Dynojet Power Commander III Bedienungsanleitung

2007 Yamaha YZF R1- PCIII USB - 1i426-411 www.powercommander.com

2007 Yamaha YZF R1

Installation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

Parts List

1Power Commander

1USB Cable

1CD-ROM

1Installation Guide

1Power Adapter

2Power Commander Decals

2 Dynojet Decals

2 Velcro®Strip

1Alcohol Swab

1 Wire tap

You can also download the Power

Commander software and latest maps

from our web site at:

www.powercommander.com

The ignition MUST be turned

OFF before installation!

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Button Adjustment Display

Faceplate Buttons

Expansion Port USB Port

1Remove the main seat.

2Lift the front of the fuel tank up and

use something to keep it propped up.

3Route the PCIII harness down the

right hand side of the bike. Route the

PCIII harness underneath the fuel tank

bracket (Fig. A). The bolts that hold

the fuel tank bracket on will need to

be loosened to allow room for the

PCIII harness to fit underneath.

Tighten these bolts after the installa-

tion is complete.

4Unplug the connector from the throt-

tle bodies to the main wiring harness

(Fig. B). This is the 12 pin GREY

connector.

5Plug the PCIII connectors in-line of

the stock connector (Fig. C). Make

sure these connectors are postioned as

to not interfere with the fuel line

when the fuel tank is installed back

into position.

Fig. AFig. B

Fig. C

2007 Yamaha YZF R1- PCIII USB - 2i426-411 www.powercommander.com

PCIII harness

PCIII connectors

Unplug

Stock connectors

Fuel tank bracket

6Crimp the supplied wire tap to the

WHITE wire of the ECU (Fig. D).

This wire is from the smaller of the

two ECU connectors in position 5.

Note:The wire location is numbered

on the back of the connector..

7Connect the GREY wire from the

PCIII to the wire tap (Fig. E).

Note: It is recommended to use dielectric

grease on both of these connections.

8Attach the ground wire from the PCIII

to the negative side of the battery

(Fig. E).

9Install the PCIII to the top, rear part

of the ECU using the supplied velcro

(Fig. F). Make sure to use the alcohol

swab to clean both surfaces before

attaching velcro.

Tuning Notes:

This bike uses a fly-by wire system, so conven-

tional tuning can not be performed for all RPM

and throttle ranges.

The GREY wire from the PCIII is attached to the

throttle blade angle sensor of the throttle bodies

which is NOT directly correlated to the throttle

grip position. Because of this when setting the

throttle position in the PCIII software we recom-

mend on resetting only the closed position after

the bike has completely warmed up. Use the

arrow key (<) next to CLOSED to perform this

step and then click OK. Do not try to set the

OPEN position unless you are on a dyno and

above 9000rpm.

You will notice that in the maps there are not

detailed values below 7000rpm at 100% throttle

and below 5250rpm at 60-80%. This is because

the throttle blades will not open more than 60%

below this RPM range no matter how much throt-

tle input is given. Therefore this area can not be

tuned.

Fig. DFig. E

Fig F

2007 Yamaha YZF R1- PCIII USB - 3i426-411 www.powercommander.com

Ground wire

Wire tap

Grey wire

Inhaltsverzeichnis

Andere Dynojet Autozubehör Handbücher

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Service-Handbuch

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet POWER VISION PV3-25-16 Bedienungsanleitung

Dynojet

Dynojet POWER VISION PV3-17-02 Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power Commander III USB Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet POWER VISION PV3-16-07 Bedienungsanleitung

Dynojet

Dynojet POWER VISION PV3-2504C Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet POWER VISION 3 Bedienungsanleitung

Dynojet

Dynojet power commander III Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet power commander III Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power Commander III Service-Handbuch

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Bedienungsanleitung

Dynojet

Dynojet Power commander V Service-Handbuch

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung