Federal Signal Corporation DFC-WC-DUR21 Bedienungsanleitung

Installing the DFC-WC-DUR21 Push Bumper Wire

Cover on the 2021+ Dodge®Durango®

Safety Message to Installers and Service Personnel of Emergency Vehicle Safety

Equipment

People's lives depend on your proper installation and servicing of Federal Signal products. It is important

to read and follow all instructions shipped with this product. Listed below are some other important safety

instructions and precautions you should follow:

Before Installation or Service

Qualications

• To properly install or service this equipment, you must have a good understanding of automotive

electrical procedures and systems along with proﬁciency in the installation and service of safety warning

equipment. Always refer to the vehicle service manuals when installing equipment on a vehicle.

Electrical Hazards

• Never attempt to install aftermarket equipment that connects to the vehicle wiring without reviewing a

vehicle wiring diagram available from the vehicle manufacturer. Ensure that your installation will not aect

vehicle operation and safety functions or circuits.

During Installation or Service

• To avoid a battery explosion, always disconnect the negative battery cable ﬁrst and reconnect it last.

Avoid causing a spark when connecting near or to the battery. The gasses produced by a battery can

cause a battery explosion that could result in vehicle damage and serious injury.

• Do not install equipment or route wiring or a plug-in cord in the deployment path of an airbag.

• Before mounting any components, check the manual to ensure that the component you are installing

is suitable for use in that area of the vehicle. Many components are not suitable for use in the engine

compartment or in other areas subject to extreme environmental exposure.

• When drilling into a vehicle structure, ensure that both sides of the surface are clear of anything that

could be damaged. Remove all burrs from drilled holes to prevent electrical shorts, and grommet all

drilled holes through which wiring passes. Ensure that mounting screws do not cause electrical or

mechanical damage to the vehicle.

After Installation or Service

• To ensure proper operation, test all vehicle functions, including horn operation, vehicle safety functions,

and vehicle light systems. Ensure that installation has not aected vehicle operation or changed any

vehicle safety function or circuit.

• After installation and testing are complete, provide a copy of these instructions to instructional sta and

all operating personnel.

• File these instructions in a safe place and refer to them when maintaining and/or reinstalling the product.

Failure to follow all safety precautions and instructions may result in property damage, serious injury, or

death.

25500849 Rev A0 0623

Installing the DFC-WC-DUR21 Push Bumper Wire Cover on the 2021+ Dodge®Durango®

2 DFC-WC-DUR21 Push Bumper Wire Cover

Federal Signal www.fedsig.com

Introduction

This document contains instructions for installing the DFC-WC-DUR21 Push Bumper Wire Cover in a 2021+

Dodge Durango. This product is to be installed only on the DFC-PB-DUR21 Push Bumper.

Unpacking the Product

After unpacking the product, inspect it for damage that may have occurred in transit. If it has been damaged,

do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of the

damage. Failure to identify damage before installation could lead to the rejection of any claim. Carefully check

all envelopes, shipping labels, and tags before removing or destroying them. Ensure that the parts listed in

Table 1 are included in the package. If you are missing any parts, contact Federal Signal Customer Support at

1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).

THREAD DAMAGE AND GALLING: To prevent thread damage and galling, anti-seize lubricant must

be used on all stainless steel fasteners.

Table 1 Kit contents

Item Description Qty.

1 Driver Side Wire Cover 1

2 Passenger Side Wire Cover 1

3 No. 6-32 x 2-inch Button Head Bolt 4

4 No. 6 Lock Washer 4

5 No. 6 Flat Washer 4

6 No. 6-32 Hex Nut 4

Figure 1 Kit items

Item 1 Item 2

Installing the DFC-WC-DUR21 Push Bumper Wire Cover

FASTENERS PRECAUTION: Double-check all fasteners before initial use and periodically in the

future to ensure proper function and safety.

FOR CALIFORNIA RESIDENTS ONLY; PROPOSITION 65 WARNING: Some products may contain

chemicals such as DEHP, which can cause cancer, birth defects, or other reproductive harm. For

more information, go to www.p65warnings.ca.gov.

Installing the DFC-WC-DUR21 Push Bumper Wire Cover on the 2021+ Dodge®Durango®

DFC-WC-DUR21 Push Bumper Wire Cover

Federal Signal www.fedsig.com

To install the DFC-WC-DUR21 Push Bumper Wire Cover:

1. Place the wire covers (Items 1 and 2) as shown in Figure 2. Note that the ﬁgure is of the driver-side wire

cover (Item 1).

Figure 2 Wire cover placement (Driver side shown)

2. Install the supplied hardware as shown in Figure 3.

Figure 3 Install hardware

3. Tighten all hardware to 8 ft-lb.

Care Instructions

Regularly clean the textured powder coat ﬁnishes with either a soft cloth or a brush with mild soap and warm

water. Avoid using any harsh chemicals, as this will damage the product's ﬁnish. Pressure washing this product

is the most ecient way to remove heavy dirt and grime. The pressure washer should be used on a low-

pressure setting with ﬁltered water for best results. Using high pressure can damage the product's ﬁnish.

Installing the DFC-WC-DUR21 Push Bumper Wire Cover on the 2021+ Dodge®Durango®

4 DFC-WC-DUR21 Push Bumper Wire Cover

Federal Signal www.fedsig.com

Getting Technical Support

For technical support, please contact:

Federal Signal Corporation

Service Department

Phone: 1-800-433-9132

Email: [email protected]

Getting Repair Service

The Federal Signal factory provides technical assistance with any problems that cannot be handled locally.

Any product returned to Federal Signal for service, inspection, or repair must be accompanied by a Return

Material Authorization (RMA). Obtain an RMA from a local Distributor or Manufacturer’s Representative. Provide

a brief explanation of the service requested or the nature of the malfunction.

Address all communications and shipments to the following:

Federal Signal Corporation

Service Department

2645 Federal Signal Dr.

University Park, IL 60484-3167

Limited Warranty

This product is subject to and covered by a limited warranty, a copy of which can be found at

www.fedsig.com/SSG-Warranty. A copy of this limited warranty can also be obtained by written request to

Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to [email protected] or

call +1 708-534-3400.

This limited warranty is in lieu of all other warranties, express or implied, contractual or statutory, including,

but not limited to the warranty of merchantability, warranty of ﬁtness for a particular purpose and any warranty

against failure of its essential purpose.

2645 Federal Signal Drive

University Park, Illinois 60484-3167

www.fedsig.com

Customer Support

Police/Fire-EMS: 800-264-3578 • +1 708 534-3400

Work Truck: 800-824-0254 • +1 708 534-3400

Technical Support: 800-433-9132 • +1 708 534-3400

All product names or trademarks are properties of their respective owners.

Inhaltsverzeichnis

Andere Federal Signal Corporation Autozubehör Handbücher

Federal Signal Corporation

Federal Signal Corporation JetSolaris JLX Series Handbuch

Federal Signal Corporation

Federal Signal Corporation Vision SLR Original Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation Vista Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ESB-CRG07 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation VIPER EXT Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation 501900-31XX Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ARJENT S2 SERIES Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Cuda TriOptic 351014F Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ML-PT Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation HighLighter Montageanleitung

Federal Signal Corporation

Federal Signal Corporation RAYDIAN Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CAMSET56-AHD-NTSC2 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation DFC-WC-FRD21 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120A Handbuch

Federal Signal Corporation

Federal Signal Corporation LEDTCL97 Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation Legend LGD Einrichtungshandbuch

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120 Handbuch

Federal Signal Corporation

Federal Signal Corporation DFC Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CAMLCD-AHD-70 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Cuda TriOptic SIGNALMASTER 328823F Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CUDA TRIOPTIC 351011 Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation SpectraLux SIFZ Front ILS Handbuch

Federal Signal Corporation

Federal Signal Corporation GH1K Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation VSLR1-IPX Series Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung