the desired location and

mark the two holes. Pre-drill the holes if necessary, and

then secure the bracket using two fasteners (not included).

3. Align the slots of the Gigabit PoE Adapter with the tabs of

the PoE Mounting Bracket, and then slide the adapterdown.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Ubiquiti Drahtloser Zugangspunkt Handbücher

Ubiquiti

Ubiquiti U-LTE Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF 60 Bedienungsanleitung

Ubiquiti

Ubiquiti Power AP N 802.11n Bedienungsanleitung

Ubiquiti

Ubiquiti LiteAP ac LAP-120 Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-Outdoor-5 Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-AC-LR-5-EU Bedienungsanleitung

Ubiquiti

Ubiquiti Rocket 5AC PTP Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-11 Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-AC-IW Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi AP XG Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP-AC-PRO Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-AC-HD Bedienungsanleitung

Ubiquiti

Ubiquiti LiteBeam LBE5AC120-U Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-PRO Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation loco Bedienungsanleitung

Ubiquiti

Ubiquiti NanoBeam ac NBE-5AC-16 Bedienungsanleitung

Ubiquiti

Ubiquiti NBE--2AC--13 Bedienungsanleitung

Ubiquiti

Ubiquiti Uni-fi AP Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-IW-HD Bedienungsanleitung

Ubiquiti

Ubiquiti UniFi UAP Bedienungsanleitung

Ubiquiti

Ubiquiti airFiber AF-5XHD Bedienungsanleitung

Ubiquiti

Ubiquiti PowerBeam PBE-5AC400 Bedienungsanleitung

Ubiquiti

Ubiquiti UAP-PRO Bedienungsanleitung

Ubiquiti

Ubiquiti PowerBeam AC GENZ Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung

Draytek

Draytek VIGORAP 902 Bedienungsanleitung

EnGenius

EnGenius EAP350 Bedienungsanleitung