Kohler K-73078 Montageanleitung

Installation and Care Guide

Diverter Bath Faucet with Remote Valve

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-73078

1276522-2-A

Tools and Materials

Before You Begin

WARNING: Risk of personal injury. Do not install the bath

faucet in an area where it may inadvertently be used for

support by the bather.

CAUTION: Risk of property damage. Select a cutting tool

appropriate for the deck/rim surface type. Refer to the

surface manufacturer’s instructions for the proper cutting

procedures.

Observe all local plumbing and building codes.

Shut off the water supply.

Protect the surface of the bath deck/rim during installation.

Kohler Co. recommends installing a Sioux Chief 652-AD vacuum

breaker arrestor (or equivalent) close to the outlet of the remote

valve. This will reduce cavitation and water hammer when the

valve or diverter is activated. Visit Sioux Chief’s website at

www.siouxchief.com for technical and installation information.

Plumbers

Putty

5/8" OD Copper

Tubing (1/2" Nominal)

Rags

Solder

Plus:

Cutting Tools

Wood Reinforcement (Optional)

Vacuum

Breaker

Arrestor

1276522-2-A 2 Kohler Co.

Roughing-In

1. Prepare the Site

NOTE: To simplify future servicing, install an access panel to reach

the plumbing.

NOTICE: The remote valve may be installed anywhere on the deck.

To allow adequate clearance for handle rotation, provide a minimum

distance of 5-3/4″(146 mm) from the center of the spout to the

center of the valve.

Determine the mounting hole locations for the spout diverter and

remote valve. Refer to the roughing-in dimensions illustrated for

proper placement and diameters.

For a ﬁnished bath deck/rim less than 5/8″(16 mm) thick: Install

wood reinforcement to the underside of the deck/rim. The

combined thickness of the reinforcing material and the deck/rim

must not exceed 3″(76 mm).

CAUTION: Risk of property damage. Select a cutting tool

appropriate for the deck/rim surface type. Refer to the

surface manufacturer’s instructions for proper cutting

procedures.

1-11/16"

(43 mm)

9-3/16"

(233 mm)

5-13/16"

(148 mm)

5/8"

(16 mm)

Min

(76 mm)

Max

8-1/4"

(210 mm)

6-1/2"

(165 mm)

1-1/8"

(28 mm)

Ø 1-1/2"

(38 mm)

Max

Ø 1-1/2"

(38 mm)

Max

5-3/4"

(146 mm)

Min

Ø 1-1/2"

(38 mm)

Max

Kohler Co. 3 1276522-2-A

Prepare the Site (cont.)

NOTICE: Do not exceed 1-1/2″(38 mm) hole diameters for the

spout diverter and the remote valve mounting holes. Maximum

contact area is necessary for a successful installation.

Carefully cut mounting holes for the spout diverter and remote

valve.

Install or relocate the water supplies as needed.

1276522-2-A 4 Kohler Co.

2. Install the Remote Valve

Insert the O-ring into the groove in the underside of the

escutcheon.

Slide the escutcheon onto the remote valve.

Insert the remote valve assembly through the mounting hole.

Slide the plate onto the remote valve, then wrench tighten the

three nuts to secure the remote valve.

Escutcheon

O-Ring

Nut

Plate

Remote Valve

Kohler Co. 5 1276522-2-A

3. Install the Spout

NOTICE: The brass collar with O-ring included in the hardware

bag is not needed for this installation. Please discard the brass collar

with O-ring.

Insert the remaining O-ring into the groove in the underside of

the escutcheon.

Thread the nut all the way down the diverter valve.

Insert the diverter valve into the mounting hole from underneath.

Thread the escutcheon down the diverter valve until it stops.

Wrench tighten the nut to secure the diverter valve.

Use a needle-nose pliers to lift and hold the diverter tube. Then

thread the lift rod into the diverter tube.

Ensure that the setscrew does not protrude beyond the inside

wall of the spout. Back the setscrew out if needed.

IMPORTANT! Do not bend the lift rod during spout installation.

Position the spout over the lift rod, and slide it down onto the

diverter valve.

Tighten the setscrew.

Insert the plug button into the setscrew hole.

Setscrew

Plug Button

Lift Rod

Diverter

Tube

Nut

Diverter Valve

O-Ring

Escutcheon

1276522-2-A 6 Kohler Co.

4. Install the Lift Knob

IMPORTANT! Do not overtighten the lift knob setscrews.

Press the lift knob connector down onto the lift rod. Tighten the

two setscrews.

Fit the lift knob onto the lift rod connector. Tighten the two

setscrews.

Lift Rod Setscrew Lift Knob

Setscrew

Lift Knob

Connector

Kohler Co. 7 1276522-2-A

5. Connect the Plumbing

NOTE: The illustration shown is a suggested plumbing connection

method. Actual plumbing connections will vary by site.

Verify that the spout, diverter valve, and remote valve are

properly positioned and secured.

Cut and assemble the copper tubing and connections to ﬁt the

installation layout.

Install a vacuum breaker arrestor near the diverter valve inlet.

Follow the vacuum breaker arrestor manufacturer’s instructions.

Solder the connections.

Use thread sealant tape, and securely wrench tighten a cap to the

open inlet port of the diverter valve.

Vacuum Breaker

Arrestor

Cap

1276522-2-A 8 Kohler Co.

6. Install the Hose Guide

Thread the hose guide escutcheon onto the shank.

Insert the hose guide assembly and gasket into the mounting

hole.

Slide the washer and spacer up the shank from underneath.

Thread the nut up the hose guide, and securely wrench tighten.

Hose Guide

Escutcheon

Gasket

Shank

Washer

Spacer

Nut

Kohler Co. 9 1276522-2-A

7. Install the Handshower

Run cold and hot water through the shower outlet to ﬂush out

dirt and debris.

Insert the screen washer into the outlet end of the elbow, and

thread the elbow onto the handshower. Adjust the position of the

elbow as needed so the installed handshower will lean over the

bath rim.

Fit a rubber gasket into the tapered end of the handshower hose,

and securely handtighten the handshower hose to the elbow.

Fit a rubber gasket into the handshower hose, and securely hand

tighten the handshower hose to the high-pressure hose.

Feed the hoses into the hose guide.

Fit a rubber gasket into the end of the high-pressure hose, and

securely wrench tighten the high-pressure hose to the spout

diverter.

Screen Washer

Nut

Inlet

To spout diverter.

Elbow

High-Pressure

Hose

Handshower Hose

Rubber

Gasket

Rubber Gasket

1276522-2-A 10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Avid T97367-4-BN Bedienungsanleitung

Kohler

Kohler Memoirs K-2238 Montageanleitung

Kohler

Kohler K-25875-0 Bedienungsanleitung

Kohler

Kohler K-616 Montageanleitung

Kohler

Kohler Stance 14775-4-CP Montageanleitung

Kohler

Kohler K-7273-AF Montageanleitung

Kohler

Kohler 24811A-0 Installationsanleitung

Kohler

Kohler K-T343 Bedienungsanleitung

Kohler

Kohler Mira Logic L19B Bedienungsanleitung

Kohler

Kohler K-T13141 Montageanleitung

Kohler

Kohler K-T314 Bedienungsanleitung

Kohler

Kohler Sterling 442007-U Bedienungsanleitung

Kohler

Kohler K-18829 Bedienungsanleitung

Kohler

Kohler K-7437 Bedienungsanleitung

Kohler

Kohler COUTURE WATERGUARD Bedienungsanleitung

Kohler

Kohler PURIST UPGRADE Bedienungsanleitung

Kohler

Kohler Lyntier K-10331 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Kohler

Kohler K-8247 Montageanleitung

Kohler

Kohler SKYLINE Series Bedienungsanleitung

Kohler

Kohler K-349 Montageanleitung

Kohler

Kohler K-6812 Bedienungsanleitung

Kohler

Kohler K-3444K-NS Montageanleitung

Kohler

Kohler K-11618 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung