AFe Power 46-20299-B Bedienungsanleitung

advanced FLOW engineering

Instruction Manual P/N: 46-20299-B

Make: Ford Model: F-150 Raptor Year: 2017-2020 Engine: V6-3.5L (tt) EcoBoost

Label Qty. Description Part Number

A 1 Tube, Cold Side 05-60771B

B 1 Coupling, Silicone Hump: 3"ID x 2-1/4" 05-01245

C 1 Coupling, Silicone Elbow: 3-1/2"ID x 45 05-60556

D 1 Adaptor 05-60373

E 1 Plug, Hex Head Socket: 1/8" NPT 03-50029

F 1 O-Ring 05-60626

G 2 Clamp, #052 03-50008

H 2 Clamp, #048 03-50007

I 1 Screws, Socket Head Cap: M6 03-50241

J 1 Washer, M6 03-50177

Tools Needed: 6mm & 8mm Allen wrenches, 7mm & 8 mm sockets or nut drivers, T30 Torx socket

or driver, 13mm & 15mm sockets, ratchet, grease and thread sealant.

Note: Legal in California for use on race vehicles only. The use of this device on vehicles used on

public streets or highways is strictly prohibited in California and others states that have adopted

California emission regulations.

• Please read the entire instruction manual before proceeding.

• Ensure all components listed are present.

• If you are missing any of the components, call customer support at 951-493-7185.

• Ensure you have all necessary tools before proceeding.

• Do not attempt to work on your vehicle when the engine is hot.

• Disconnect the negative battery terminal before proceeding.

• Retain factory parts for future use.

Page 2

aFepower.com

Page 3

H H G G

D I

E J

Refer to Figure A for Steps 1-6

Step 1: Park vehicle on level ground and engage parking brake.

Step 2: Remove intake Y-pipe by loosening the three clamps using a 7mm socket or nut driver and

disconnecting the sensor. (Figure A).

Step 3: Disconnect the vent tube by squeezing the retaining clip and pushing it through to release it,

then gently pull it off the intercooler tube. (Figure B).

Step 4: Disconnect the wire harness from the sensor and the factory intercooler tube. (Figure B).

Step 5: Remove the sensor for reuse in your new aFe intercooler tube, using a Torx socket. (Figure B).

Step 6: Loosen the clamp at the throttle body connection, using a 7mm socket or nut driver and

separate the coupling from the throttle body. (Figure B).

Page 4

REMOVAL

Figure A

Refer to Figure B for Steps 7-12

Step 7: Under the vehicle you will need to remove the six bolts securing the skid plate to the truck.

Step 8: Once the skid plate is removed disconnect the pressure relief valve tube on the driver side of the

vehicle right above the intercooler tube connection by twisting it a ¼ turn counter-clock wise,

then gently pulling it back to separate it from the canister and twisting the entire tube out of the

way.

Step 9: On the driver side of the vehicle loosen the clamp using a 7mm socket or nut driver that is

securing the cold side intercooler tube to the 3-1/2" rubber hose and disconnect the hard plastic

tube from the rubber coupling.

Step 10: Once the rubber hose is disconnected remove the tube from the top of the vehicle.

Step 11: Use a small screwdriver to remove the wire retaining clip at the lower intercooler tube

connection on the driver side of the vehicle.

Step 12: Pull the lower tube connection apart and remove the lower half of the intercooler tube from the

vehicle.

aFepower.com

Page 5

REMOVAL

Figure B

Refer to Figure C for Steps 13-14

Step 13: Place the small silicone coupling over the small end of the aFe intercooler tube with one of the

smaller supplied clamps and install the 1/8” NPT plug into the ﬁtting.

NOTE: Be sure to use thread sealant on the threads prior to instillation.

Step 14: Install the sensor from Step 5 into the aFe intercooler tube with the small screw provided, using

an allen wrench.

Page 6

INSTALL

Figure C

Refer to Figure D for Steps 15-17

Step 15: Install the factory retaining clip into the groove on the outside of the supplied aluminum adaptor

(Figure A).

Step 16: Install the supplied O-ring into the groove on the inside the aluminum adaptor (Figure A).

NOTE: Lube the O-rings for the adaptor and the sensor from Step 5 with a small amount

of grease, prior to installation, to prevent the O-ring from tearing.

Step 17: Place the large 45° silicone coupling the intercooler adaptor along with the large clamps

(Figure B).

Page 7

INSTALL

Figure D

aFepower.com

Refer to Figure E for Steps 18-20

Step 18: Install the intercooler tube from the top of the vehicle.

Step 19: Install the aluminum adaptor onto the intercooler and then onto the intercooler tube, be sure

that the clip snaps all the way into the groove on the intercooler.

Step 20: Up top, install the throttle body coupling onto the throttle body with the last clamp.

Page 8

INSTALL

Figure E

Refer to Figure F for Steps 21-23

Page 9

Step 21: Reinstall the relief valve tube from Step 8.

Step 22: Ensure intercooler tube is not resting on any plastic or metal surfaces then tighten all clamps.

Step 23: Reinstall factory skid plate.

INSTALL

Figure F

aFepower.com

Refer to Figure G for Steps 24-27

Page 10

Step 24: Up top, reconnect the vent tube onto the aFe intercooler tube and lock it with the retaining clip.

Step 25: Reconnect the sensor from Step 4.

Step 26: Reinstall intake y-pipe and the tighten clamps.

Step 27: Reconnect the sensor in the intake tube. Install is now complete.

Thank you for choosing aFe Power. Enjoy!

Figure G

INSTALL

Inhaltsverzeichnis

Andere aFe Power Autozubehör Handbücher

aFe Power

aFe Power Magnum FORCE Bedienungsanleitung

aFe Power

aFe Power 77-46309 Bedienungsanleitung

aFe Power

aFe Power 52-10002D Bedienungsanleitung

aFe Power

aFe Power SCORCHER BLUE 77-83043 Bedienungsanleitung

aFe Power

aFe Power 440-401006-N Bedienungsanleitung

aFe Power

aFe Power 46-70022 Bedienungsanleitung

aFe Power

aFe Power SCORCHER GT 77-47004 Bedienungsanleitung

aFe Power

aFe Power 46-70270 Bedienungsanleitung

aFe Power

aFe Power 51-74201 Bedienungsanleitung

aFe Power

aFe Power 54-82039 Bedienungsanleitung

aFe Power

aFe Power takeda 56-70005D Bedienungsanleitung

aFe Power

aFe Power 54-10468 Bedienungsanleitung

aFe Power

aFe Power MOMENTUM GT 50-70034S Bedienungsanleitung

aFe Power

aFe Power 77-42008 Bedienungsanleitung

aFe Power

aFe Power 46-70162 Bedienungsanleitung

aFe Power

aFe Power Momentum GT Bedienungsanleitung

aFe Power

aFe Power Scorcher Bedienungsanleitung

aFe Power

aFe Power F1-03003 Bedienungsanleitung

aFe Power

aFe Power 52-10001D Bedienungsanleitung

aFe Power

aFe Power Magnum FORCE 54-13035D Bedienungsanleitung

aFe Power

aFe Power 77-43023 Bedienungsanleitung

aFe Power

aFe Power 54-12208 Bedienungsanleitung

aFe Power

aFe Power advanced FLO engineering Bedienungsanleitung

aFe Power

aFe Power 46-71180A Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung

aFe Power 46-20299-B Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken