Bradley S19-220DCR Bedienungsanleitung

P.O. Box 309, Menomonee Falls, WI USA 53052-0309

PHONE 1-800-BRADLEY FAX (262) 251-5817

http://www.bradleycorp.com

Installation

215-158DCR Rev. H; EN 06-532E

Page 1 of 4 4/17/07

S19-220DCR

Wall-Mounted Eyewash with

Dust Cover

Table of Contents

Pre-Installation Information . . . . . . . . . . . . . . . .2

Installation Instructions . . . . . . . . . . . . . . . . . . .3

Assembly of Components . . . . . . . . . . . . . . . . .4

Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

S19-220DCR Installation

4/17/07 Bradley Corporation • 215-158DCR Rev. H; EN 06-532E

WARNING

Read this installation manual completely to ensure proper installation, then file it

with the owner or maintenance department. Compliance and conformity to drain

requirements and other local codes and ordinances is the responsibility of the

installer.

Separate parts from packaging and make sure all parts are accounted for before

discarding any packaging material. If any parts are missing, do not begin

installation until you obtain the missing parts.

Flush the water supply lines before beginning installation and after installation is

complete. Test the unit for leaks and adequate water flow. Main water supply to

the eyewash should be “ON” at all times. Provisions shall be made to prevent

unauthorized shutoff.

The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a

minimum 30 PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per

ANSI Z358.1.

The inspection and testing results of this equipment should be recorded weekly

to verify proper operation. This equipment should be inspected annually to

ensure compliance with ANSI Z358.1.

Workers who may come in contact with potentially hazardous materials should be

trained regarding the placement and proper operation of emergency equipment

per ANSI Z358.1.

For questions regarding the operation or installation of this product, visit

www.bradleycorp.com or call 1-800-BRADLEY.

Product warranties may also be found under ”Product Information” on our web

site at www.bradleycorp.com.

Installation

THIS

SIDE

Packing List

P.O.Box309, MenomoneeFalls, WI 53051

TESTTHISUNITEACHWEEK

Test-operatevalve(s) each week and sign below.

Reportany malfunctions immediately.

Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt

durchUnterschrift. Jegliche Störung sofort melden.

Date

Datum

Date

Signed

Unterschrift

Signe

Date

Date Signed

Signed

DIESESGERÄT1STWÖCHENTLICHZUPRÜFEN.

ESSAIHEBDOMADAIRE

Testle fonctionnement des valves chaque semaine et

signeen bas. S'il y à quelque chose qui ne va pas fait

unrapport immédiatement.

P.O.BOX309, MENOMONEE FALLS,WI 53052-0309 USA

TEL:1-800-BRADLEY FAX: (262-251-5817)

http://www.bradleycorp.com

114-051

Installation S19-220DCR

Bradley Corporation • 215-158DCR Rev. H; EN 06-532E 4/17/07

Installation

NOTE: Flush the water supply line before

beginning installation.

Supplies Required:

• (3) 3/8" bolts and wall anchors for

mounting wall bracket

• Pipe sealant

• Piping to 1/2" NPT water supply inlet on

unit

• Piping to 1-1/4" NPT drain outlet for

eyewash

• Sign-mounting hardware

Step 1: Install inlet drain fittings

NOTE: The top of the eyewash heads should

be 33"–45" (838mm–1143mm) from the floor.

1. Position the inlet drain fitting over the 1-

1/4" drain outlet pipe from wall.

2. Using the inlet drain fitting as a template,

mark the bolt hole locations on the wall

OR install three suitable fasteners

(supplied by installer) for 3/8" bolts in

the wall at the marked hole locations (see

Figure 1).

3. Bolt the inlet drain fitting to the wall or

wall fasteners using 3/8" bolts (supplied

by installer).

Step 2: Assemble eyewash

components

1. Assemble eyewash components as shown

in Figure 2 on page 4.

• Apply pipe sealant (supplied by

installer) to all male-threaded pipe

joints.

• Use a strap wrench around pipes when

tightening to prevent marring.

Step 3: Connect water supply

1. Connect the water supply piping

(supplied by installer) to the 1/2" NPT

inlet on the eyewash.

2. Connect the tailpiece to the 1-1/4" NPT

drain outlet on the eyewash.

3. Mount the safety sign to the wall using sign-mounting hardware (supplied by installer).

4. Open the water supply lines. Test for leaks and adequate water flow.

Ø 10-3/4" (273mm)

7-1/4"

(184mm)

17-1/4"

(438mm)

8-3/4"

(222mm)

5-1/4"

133mm)

7-1/2"

(191mm)

(13-5/8")

346mm

(102mm)

Wall

21-1/2" (546mm)

8-1/4"

(210mm)

4-5/8"

(119mm)

30-1/2"

(775mm)

Suggested

Height

To Floor

36"

(914mm)

Suggested

Height

To Floor

2-1/4"

(57mm)

Ø 5/16"

(8mm)

Figure 1

Assembly of Components and Parts List

S19-220DCR Installation

4/17/07 Bradley Corporation • 215-158DCR Rev. H; EN 06-532E

1.7

1.5 Flow Control

ThisEnd

1.4

1.3

1.2

1.1

4.1

1/2" IPS

Supply Inlet

1-1/4" IPS

Drain Outlet

1.13

1.8

1.10

1.12

1.9

1.11

P.O. B ox 309, Menomonee Falls, WI 53051

TESTTHISUNIT EACH WEEK

Test-operate valve(s) each week and sign below.

Report any malfunctionsimmediately.

Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt

durch Unterschrift.Jegliche Störungsofort melden.

Date

Datum

Date

Signed

Unterschrift

Signe

Date

Date Signed

Signed

DIESESGERÄT1ST WÖCHENTLICH ZU PRÜFEN.

ESSAI HEBDOMADAIRE

Test le fonctionnement desvalveschaque semaine et

signe en bas. S'il y à quelque chose qui ne va pasfait

un rapport immédiatement.

P.O. B OX 309, MENOMONEE FALLS,WI 53052-0309 USA

TEL:1-800-BRADLEY FAX:(262-251-5817)

http://www.bradleycorp.com

114-051

4.3

4.11

4.2

HANDLE NOTE:

Close the cover and

put the pin through

the clip to keep closed.

1.6

4.4

Figure 2

1 S90-301 1 Dust Cover w/Spray Ring

1.1 111-061 1 Inlet-Drain Fitting

1.2 124-028 1 Gasket

1.3 S90-009 1 Dust Cover Assembly

1.4 173-009 1 Cup Strainer

1.5 S21-073 1 Supply Stem

1.6 113-1159 1 Drain Spacer

1.7 S05-100 1 Eyewash Yoke Assembly

1.8 269-651 1 Swivel Stem

1.9 124-055 2 Quad Ring

1.10 139-087 1 Spray Ring Assembly

1.11 110-199 1 Acorn Nut

1.12 269-447 1 Bumper

1.13 161-025 1 Hex Nut

2 113-006LQ 1 Pipe 1/2" NPT x 3-1/2" Long

3 169-025 1 Elbow

4 S30-072 1 1/2" Valve/Handle Prepack

4.1 S27-282 1 1/2" Ball Valve with Nut

4.11 110-215 1 Nut only

4.2 S08-056 1 Handle Assembly

4.3 142-002DA 1 Lockwasher

4.4 143-372R 1 Adapter

5 269-167 1 Tailpiece

6 114-051 1 Safety Sign

7 204-421 1 Emergency Tag

Item Part No. Qty Description Item Part No. Qty Description

NOTE: Items 1.1–1.13 come preassembled as Item 1.

Prepack S05-127 includes Items 1.8, 1.9, 1.10, 1.11

Prepack S30-087 includes Items 4.11, 4.2, 4.3, 4.4

Andere Bradley Sanitärprodukte Handbücher

Bradley

Bradley S19-230H Bedienungsanleitung

Bradley

Bradley S19294 Series Bedienungsanleitung

Bradley

Bradley S19-222 Bedienungsanleitung

Bradley

Bradley Express SS Series Bedienungsanleitung

Bradley

Bradley Verge LVLD Series Bedienungsanleitung

Bradley

Bradley CRS Series Bedienungsanleitung

Bradley

Bradley E19-310DC Bedienungsanleitung

Bradley

Bradley WS-1X Bedienungsanleitung

Bradley

Bradley S19-125SBF Bedienungsanleitung

Bradley

Bradley Navigator S19-2010 Series Bedienungsanleitung

Bradley

Bradley S19-220FWPT Bedienungsanleitung

Bradley

Bradley Terreon Classic WF2500 Series Bedienungsanleitung

Bradley

Bradley Terreon Classic WF2500 Series Bedienungsanleitung

Bradley

Bradley Express MG Series Bedienungsanleitung

Bradley

Bradley S19-120FMBF Bedienungsanleitung

Bradley

Bradley FL-3H Bedienungsanleitung

Bradley

Bradley Terreon Classic WF2500 Series Bedienungsanleitung

Bradley

Bradley S19-120 Bedienungsanleitung

Bradley

Bradley Terrazzo WF2600 Series Bedienungsanleitung

Bradley

Bradley GLX-3 Bedienungsanleitung

Bradley

Bradley MG-2/BIR3 Bedienungsanleitung

Bradley

Bradley S19-210SS Bedienungsanleitung

Bradley

Bradley S19-304GA Bedienungsanleitung

Bradley

Bradley Terreon WF3204 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema