Ekwb EK-FC R9-290X SE Backplate Leitfaden

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 16th of July, 2014.

Installation and mounting manual for EK-FC R9-290X SE Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of Powercolor Radeon R9-290 series graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC R9-290X SE Backplate is very easy to install. First install EK-FC R9-290X SE series water block according to its installation manual. If you

have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed.

Please remove the five (5) M3x4 DIN7985 screws and their washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

EK-FC R9-290X SE Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed 1mm and 1,5mm thick thermal pad (Thermal Pad A –1mm (100x16), Thermal Pad C –1,5mm

(25x25)) as shown on the picture below. You may need to trim the excess thermal pad.

Thermal PAD C 1,5mm

Thermal PAD A 1mm

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 16th of July, 2014.

STEP 4: ATTACHING EK-FC R9-290X SE BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Use four (5) M3x8 DIN7991 and one (1) M3x10 DIN7991 with M3 nut

(see picture below).

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over

tightening of the screws. Nevertheless do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC R9-290X SE series water blocks. No other 3rd party

heat sinks or coolers are supported!

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive chemical, chemical agents or other improper

liquids or solids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS:

Philips head screwdriver scissors

M3x8 DIN7991 screw

M3x10 DIN7991 screw

M3 nut

PVC washer

YOU MUST REMOVE ALL PVC

WASHERS FROM THE BACK OF

THE PCB BEFORE INSTALLING

THE BACKPLATE!

M3 nut

Figure1: Detail A

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb SLIM 120 Bedienungsanleitung

ekwb

ekwb Vector 2 FTW3 RTX 3080/90 ABP Bedienungsanleitung

ekwb

ekwb EK-SF3D Inflection Point EVO Bedienungsanleitung

ekwb

ekwb EK-FB ASUS Max4 Extreme Leitfaden

ekwb

ekwb EK-AIO Elite 360 D-RGB Bedienungsanleitung

ekwb

ekwb EK-FC Titan X Original CSQ Handbuch

ekwb

ekwb EK-FC470 GTX Handbuch

ekwb

ekwb EK-FC 6970 V2 Handbuch

ekwb

ekwb EK-FB KIT RE4 Handbuch

ekwb

ekwb EK-FC7990 Handbuch

ekwb

ekwb EK-FB KIT GA-X99 LE Leitfaden

ekwb

ekwb EK-Quantum Momentum ROG Crosshair VIII Hero Bedienungsanleitung

ekwb

ekwb EK-Supremacy Elite Edition series Bedienungsanleitung

ekwb

ekwb EK-FB ASUS ROG R6E Monoblock Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Backplate Leitfaden

ekwb

ekwb EK-FB ASUS M8I Monoblock Bedienungsanleitung

ekwb

ekwb EK H30 SUPREME Bedienungsanleitung

ekwb

ekwb EK-UNI Holder D5 V3 Handbuch

ekwb

ekwb EK-FC 6970 Handbuch

ekwb

ekwb Velocity Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector RE RTX 3080 Active Backplate... Bedienungsanleitung

ekwb

ekwb EK-FC680 GTX DCII Handbuch

ekwb

ekwb EK-Quantum Vector FE RTX 3080 Bedienungsanleitung

ekwb

ekwb EK-Quantum Momentum TRX40 Aorus Master Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-FC R9-290X SE Backplate Leitfaden

Beliebte Computerhardware Handbücher anderer Marken