Clarke ATC12VB Bedienungsanleitung

OPERATION & MAINTENANCE

INSTRUCTIONS

LS0618 ISS 2

ORIGINAL INSTRUCTIONS

TRICKLE CHARGER

MODEL NO: ATC12VB

PART NO: 6266012

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for selecting this Clarke Trickle Charger.

Read this manual before use. The warnings and cautions in this manual help

you use the trickle charger safely. Please store these instructions for future

reference.

RECOMMENDED USE

This charger must not be used for the charging of non-rechargeable batteries.

This charger is suitable for charging 12V lead acid, sealed lead-acid, GEL,

maintenance-free and AGM batteries of capacities up to 100Ah (Ampere

hours).

Check with your battery manufacturer if you are unsure about the suitability of

this charger for use with your battrey.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt which will be

required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product can

be returned to us without prior permission.

This guarantee does not effect your statutory rights.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SAFETY INSTRUCTIONS

• This charger must not be used by children under 8 years old or people

with reduced physical, sensory or mental capabilities or lack of

experience and knowledge.

• Children must be supervised when using this charger.

• The casing should not be opened. There are no user-serviceable parts.

• Store this product in a dry place to prevent moisture damage.

• Do not use this product if it is damaged.

• Only use this product for the purposes described in this instruction

booklet. Damage resulting from incorrect use will not be covered by

your warranty.

• The use of safety goggles and gloves when working with lead acid

batteries is strongly advised.

• Avoid contact with the electrolyte as this is acidic and is likely to cause

burns to the skin or clothes.

• Prevent short circuits which can result in a dangerous electrical

discharge that could result in personal injury or damage to equipment

and property.

OUTPUT CONNECTIONS

The output cable from the charger terminates in a socket. Connect one of the

following leads into this socket.

Crocodile clips - for connecting direct to the

battery terminals, positive (Red) and negative

(Black).

For semi permanent connection to the battery

via eyelets. For motorcycles, Boats, ATVs, Quad

bikes and Scooter.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

LED STATUS INDICATOR

OPERATION

1. PREPARATION OF THE BATTERY (FOR NON-SEALED LEAD-ACID BATTERIES ONLY)

If possible, inspect the liquid levels in each cell and top up if required, using

deionized or distilled water.

The cell caps must be replaced but not tightened until charging is complete.

2. BATTERY CONNECTIONS

The mains supply should always be disconnected before making or breaking

battery connections.

Connect the clips to the battery in the following order:

1. Connect the positive charging lead (RED) to the positive post of the

battery

FOR BATTERIES INSTALLED IN THE VEHICLE:

2. Connect the negative charging lead (BLACK) to the vehicle chassis, well

away from the battery, fuel line, and hot or moving parts.

FOR BATTERIES THAT HAVE BEEN REMOVED FROM THE VEHICLE:

3. Connect the negative charging lead (BLACK) to the negative post of the

battery.

4. After connecting the clips, rotate them slightly to remove dirt or oxidation,

thus ensuring a good contact.

NOT LIT The battery is not correctly connected or the charger is not

plugged into AC power.

RED LIGHT

FLASHING

Indicates that the battery charger has AC power available. If

the red light continues to flash after connection, then either the

battery voltage is too low (Less than 2.0 Volts) or the output clips

are not connected correctly.

RED LIGHT

ON STEADY

The battery is connected and charging. The red light will stay on

until the charger completes the charging step.

GREEN LIGHT

FLASHING

The battery is greater than 80% charged and may be removed

from the charger and used if necessary.

GREEN LIGHT

ON STEADY

Charging is complete. The charger can stay connected to keep

the battery fully charged for an indefinite period of time.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINS CONNECTION - CHARGING

Connect the charger to mains power supply.

• If the battery is in an acceptable condition the charge cycle will now

commence and the LED's will show charging information.

• If the battery is not connected properly, the red LED will flash. Charging

will not begin while the red LED flashes.

• When charging begins, the red LED will turn on.

• When the battery is fully charged, the charger will switch to provide a

maintenance charge and may be left connected.

AUTOMATIC - CHARGE CYCLE

DISCONNECTION

1. Switch off the mains supply and unplug the charger.

2. Disconnect the clips, Negative (BLACK lead) -ve first, followed by the

Positive (Red lead) +ve.

3. If the battery has been removed from the vehicle for charging, replace it

and reconnect the cables.

WARNING: DO NOT ATTEMPT TO START THE VEHICLE WITH THE CHARGER

CONNECTED. THIS MAY DAMAGE YOUR BATTERY CHARGER.

Stage 1 Diagnosis/

Analysis:

To check if the battery can accept a charge or

not and prevent charging a defective battery;

Stage 2 Bulk Mode

(Constant

Current)

Fast speed charging, the battery is 0% to 80%

charged;

Stage 3 Absorption Mode

(Constant

Voltage):

Absorption to voltage 14.6V, battery is 80% to

100% charged.

Stage 4 Storage/Float

maintenance

mode:

Automatic On-off Monitoring. The charger will

shut off and will monitor the battery.

If the battery falls below 12.8VDC, the charger

will restart and enter into stage one.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

This charger requires minimal maintenance. As with any appliance or tool, a

few common sense rules will prolong the life of the battery charger.

1. Store in a clean, dry place

2. Coil up the leads when not in use.

3. Clean the case and leads with a slightly damp cloth.

4. Clean any corrosion from the clamps with a solution of water and baking

soda.

5. Examine the leads periodically for cracking or other damage and have

them replaced if necessary.

WARNING: ALWAYS BE SURE THE CHARGER IS UNPLUGGED BEFORE

PERFORMING ANY MAINTENANCE OR CLEANING.

WARNING: ALL OTHER SERVICE SHOULD BE DONE BY QUALIFIED

PERSONNEL ONLY

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ENVIRONMENTAL PROTECTION

Through purchase of this charger, the customer is taking on the

obligation to deal with the WEEE in accordance with the WEEE

regulations in relation to the treatment, recycling & recovery and

environmentally sound disposal of the WEEE.

In effect, this means that this charger must not be discarded with general

waste. Refer to the laws governing Waste Electrical and Electronic Equipment

(WEEE) at a recognised disposal facility.

Inhaltsverzeichnis

Andere Clarke Akkuladegerät Handbücher

Clarke

Clarke DIGICAR 900 Bedienungsanleitung

Clarke

Clarke Start N Charge WIBC200 Bedienungsanleitung

Clarke

Clarke IBC8 Bedienungsanleitung

Clarke

Clarke AC80 Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC120C Bedienungsanleitung

Clarke

Clarke BC520P Bedienungsanleitung

Clarke

Clarke IBC40 Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC150 Bedienungsanleitung

Clarke

Clarke IBC2 Bedienungsanleitung

Clarke

Clarke BC125 Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC260N Bedienungsanleitung

Clarke

Clarke CBO9-12 Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC130 Bedienungsanleitung

Clarke

Clarke IBC50 Bedienungsanleitung

Clarke

Clarke IBC4 Bedienungsanleitung

Clarke

Clarke IBC25 Bedienungsanleitung

Clarke

Clarke Start'N'Charge BC185N Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC420N Installations- und Betriebshandbuch

Clarke

Clarke Start-N-Charge BC120C Bedienungsanleitung

Clarke

Clarke BC 700 Handbuch

Clarke

Clarke HFBC12-24 Bedienungsanleitung

Clarke

Clarke WBC400 Bedienungsanleitung

Clarke

Clarke IBC80 Bedienungsanleitung

Clarke

Clarke ZX-R Pro Series Bedienungsanleitung

Beliebte Akkuladegerät Handbücher anderer Marken

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Bedienungsanleitung

Enelion

Enelion Vertica Bedienungsanleitung

RCA

RCA CHU6 Bedienungsanleitung

ANSMANN

ANSMANN ALCT 6/24-10 Bedienungsanleitung

Hitachi

Hitachi UC 18YRSL Fehlerbehebungshandbuch

Olympus

Olympus B-20 LPC Bedienungsanleitung

Exibel

Exibel ZH1708143 Bedienungsanleitung

Lenmar

Lenmar Mach 1 Bedienungsanleitung

CTEK

CTEK MXS 5.0 Bedienungsanleitung

ABB

ABB HT842379 Bedienungsanleitung

Nitecore

Nitecore Superb Charger SC4 Bedienungsanleitung

Renogy

Renogy RBC2125DS-21W Bedienungsanleitung

Braun

Braun BWC02M Bedienungsanleitung

CTEK

CTEK MXS 3.6 Bedienungsanleitung

Black & Decker

Black & Decker BDV090 Bedienungsanleitung

Trinity

Trinity DPD Bedienungsanleitung

Hulkman

Hulkman Sigma 1 Bedienungsanleitung

IKEA

IKEA koppla Bedienungsanleitung