Federal Signal Corporation Vision SLR Original Betriebsanleitung

Safety Message to Installers of Warning Light Equipment

People’s lives depend on your proper installation and servicing of Federal Signal products. It is important to

read and follow all instructions shipped with this product and the original product. Listed below are some

other important safety instructions and precautions you should follow:

• To properly install the lighting system, you must have a good understanding of automotive systems,

along with proﬁciency in the installation and use of safety warning equipment.

• Do not install equipment or route wiring in the deployment path of an airbag.

• If a vehicle seat is temporarily removed, verify with the vehicle manufacturer if the seat needs to be

recalibrated for proper airbag deployment.

• Frequently inspect the light system to ensure that it is operating properly and that it is securely

attached to the vehicle.

• When drilling into a vehicle structure, ensure that both sides of the surface are clear of anything that

could be damaged.

• Refer to the instructions packed with related products for additional precautions and information.

• File these instructions in a safe place and refer to them when maintaining and/or reinstalling the

product.

• Do not stare directly into the lights at a close range, or permanent damage to your eyesight may occur.

Failure to follow all precautions and instructions may result in property damage, serious injury, or death.

Introduction

This publication has instructions for installing the Rooftop-Mount Quick Disconnect for the Vision®SLR.

The Quick Disconnect enables service personnel to quickly disconnect both power and communication

together without opening the light bar. The cables are factory installed on the VisionSLR. No

connections inside the light bar are required.

NOTE: For electrical installation instructions, including instructions on mating and unmating the Quick

Disconnect connectors, refer to the Installation and Maintenance Instructions packed with the light bar.

Unpacking the Kit

After unpacking the kit, inspect it for damage that may have occurred in transit. If it has been damaged,

do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of the

damage. Carefully check all envelopes, shipping labels, and tags before removing or destroying them.

Ensure that the parts listed in Table 1 are included in the package. If you are missing any parts, contact

Customer Support at 1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).

Vision®SLR Rooftop-Mount Quick

Disconnect Manual

25500173 A2 0620

Vision®SLR Rooftop-Mount Quick Disconnect Manual

2Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

Table 1 Kit contents

Qty. Description Part Number

1Stud Plate Assembly 865200989

1 Gasket 8652152

1Roof Seal 865200990

3 8-32 Hex Head Elastic Stop Nut Stainless Steel 7058056

3 #8-32 Stainless Steel Acorn Nut 7054017

1 FPIU20 Stud Plate Assembly, 1-inch studs* 865200989-16

1 FPIU20 Roof Seal* 865203359

* These two items are used for Ford Interceptor Utility, 2020+

Installing the Quick Disconnect

AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the deployment of an airbag.

Failure to observe this warning will reduce the eectiveness of the airbag or potentially dislodge

the equipment, causing serious injury or death.

DRILLING PRECAUTIONS: Before drilling holes, check the area into which you plan to drill to

ensure that you do not damage vehicle components. All drilled holes should be deburred and all

sharp edges should be smoothed. All wires going through drilled holes should be protected by

a grommet or convolute/split-loom tubing.

NOTE: Due to the crown of the roof, the drainage of the roof seal is designed for installation of the

passenger side of the vehicle. The Quick Disconnect must be installed with the two electrical connectors

facing the rear of the vehicle.

IMPORTANT: Plan all cable routing before the installation.

Tools needed:

• Power drill

• 3/16-inch drill bit

• 7/8-inch drill bit

• Scratch awl

• RTV sealant

Vision®SLR Rooftop-Mount Quick Disconnect Manual

Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

Preparing the Installation Surface

To prepare the installation surface for the stud plate:

1. Following the vehicle manufacturer instructions, remove the headliner.

2. From inside the vehicle, position the stud plate against the roof so it clears ribs, braces, and other

interferences. See Figure 1. For Ford Interceptor Utility, 2020+, verify that the seal will sit properly

between the roof ribs.

Figure 1 Position of stud plate on interior of roof

Toward Front of Vehicle

290A7827

3. Mark the center of the large cable routing hole in the stud plate and drill a 7/8-inch hole.

4. Snap the appropriate roof seal into the 7/8-inch hole and use it as template to mark the three stud

locations with a scratch awl.

5. Remove the roof seal and drill the three holes with a 3/16-inch drill.

Vision®SLR Rooftop-Mount Quick Disconnect Manual

4Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

Completing the Installation

To complete the installation:

1. Apply the gasket to the appropriate stud plate. See Figure 2.

Figure 2 Exploded view of Quick Disconnect installed on roof

Vehicle Roof

8-32 Stop Nut (3)

Stud Plate

Acorn Nut (3)

Gasket

290A7828B

2. From outside the vehicle, route the cables through the roof seal, roof, and then the appropriate stud

plate.

3. Seal all drilled holes with RTV and snap the roof seal in place.

4. From inside the vehicle, push the stud plate into position. The friction of the roof seal will hold the

plate up.

5. Seal the cables to the roof seal with RTV and lower the housing over the studs.

6. Install the 8-32 stop nuts. Tighten the stop nuts just until the roof seal starts to bulge. Do not over-

tighten the nuts.

7. If you are not using the FPIU20 assembly, tighten the acorn nuts over the stop nuts. Do not

overtighten the nuts.

Vision®SLR Rooftop-Mount Quick Disconnect Manual

Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

8. Reinstall the headliner.

9. Complete the wiring according to the instructions supplied with the light bar.

Getting Technical Support

For technical support, please contact:

Federal Signal Corporation

Service Department

Phone: 1-800-433-9132

Fax: 1-800-343-9706

Email: [email protected]

Vision®SLR Rooftop-Mount Quick Disconnect Manual

6Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

Getting Repair Service

The Federal Signal factory provides technical assistance with any problems that cannot be handled

locally. Any product returned to Federal Signal for service, inspection, or repair must be accompanied

by a Return Material Authorization (RMA). Obtain a RMA from a local Distributor or Manufacturer’s

Representative. Provide a brief explanation of the service requested, or the nature of the malfunction.

Address all communications and shipments to the following:

Federal Signal Corporation

Service Department

2645 Federal Signal Dr.

University Park, IL 60484-3167

Limited Warranty

This product is subject to and covered by a limited warranty, a copy of which can be found at

www.fedsig.com/SSG-Warranty. A copy of this limited warranty can also be obtained by written request

to Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to info@fedsig.

com or call +1 708-534-3400.

This limited warranty is in lieu of all other warranties, express or implied, contractual or statutory,

including, but not limited to the warranty of merchantability, warranty of ﬁtness for a particular purpose

and any warranty against failure of its essential purpose.

Vision®SLR Rooftop-Mount Quick Disconnect Manual

Rooftop-Mount Quick Disconnect

Federal Signal www.fedsig.com

Ordering Replacement Parts

To order replacement parts, call Customer Support at 1-800-264-3578, 7a.m. to 5 p.m., Monday through

Friday (CT) or contact your nearest distributor.

2645 Federal Signal Drive

University Park, Illinois 60484-3167

www.fedsig.com

Customer Support

Police/Fire-EMS: 800-264-3578 • +1 708 534-3400

Work Truck: 800-824-0254 • +1 708 534-3400

Technical Support: 800-433-9132 • +1 708 534-3400

All product names or trademarks are property of their respective owners.

Inhaltsverzeichnis

Andere Federal Signal Corporation Autozubehör Handbücher

Federal Signal Corporation

Federal Signal Corporation Cuda TriOptic 351014F Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Fireball FB2LED Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation XHK-SD Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CAMSET56-AHD-NTSC2 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Vision SLR Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation DFC-WC-FRD21 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120B Handbuch

Federal Signal Corporation

Federal Signal Corporation VIPER EXT Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation DFC-WC-DUR21 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation LEDTCL97 Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation ESB-CRG07 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation RAYDIAN Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ARJENT S2 SERIES Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation DFC Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Viewpoint FV Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120 Handbuch

Federal Signal Corporation

Federal Signal Corporation Spectralux Rear ILS Light Bar Handbuch

Federal Signal Corporation

Federal Signal Corporation GHSCENE Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CommCenter D1 Series Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation JetSolaris JLX Series Handbuch

Federal Signal Corporation

Federal Signal Corporation Vision SLR Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation SpectraLux SIFZ Front ILS Handbuch

Federal Signal Corporation

Federal Signal Corporation SpectraLux SIFZJ FSJoin Handbuch

Federal Signal Corporation

Federal Signal Corporation Vista Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung