Extron electronics UCS FT 901 Bedienungsanleitung

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

UCS FT 901 and UCS FR 902 • Setup Guide

This guide provides basic instructions for an experienced technician to install and

congure the Extron UCS 900 Series. The UCS FT 901 and UCS FR 902 extend USB

signals from USB 3.x, 2.0, and 1.1 peripheral devices located up to 492 feet (150 meters)

away to a USB 3.x host computer over multimode ber optic cable, with a SuperSpeed

data transfer rate of up to 5 Gbps. The transmitter features a USB Type-C connector.

The receiver features a built-in active two-port hub that supplies up to 5 V, 1.5 A from

each port to power attached devices.

See the UCS FT 901 and UCS FR 902 User Guide, available at www.extron.com, for more information.

NOTE:

• This product supports USB data ONLY. DisplayPort Alt Mode and Power Delivery are NOT supported.

• The use of a USB 2.0 hub on the UCS FR 902 is not recommended. If a hub is needed in the system, Extron

recommends the use of a USB 3.x hub. Please contact your Extron AE for more details.

Installation

ATTENTION: Installation and service must be performed by authorized personnel only.

ATTENTION : L’installation et l’entretien doivent être effectués uniquement par un technicien qualifié.

Mounting

The UCS FT 901 and UCS FR 902 can be rack mounted, furniture mounted, or placed on a tabletop with the provided rubber feet.

For ZipClip mounting instructions, see the UCS FT 901 and UCS FR 902 User Guide at www.extron.com.

Connecting Cables

WARNING: Fiber optic connectors emit continuous invisible light, which may be harmful to the eyes; use with caution. Do

not look into the fiber optic cable connectors or into the fiber optic cables themselves. Plug the attached dust caps into the

optical transceivers when the fiber cable is unplugged.

ADVERTISSEMENT : Les connecteurs de fibre optique émettent une lumière invisible continue, qui peut être dangereuse

pour les yeux ; à utiliser avec précaution. Ne pas fixer directement les connecteurs optiques ou les câbles fibre optique.

Branchez les protections contre la poussière dans l’ensemble émetteur/récepteur lorsque le câble fibre optique est

débranché.

The illustration below shows connections for the UCS FT 901 and UCS FR 902.

POWER

12V

HOST

USB-C

SS 5G Tx

OUTPUT

POWER

12V

1.0A MAX

INPUT

OUTPUTS

WER

A MAX

INPUT

UTPUT

POWER

12V

DEVICES INPUT

1.5 A

1.6A MAX

Ground

+12 VDC input

External Power Supply

(12 VDC, 2.0 A max.)

Ground all

Devices

Ground

+12 VDC input

External Power Supply

(12 VDC, 0.5 A max.)

Ground all

Devices

0.1A MAX

USB

USB Camera

Receiver

USB

Laptop

Transmitter

Multimode Fiber Optic Cable

Compatible with USB 3.x, 2.0, 1.x

peripheral devices

Compatible with USB 3.x

host ports ONLY

68-3621-50 Rev. C

05 21

For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the

Extron Safety and Regulatory Compliance Guide on the Extron website.

All trademarks mentioned are the property of their respective owners.

Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876

Connecting Power

Power off all devices that will be directly connected to the receiver.

Wire the provided 24 W power supply (see previous page, 1) to

the receiver 2-pole captive screw connector (3), and the provided

6 W power supply (2) to the transmitter (see gure at right for

wiring instructions).

NOTE: The UCS FT 901 (transmitter) can also be powered

by the Host device, without the need for the external

power supply.

Once a unit receives power, the front panel Power LED (see unit

illustrations to the right, A) lights.

Connecting the Host (Transmitter)

1. Connect a USB Type A-to-C (or Type C-to-C) cable from the

Host device to the transmitter HOST port (see previous page,

4). The HOST LED on the transmitter (see figure at right, B)

lights as communication between the transmitter and host

device is established.

NOTE: The transmitter is compatible with and must

be connected to a USB 3.x host ports ONLY. Ensure

that the USB cable used between the USB port of the

Host PC and transmitter input supports USB 3.x.

USB 3.x ports are either blue Type A, Type C, or

labeled with a SuperSpeed trident logo (see below).

2. Connect a multimode fiber optic cable from the output port of the transmitter to the input port of the receiver (see previous

page, 5).

3. Once the cable is connected to both the transmitter and receiver, the front panel LINK LEDs light steadily (see figure above, C).

4. Mount the devices, if appropriate.

5. Power on the host device. The transmitter (UCS FT 901) HOST LED (B) lights when the computer recognizes the transmitter.

Connecting the Devices (Receiver)

The receiver is compatible and can be connected to USB 3.x, 2.0, & 1.x peripheral devices. Connect up to two USB peripheral

devices to the receiver devices ports (see previous page, 6). The order of connection does not matter.

The UCS FR 902 (receiver) supplies up to 5 V, 1.5 A to each connected peripheral device.

The system is now ready to operate.

Captive Screw Connector

Tie Wrap

Heat

Shrink 1/8"

(3 mm)

7/8"

(22 mm)

3/16"

(5 mm) Max.

eUCS FR 902

LINK

STATUS

POWER

12V

--A MAX

DEVICES INPUT

1.5 A

A C

UCS FT 901e

LINK

HOST

STATUS

POWER

12V

0.1A MAX

HOST

USB-C

SS 5G Tx

OUTPUT

A B C

A B

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Extron electronics Computerhardware Handbücher

Extron electronics

Extron electronics Annotator 401 Bedienungsanleitung

Extron electronics

Extron electronics Network Device PIP 444 Bedienungsanleitung

Extron electronics

Extron electronics IPL Pro Series Bedienungsanleitung

Extron electronics

Extron electronics IPL M PDP-ES Montage- und Bedienungsanleitung

Extron electronics

Extron electronics IPCP Pro Series Bedienungsanleitung

Extron electronics

Extron electronics AXP 64 C AT Bedienungsanleitung

Extron electronics

Extron electronics IPL Pro Series Bedienungsanleitung

Extron electronics

Extron electronics Quantum Ultra Bedienungsanleitung

Extron electronics

Extron electronics IPCP Pro PCS1 Bedienungsanleitung

Extron electronics

Extron electronics AXP 64 C AT Bedienungsanleitung

Extron electronics

Extron electronics XMP 240 C AT Bedienungsanleitung

Extron electronics

Extron electronics IPCP 505 Bedienungsanleitung

Extron electronics

Extron electronics Instruction Card Video DC Block Technisches Handbuch

Extron electronics

Extron electronics StudioStation 100 Bedienungsanleitung

Extron electronics

Extron electronics Annotator 300 Bedienungsanleitung

Extron electronics

Extron electronics DMP Plus Series Bedienungsanleitung

Extron electronics

Extron electronics DMP 64 Plus Bedienungsanleitung

Extron electronics

Extron electronics DTP3 T/R 301 Bedienungsanleitung

Extron electronics

Extron electronics DTP3 T 202 Bedienungsanleitung

Extron electronics

Extron electronics UCS 601 Bedienungsanleitung

Extron electronics

Extron electronics DMP 44 LC Bedienungsanleitung

Extron electronics

Extron electronics EDID 101H 4K PLUS Bedienungsanleitung

Extron electronics

Extron electronics DMP 128 Plus Bedienungsanleitung

Extron electronics

Extron electronics Multi-Graphic Processor MGP 464 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung