White Rodgers 1F92W-51 Original Betriebsanleitung

Multi-stage/Heat Pump Electronic

Digital Thermostat

WHITE-RODGERS

Operator: Save this booklet for future use!

INSTALLATION &

OPERATION GUIDE 1F92W-51

About Your New Thermostat . . .

Your new White-Rodgers Digital Multi-stage/Heat Pump Thermostat uses the technology of a solid-state

microcomputer to provide precise time/temperature control. This thermostat offers you the flexibility to

design heating and cooling programs that fit your needs.

Please read this manual thoroughly before operating or programming your thermostat. If you have

questions, contact us at the address shown on the back cover of this manual.

In This Guide . . .

OPERATING YOUR THERMOSTAT ............... 22

PARTS OF THE THERMOSTAT

The Back Of the Thermostat Body

The Display

The Thermostat Buttons

OPERATING FEATURES

PROGRAMMING YOUR

THERMOSTAT........................................... 34

PLANNING FOR YOUR NEEDS

ENTERING YOUR PROGRAM

Set Current Time and Day

Enter Heating Program

Enter Cooling Program

CHECK YOUR PROGRAMMING

QUESTIONS AND ANSWERS........................ 44

YOUR NEW THERMOSTAT’S

FEATURES .................................................. 4

PRECAUTIONS ................................................. 5

THE THERMOSTAT’S SPECIFICATIONS ....... 6

INSTALLING YOUR THERMOSTAT ................ 7

NEW INSTALLATION

Select Thermostat Location

Route Wires to Location

REPLACEMENT INSTALLATION

Remove Old Thermostat

Attach Subbase to Wall

SYSTEM CONFIGURATON

Set Option Switches

CHECK THERMOSTAT OPERATION

Fan Operation

Heating System Operation

Cooling System Operation

LOCKOUT BYPASS OPTION

Compressor Long Term Cycle Protection

Compressor Short Term Cycle Protection

YOUR NEW THERMOSTAT’S FEATURES

• Five-day/two-day programming capability

• Simultaneous heat and cool program storage

• Four separate time and temperature settings

per 24-hour period

• Up to 2 stages of heat and up to 1 stage of cool

• Computed Energy Management Recovery

(EMR)

• Automatic changeover (operator selectable)

• Two hour temperature override

• Manual program override (HOLD temperature)

• “Advance Program” button

• Armchair programming capability

• LCD displays continuous setpoint, time, and

room temperature

• Adjustable cycle times

• 9 volt Energizer®alkaline battery backup

• Compressor long term cycle protection

• Compressor short cycle protection

• Blower delay in the cooling cycle

• Preprogrammed temperature control

• Visual prompting during operation

• Programmable blower control

• Temperature range 40°to 99°F

•°F/°C convertibility

• Electric Heat (installer-selectable)

PRECAUTIONS

Ifindoubtaboutwhetheryourwiringismillivolt,line,

or low voltage, have it inspected by a qualified

heating and air conditioning contractor, electrician,

orsomeonefamiliarwithbasicelectricityandwiring.

Do not exceed the specification ratings.

All wiring must conform to local and national electri-

cal codes and ordinances.

Thiscontrolisaprecisioninstrument,andshouldbe

handledcarefully.Roughhandlingordistortingcom-

ponents could cause the control to malfunction.

To prevent electrical shock and/or equip-

ment damage, disconnect electric power to

system, at main fuse or circuit breaker box,

until installation is complete.

CAUTION

Do not use on circuits exceeding specified

voltage. Highervoltagewilldamagecontrol

and could cause shock or fire hazard.

Do not short out terminals on gas valve or

primary control to test. Short or incorrect

wiring will burn out thermostat and could

cause personal injury and/or property

damage.

WARNING

THE THERMOSTAT’S SPECIFICATIONS

THIS CONTROL IS DESIGNED FOR USE WHERE BOTH SIDES OF THE TRANSFORMER ARE

PRESENT AT THE THERMOSTAT (both the hot and common sides of the 24 VAC end of the

transformer.)

ELECTRICAL DATA

Electrical Rating:

20 to 30 VAC 50/60 Hz.

0.01 to 1.5 Amps (Load per terminal)

2.5 Amps Maximum Total Load (Allterminals

combined)

Anticipation:

Heating 4 to 40

Cooling 4 to 40

Auxiliary 4 to 40

STAGING DATA

Up to 3 heating stages

Up to 1 cooling stage

THERMAL DATA

Setpoint Temperature Range:

40°F to 99°F (4°C to 37°C)

Operating Ambient Temperature Range:

32°F to 105°F

Operating Humidity Range:

0 to 90% RH (non-condensing)

Shipping Temperature Range:

-40°F to 150°F

ACCESSORIES

Thermostat Guard:

W. R. Part No. F29-0198 (clear)

or F29-0238 (opaque)

INSTALLING YOUR THERMOSTAT

NEW INSTALLATION

WE RECOMMEND THAT YOU PROGRAM THE

THERMOSTATWITHBATTERY INSTALLED BE-

FOREATTACHINGONSUBBASE. SEEOPERA-

TIONSECTIONFOR PROGRAMMINGINSTRUC-

TIONS.

SELECT THERMOSTAT LOCATION

Proper location insures that the thermostat will

provide a comfortable building temperature. Ob-

serve the following general rules when selecting

a location:

1. Locate thermostat about 5 ft. above the floor.

2. Installthermostatonapartitioningwall,notonan

outside wall.

3. Never expose thermostat to direct light from

lamps,sun,fireplacesoranytemperatureradiat-

ing equipment.

4. Avoid locations close to windows, adjoining out-

side walls, or doors that lead outside.

5. Avoid locations close to air registers or in the

direct path of air from them.

6. Makesuretherearenopipesorductworkinthat

part of the wall chosen for the thermostat loca-

tion.

7. Never locate thermostat in a room that normally

warmer or cooler than the rest of the building.

8. Avoid locations with poor air circulation, such as

behind doors or in alcoves.

ROUTE WIRES TO LOCATION

All wiring must conform with local and national

electrical codes and ordinances.

NOTE

1. Probe for obstructions in partition before drilling

1⁄2” hole in wall at selected location. Take up

quarter round and drill a small guide hole for

sighting(seefig.1).Frombasement,drill3⁄4”hole

in partition floor next to guide hole. In buildings

without basements, drill 1⁄2” hole through ceiling

and into partition from above (see fig. 1).

2. Through this hole drop a light chain, or 6” chain

attachedtoastrongcord.Snagcordinbasement

with hooked wire. In buildings without base-

ments, drop cord through hole in ceiling and

down partitioning; snag cord at the thermostat

location.

3. Attach thermostat wires to cord and pull wires

through hole in wall so that 6” of wire comes out

of the wall.

Approximately

5 feet from floor

⁄

” hole for

thermostat wire

Stout cord with 6”

chain attached

Baseboard

strip moulding

⁄

” guide hole

for sighting

Quarter round

removed

⁄

” hole in floor of partition

Hooked wire for snagging chain

Figure 1. Routing thermostat wires

REPLACEMENT INSTALLATION

REMOVE OLD THERMOSTAT

1. Shutoffelectricityatthemainfuseboxuntil

installation is complete. Verify power is off

with a voltmeter.

2. Remove the front cover of the old thermo-

stat. With wires still attached, remove

wall plate from the wall.

3. If the old thermostat has a wall mounting

plate, remove the thermostat and the wall

mounting plate as an assembly.

4. Usethe CrossReference Guideto findthe

thermostat type you are replacing.

5. Identifyeachwireattachedtotheoldthermo-

stat using the labels enclosed with the new

thermostat (see Table 1). Record the identifi-

cationofthewireonthecorrespondingblank

in Table 2.

TABLE 1. WIRE IDENTIFICATION LABELS

6. Disconnectthewires fromoldthermostatone at

a time. Pull at least 6 inches of wire out of the

wall. DO NOT LET WIRES FALL BACK INTO

THE WALL.

7. Installnewthermostatusingthefollowingproce-

dures.

TABLE 2. TERMINAL REFERENCE

LABEL

NUMBER

NEW THERMOSTAT

TERMINAL

DESIGNATION FUNCTION

OLD THERMOSTAT

TERMINAL

DESIGNATION

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8)

(9)

(10)

(11)

(12)

(13)

Fan Output

Transformer 24 VAC Common

(this terminal not used)

Transformer 24 VAC Hot

Changeover Output (Cooling)

Changeover Output (Heating)

Emergency Heat Relay (cycles on

1st stage in Emergency Mode)

Emergency Heat Relay (continually

energized in Emergency Mode)

Stage 1 Cool

(this terminal not used)

Stage 1 Heat (Compressor)

Stage 2 Heat (Auxiliary)

(this terminal not used)

Inhaltsverzeichnis

Andere White Rodgers Thermostat Handbücher

White Rodgers

White Rodgers 1F82-261 Bedienungsanleitung

White Rodgers

White Rodgers 1F91-71 Bedienungsanleitung

White Rodgers

White Rodgers 37-1406-1 Bedienungsanleitung

White Rodgers

White Rodgers 1F95-397 Bedienungsanleitung

White Rodgers

White Rodgers UP310 Bedienungsanleitung

White Rodgers

White Rodgers 1C26 Bedienungsanleitung

White Rodgers

White Rodgers 1F80-261 Bedienungsanleitung

White Rodgers

White Rodgers 1F94-71 Bedienungsanleitung

White Rodgers

White Rodgers 1F83-0471 Bedienungsanleitung

White Rodgers

White Rodgers 1F82-51 Bedienungsanleitung

White Rodgers

White Rodgers EMERSON BLUE 1F98EZ-1421 Bedienungsanleitung

White Rodgers

White Rodgers 1A66W Bedienungsanleitung

White Rodgers

White Rodgers 1F59-11 Montageanleitung

White Rodgers

White Rodgers 1F57-306 Bedienungsanleitung

White Rodgers

White Rodgers 1F96 Series Bedienungsanleitung

White Rodgers

White Rodgers 1F89-211 Bedienungsanleitung

White Rodgers

White Rodgers 1F85ST-0422 Bedienungsanleitung

White Rodgers

White Rodgers F95-391 Bedienungsanleitung

White Rodgers

White Rodgers Comfort-Set 90 Bedienungsanleitung

White Rodgers

White Rodgers 1F97W-51 Bedienungsanleitung

White Rodgers

White Rodgers TYPE 152 Bedienungsanleitung

White Rodgers

White Rodgers UNP300 Verdrahtungsschema

White Rodgers

White Rodgers P200 Verdrahtungsschema

White Rodgers

White Rodgers 1F92W-71 Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Honeywell

Honeywell T6811 Bedienungsanleitung