Whalen ODUS-JLDHCV Bedienungsanleitung

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.

PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Date 2020-07-17 Rev. 0001-A

Jasper L Desk

Model # ODUS-JLDHCV

ADULT ASSEMBLY REQUIRED

If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the

store where it was purchased. Please call our toll-free customer service number and have your

instructions and parts list ready to provide the model name, part name or factory number:

1-866-942-5362

Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday

Or visit our web site 24 hours a day, 7 days a week for product assistance at

www.whalenfurniture.com

Or e-mail your request to parts@whalenfurniture.com

LOT NUMBER:

DATE PURCHASE

MANUFACTURER: Whalen Furniture Manufacturing

CATALOG: Jasper L Desk

MODEL # ODUS-JLDHCV

SPECIAL NOTE

Please read the instruction sheets completely before assembly. Examine all packaging

material before discarding carton. Remove any remaining staples from the carton before

discarding. Remove all parts from carton and separate into groups as indicated on part

list. Please ensure all parts are included prior to assembly. Use of power tools to

complete assembly is not recommended.

MAXIMUM LOAD 100 lb. (45.4 kg)

M A X I M U M R E C O M M E N D E D W E I G H T L O A D S

THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM

WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM

WEIGHTS INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

MAXIMUM LOAD 50 lb. (22.7 kg)

IMPORTANT

Before you begin: Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-

abrasive surface. You will need the parts identified on page 4, 5 and 6 of this instruction manuals.

NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH DOWELS. EXCESS GLUE CAN BE WIPED OFF

WITH DAMP CLOTH.

Insert Dowel at least half way by tapping lightly with a rubber mallet, IF NECESSARY.

CAM LOCK SYSTEM OPERATION

HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS

1. Screw the Cam Bolt into the threaded inserts on the panel. Connect both panels together; making sure Cam

Bolt goes into the pre-drilled hole on the end of panel for Cam Lock.

2. Insert the Cam Lock into the pre-drilled large hole on the panel. Make sure the arrow on the face of Cam

Lock faces out and points towards Cam Bolt.

3. Take a Phillips screwdriver and rotate the Cam Lock clockwise to lock the Cam Bolt in place.

4. Plug the Cam Lock Cover into the cross slot of the Cam Lock to conceal the Cam.

You are now ready to assemble the KD unit.

FINAL

1 2 43

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

A- Desk Glass Top B- Return Glass Top C- Left Top Panel

(Qty. 1) (Qty. 1) (Qty. 1)

D- Left Bottom Panel E- Left Front Panel F- Left Back Panel

(Qty. 1) (Qty. 1) (Qty. 1)

G- Left Side Panel H- Right Top Panel I- Right Bottom Panel

(Qty. 1) (Qty. 1) (Qty. 1)

J- Right Front Panel K- Right Back Panel L- Right Side Panel

(Qty. 1) (Qty. 1) (Qty. 1)

M- Desk Fixed Shelf N- Desk Shelf Support O- Return Fixed Shelf

(Qty. 1) (Qty. 1) (Qty. 1)

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

P- Return Shelf Support Q- Large Leg R- Small Leg

(Qty. 1) (Qty. 1) (Qty. 1)

S- Desk Back Upper Stretcher T- Desk Front Upper Stretcher U- Return Back Upper Stretcher

(Qty. 1) (Qty. 1) (Qty. 1)

V- Return Front Upper Stretcher W- Back Bottom Stretcher

(Qty. 1) (Qty. 2)

(1) Cam Lock (2) Self-tapping Cam Bolt (3) M8 x 30 mm Wood Dowel

(Qty. 45+2 extra) (Qty. 41+2 extra) (Qty. 36

+1 extra)

(4) M8 x 40 mm Wood Dowel (5) Regular Cam Bolt (6) M6 x 15 mm Black Bolt

(Qty. 2+1 extra) (Qty. 4+1 extra) (Qty. 32+1 extra)

(7) M6 x 32 mm Black Bolt (8) Black Lock Washer (9) Black Flat Washer

(Qty. 4+1 extra) (Qty. 36+1 extra) (Qty. 36+1 extra)

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware are present

before beginning assembly.

(10) M6 x 35 mm Zinc Bolt (11) M6 x 50 mm Zinc Bolt (12) Zinc Lock Washer

(Qty. 11+1 extra) (Qty. 6+1 extra) (Qty. 11+1 extra)

(13) Zinc Flat Washer (14) M4 x 20 mm Screw (15) M5 x 50 mm Screw

(Qty. 17+1 extra) (Qty. 16+1 extra) (Qty. 4+1 extra)

(16) M5 x 12 mm Screw (17) Square Metal Bracket (18) L-shaped Metal Bracket

(Qty. 8+1 extra) (Qty. 4) (Qty. 2)

(19) Straight Metal Bracket (20) Left Metal Bracket (21) Right Metal Bracket

(Qty. 2) (Qty. 2) (Qty. 2)

(22) Cam Lock Cover (23) Cam Lock Cap Flat Tip Hex Wrench

(Qty. 8+1 extra) (Qty. 15+1 extra) (Qty. 1)

Glue (Qty. 2)

Tools required: Hex wrench (provided) and Phillips screwdriver (not provided).

Assembly Instructions

NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled,

go back and fully tighten all bolts. This will make the assembly easier.

1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a

carpeted floor or the empty carton to avoid any scratch.

2. Lay out the Left Side Frame components (C, E, F and G) with the holes facing up. Securely screw the

Self-tapping Cam Bolts (2) into the designated small holes, as shown in the illustration.

3. Glue one 30 mm Wood Dowel (3) into the bottom middle hole of the Left Side Panel (G) and attach it to

the Left Bottom Panel (D) with two 50 mm Screws (15). Tighten the screws with a Phillips screwdriver.

Make sure that you use a small amount of glue with both ends of all dowels.

Assembly Instructions

4. Glue four 30 mm Wood Dowels (3) to the Left Back Panel (F) and attach it to the previous assembly by

engaging four Cam Locks (1) (Refer to page 3 on Cam Lock system operation supplement).

5. Fasten the Left Front Panel (E) to the front end of Left Bottom Panel (D) using two 30 mm Wood

Dowels (3) and one Cam Lock (1).

6. Glue four 30 mm Wood Dowels (3) into the drilled holes on the top edge of the previous assembly.

7. Align the drilled holes on the Left Top Panel (C) with the inserted Wood Dowels (3) and press them

together. Fasten the Left Top Panel (C) in place by engaging four Cam Locks (1).

Assembly Instructions

8. Flip around the assembled side frame.

9. With the pilot holes as a guide, fasten two Square Metal Brackets (17) at the joints of Left Bottom Panel

(D) by using four 20 mm Screws (14) per bracket.

10. Secure the Left Top Panel (C) to the Left Back Panel (F) by engaging one Cam Lock (1).

11. Securely screw the Self-tapping Cam Bolts (2) into the designated small holes on the Right Side Frame

components (H, J, K and L), as shown in the illustration.

Assembly Instructions

12. Repeat the same procedure to form the Right Side Frame.

Inhaltsverzeichnis

Andere Whalen Inneneinrichtung Handbücher

Whalen

Whalen Bayside Furnishings CUS78BK-1 Bedienungsanleitung

Whalen

Whalen Bayside FURNISHINGS 369333 Bedienungsanleitung

Whalen

Whalen STCA48GD Bedienungsanleitung

Whalen

Whalen WF60BVJ Bedienungsanleitung

Whalen

Whalen AVFC54-12BT Bedienungsanleitung

Whalen

Whalen Aurora ARFP72CRS-6 Bedienungsanleitung

Whalen

Whalen Huntingdon EC-HUDF Bedienungsanleitung

Whalen

Whalen Laminate 44" High Console Bedienungsanleitung

Whalen

Whalen WSWC36W-E Bedienungsanleitung

Whalen

Whalen Bayside CSC3N1C-72-5 Bedienungsanleitung

Whalen

Whalen ATD60H-13AX Bedienungsanleitung

Whalen

Whalen VANITY WITH TOP WF30CVG Bedienungsanleitung

Whalen

Whalen WF36FVB Bedienungsanleitung

Whalen

Whalen Bayside Furnishings Braeden CSC7PD-7 Bedienungsanleitung

Whalen

Whalen Montcross 908722 Bedienungsanleitung

Whalen

Whalen WSF48SY26C Bedienungsanleitung

Whalen

Whalen AVC-22E Bedienungsanleitung

Whalen

Whalen Legeant Hutch Bedienungsanleitung

Whalen

Whalen Bayside CSC7PD-5 Bedienungsanleitung

Whalen

Whalen Bayside CSC7PD-12 Bedienungsanleitung

Whalen

Whalen Annual Event WMFP41BT-2 Bedienungsanleitung

Whalen

Whalen Z BEAM WSZB1848-5BW-2 Bedienungsanleitung

Whalen

Whalen Kendal Desk Bedienungsanleitung

Whalen

Whalen Mainstays MS18-03-1011-02 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung