Ekwb EK-FC980 GTX TF5 R2.0 Backplate Leitfaden

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 30th of March, 2016.

Installation and mounting manual for EK-FC980 GTX TF5 (R2.0)

Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of MSI GeForce GTX 980 Ti graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC980 GTX TF5 (R2.0) Backplate is very easy to install. First install EK-FC980 GTX TF5 (R2.0) series water block according to its installation

manual. If you have it already installed, please check the picture below to see which mounting screws are to be left in their position and which

are to be removed. Please remove the five (5) M2,5x4 DIN7985 screws and their washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 30th of March, 2016.

EK-FC980 GTX TF5 (R2.0) Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install

the enclosed thermal pad. Please install enclosed 1mm thick thermal pads (Thermal Pad A –1mm (120x16)) as shown on the picture below. You

may need to trim the excess thermal pad.

STEP 4: ATTACHING EK-FC980 GTX TF5 (R2.0) BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Depending on the variant please use the following combination of

screws. For backplate use five (5) M2.5x8 DIN7985 on the back side.

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over

tightening of the screws. Nevertheless do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC980 GTX Ti TF5 series water blocks. No other 3rd

party heat sinks or coolers are supported!

IMPORTANT DISCLOSURES

EK-FC980 GTX TF5 (R2.0)

Backplate

Thermal PAD F 1mm

M2.5X8 DIN7985 screw

M3 nut

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 30th of March, 2016.

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive chemical, chemical agents or other improper

liquids or solids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS:

Philips head screwdriver scissors

Inhaltsverzeichnis

Andere ekwb Zubehör Handbücher

ekwb

ekwb EK-Momentum AORUS Z390 MASTER Bedienungsanleitung

ekwb

ekwb EK-PRO GPU WB RTX A100 Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector Aorus RTX 2080 D-RGB Bedienungsanleitung

ekwb

ekwb EK-FC970 GTX WF3 Backplate Leitfaden

ekwb

ekwb EK-FB ASUS Maximus XI EXTREME Bedienungsanleitung

ekwb

ekwb EK-FC970 GTX TFX Backplate Leitfaden

ekwb

ekwb EK-Vector Strix RTX 2070 RGB Bedienungsanleitung

ekwb

ekwb EK-FC980 GTX Classy Backplate Leitfaden

ekwb

ekwb EK-FB ASRock X470 Gaming K4 RGB Bedienungsanleitung

ekwb

ekwb EK-XTOP Dual DDC 3.2 PWM Leitfaden

ekwb

ekwb EK-FB ASUS X399 GAMING RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-FB KIT GA-X99 Handbuch

ekwb

ekwb EK-DCP 4.0 X-RES Leitfaden

ekwb

ekwb EK-FC1070/1080 GTX Bedienungsanleitung

ekwb

ekwb EK-Velocity WS Series Bedienungsanleitung

ekwb

ekwb EK-FB ASRock X470 Taichi RGB Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX Ti Strix RGB Bedienungsanleitung

ekwb

ekwb EK-FC 1070 GTX Ti ASUS Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX Ti TF6 Bedienungsanleitung

ekwb

ekwb EK-FC GV100 PRO Bedienungsanleitung

ekwb

ekwb EK-FC7990 SE Leitfaden

ekwb

ekwb EK-FB MSI X470 M7 RGB Bedienungsanleitung

ekwb

ekwb EK-FC980 GTX Strix Backplate Leitfaden

ekwb

ekwb EK-SF3D Critical Point Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung

ekwb EK-FC980 GTX TF5 R2.0 Backplate Leitfaden

Beliebte Zubehör Handbücher anderer Marken