Cisco PC4000 Bedienungsanleitung
Cisco Secure Endpoint PC4000 Hardware Installation Guide
First Published: 2023-08-28
Last Modified: 2023-11-03
Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 527-0883
THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS,
INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND,
EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH
THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY,
CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.
The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB's public domain version of
the UNIX operating system. All rights reserved. Copyright ©1981, Regents of the University of California.
NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS" WITH ALL FAULTS.
CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.
IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT
LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS
HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network
topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional
and coincidental.
All printed copies and duplicate soft copies of this document are considered uncontrolled. See the current online version for the latest version.
Cisco has more than 200 offices worldwide. Addresses and phone numbers are listed on the Cisco website at www.cisco.com/go/offices.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL:
https://www.cisco.com/c/en/us/about/legal/trademarks.html. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a
partnership relationship between Cisco and any other company. (1721R)
©2023 Cisco Systems, Inc. All rights reserved.
CONTENTS
Overview 1
CHAPTER 1
Features 1
Package Contents 3
Serial Number Location 3
Front Panel 5
Front Panel LEDs 6
Rear Panel 8
Rear Panel LEDs 9
Power Supply 10
Hardware Specifications 11
Product ID Numbers 12
Power Cord Specifications 12
Installation Preparation 21
CHAPTER 2
Installation Warnings 21
Safety Recommendations 23
Maintain Safety with Electricity 24
Prevent ESD Damage 25
Site Environment 25
Site Considerations 25
Power Supply Considerations 25
Rack Configuration Considerations 26
Mount the Chassis 27
CHAPTER 3
Unpack and Inspect the Chassis 27
Rack-Mount the Chassis 27
Cisco Secure Endpoint PC4000 Hardware Installation Guide
iii
CHAPTER 1
Overview
•Features, on page 1
•Package Contents, on page 3
•Serial Number Location, on page 3
•Front Panel, on page 5
•Front Panel LEDs, on page 6
•Rear Panel, on page 8
•Rear Panel LEDs, on page 9
•Power Supply, on page 10
•Hardware Specifications, on page 11
•Product ID Numbers, on page 12
•Power Cord Specifications, on page 12
Features
The Cisco Secure Endpoint PC4000 appliance supports Secure Endpoint Private Cloud version 4.0 and later.
The following table lists the features of the Cisco Secure Endpoint PC4000. See Product ID Numbers, on
page 12 for a list of the spare product IDs (PIDs) associated with the Secure Endpoint PC4000. You can
remove and replace drives and power supplies. For all other internal component failures, you must send your
chassis for return merchandise authorization (RMA). Use the Cisco Returns Portal for RMA:
https://www.cisco.com/c/en/us/support/returns/returns-portal.html.
Table 1: Secure Endpoint PC4000
DescriptionFeature
2 RUForm factor
Yes
Standard 19-in. (48.3 cm) 4-post EIA rack
Rack mount
Front to rear
Cold aisle to hot aisle
Airflow
Displays the serial number.Pullout asset card
Cisco Secure Endpoint PC4000 Hardware Installation Guide
1
DescriptionFeature
Yes
Two threaded holes for dual-hole grounding lug.
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
Grounding hole
YesLocator beacon
YesPower switch
Two Intel Xeon Gold 6330 processorsProcessor
2 TB RAMMemory
Thirty-two 64-GB DDR4-3200-MHz RDIMMsRDIMMs
Two built-in dual 1/10-GB portsManagement ports
2
Version 3.0 Type A
USB ports
One 3-row 15-pin DE-15 connector
Enabled by default.
VGA port
4 fixed SFP+ ports
Supported SFP cables SFP-10G-SR
SFP ports
One 1-GB RJ45 serial port running RS-232 (RS-232D
TIA-561)
Serial console port
Two 1050-W AC power supplies (hot-swappable and
redundant as 1+1)
System power
3196 BTU/hrPower consumption
6 fans for front-to-rear coolingFans
Fourteen UCS-SD960G63X-EP (960 GB SSD RAID
6)
Ten UCS-SD76T61X-EV (7.6 TB SSD RAID 6)
Two UCS-SD38T61X-EV (3.8 TB SSD RAID 1)
Hot-swappable
Storage
1RAID controller
Cisco Secure Endpoint PC4000 Hardware Installation Guide
2
Overview
Features
Package Contents
The following figure shows the package contents for the Secure Endpoint PC4000. Note that the contents are
subject to change and your exact contents might contain additional or fewer items.
Figure 1: Package Contents
RJ-45 to RJ-45 Cat 5 Ethernet cable,
yellow six feet long (Cisco part number
72-1482-XX)
2Chassis1
Cisco Secure Endpoint Private Cloud
Virtual Appliance PC4000
This document has a URL and QR code
that point to the Digital Documentation
Portal. The portal contains links to the
Product Information page, the Hardware
Installation Guide, the Regulatory and
Safety Information Guide, and the Quick
start Guide.
4Cisco rail kit (Cisco part number
800-43376-02)
3
—SFP+ cables (Optional; in package if
ordered.)
5
Serial Number Location
The serial number (SN) for the Secure Endpoint PC4000 is printed on the pullout asset card located on the
front panel as shown in the following figure.
Cisco Secure Endpoint PC4000 Hardware Installation Guide
3
Overview
Package Contents
Figure 2: Serial Number on Pullout Asset Card
The serial number is also on the label on the cover of the chassis as shown in the following figure.
The cover latch on the top of the chassis cover is not supported. There are no internal field-replaceable parts
in the Secure Endpoint PC4000.
Caution
Figure 3: Serial Number Location on Cover
Serial number label1
Cisco Secure Endpoint PC4000 Hardware Installation Guide
4
Overview
Serial Number Location
Front Panel
The following figure shows the front panel features and disk-drive configuration for the Secure Endpoint
PC4000. See Front Panel LEDs, on page 6 for a description of the LEDs.
Figure 4: Secure Endpoint PC4000 Front Panel
Drive bays 15-24 populated with 7.6TB
SSDs for the backup volume.
2Drive bays 1-14 are populated with SSDs
for the /data volume.
1
Unit identification button/LED4Power button/power status LED3
Fan status LED6System status LED5
Power supply status LED8Temperature status LED7
Pullout asset card10Network link activity LED9
——KVM connector
Used with KVM cable that provides one
DB-15 VGA, one DB-9 serial, and two
USB connectors.
11
Cisco Secure Endpoint PC4000 Hardware Installation Guide
5
Overview
Front Panel
Front Panel LEDs
The following figure shows the front panel LEDs and describes their states.
Figure 5: Front Panel LEDs and Their States
SAS/SATA drive activity LED
• Off—There is no drive in the drive
tray (no access, no fault).
• Green—The drive is ready.
•Green, flashing—The drive is reading
or writing data.
2SAS/SATA drive fault
•Off—The drive is operating properly.
• Amber—Drive fault detected.
• Amber, flashing—The drive is
rebuilding.
• Amber, flashing with one-second
interval—Drive locate function
activated in the software.
1
Unit identification
• Off—The unit identification function
is not in use.
• Blue, flashing—The unit
identification function is activated.
4Power button/LED
• Off—There is no AC power to the
appliance.
• Amber—The appliance is in standby
mode.
• Green—The appliance is in main
power mode. Power is supplied to all
appliance components.
3
Cisco Secure Endpoint PC4000 Hardware Installation Guide
6
Overview
Front Panel LEDs
Inhaltsverzeichnis
Andere Cisco Netzwerk-Hardware Handbücher
Cisco
Cisco CMX 3375 Bedienungsanleitung
Cisco
Cisco NCS 1002 Bedienungsanleitung
Cisco
Cisco IronPort C670 Bedienungsanleitung
Cisco
Cisco 2650XM Bedienungsanleitung
Cisco
Cisco ONS 15310-MA Bedienungsanleitung
Cisco
Cisco CWDM-OADM 1 Series Kurzanleitung
Cisco
Cisco UCS-FI-6332-16UP Bedienungsanleitung
Cisco
Cisco SA-VAM - VPN Acceleration Module Bedienerhandbuch
Cisco
Cisco Nexus 93600CD-GX Handbuch
Cisco
Cisco ONS 15454 SDH E1-75 Bedienungsanleitung
Cisco
Cisco ASR 5000 Series Bedienungsanleitung
Cisco
Cisco ONS 15216-MD-40-ODD Bedienungsanleitung
Cisco
Cisco Firepower 9300 Wartungs- und Serviceanleitung
Cisco
Cisco ONS 15454 DWDM Bedienungsanleitung
Cisco
Cisco ONS 15310-CL Bedienungsanleitung
Cisco
Cisco 2431 - IAD Router Bedienungsanleitung
Cisco
Cisco MultiRIP Ethernet Card Bedienungsanleitung
Cisco
Cisco DOC 785983 Bedienungsanleitung
Cisco
Cisco Fourth-Generation Versatile Interface Processor... Bedienerhandbuch
Cisco
Cisco Cisco 5400 ENCS Handbuch
Beliebte Netzwerk-Hardware Handbücher anderer Marken
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung
Yudor
Yudor YDS-16 Bedienungsanleitung
D-Link
D-Link ShareCenter DNS-320L Bedienungsanleitung
Samsung
Samsung ES1642dc Gebrauchsanweisung
Honeywell Home
Honeywell Home LTEM-PV Montageanleitung
