Kohler Lyntier K-10331 Bedienungsanleitung

Installation Guide

Lavatory Faucet

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-10331

1048638-2-B

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Tools and Materials

Before You Begin

Observe all local plumbing and building codes.

Shut off the main water supply.

Carefully inspect the waste and supply tubing for any sign of

damage.

For new installations, install the faucet and drain to the lavatory

before installing the lavatory.

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Adjustable

Wrench

Plumbers Putty 1/8"

Hex Wrench

1048638-2-B 2 Kohler Co.

1. Install the Faucet

Assemble the Faucet

NOTE: If your faucet is already assembled, continue to ″Install the

Faucet.″

Remove the plug from the faucet body and the cap from the

spout. Discard the plug and cap.

Insert the spout into the faucet body and press down ﬁrmly to

engage the seal.

Position the spout.

Using the provided setscrew and wrench, secure the spout to the

faucet body.

Install the Faucet

Clean the lavatory surface to remove any grease, oil, or debris.

Insert the faucet supply hoses and the studs into the mounting

holes.

Slide a mounting nut over each supply hose and thread onto the

studs.

Lift Rod

Faucet Body

Gasket

Cap

Plug

Setscrew

Escutcheon

Supply Hoses

Mounting Nuts

Stud

Mounting Hole

Kohler Co. 3 1048638-2-B

Install the Faucet (cont.)

Hand tighten the mounting nuts to secure the faucet to the

mounting surface.

Insert the lift rod into the hole in the escutcheon.

1048638-2-B 4 Kohler Co.

2. Install the Drain

Remove the plastic cap from the drain assembly.

Remove the stopper from the ﬂange.

Remove the ﬂange from the drain body.

Thread the body nut down the drain body.

Slide the seal down to the body nut.

From underneath the lavatory, insert the drain body through the

drain hole.

Apply plumbers putty to the underside of the ﬂange.

Thread the ﬂange onto the top of the drain body.

Thread the body nut up the drain body until the seal is

compressed against the underside of the lavatory.

Wipe away any excess plumbers putty from around the ﬂange.

Remove the rod nut from the drain body.

Remove the clip from the rod.

Body Nut

Stopper

Stopper Bolt

Plastic Cap

Lift Rod

Flange

Drain Body

Tailpiece

Seal

Rod

Clip

Rod Nut

Link

Thumbscrew

Kohler Co. 5 1048638-2-B

Install the Drain (cont.)

Insert the short end of the rod into the seal hole and under the

stopper. Loosely secure in place with the rod nut.

Push the rod down to open the drain.

Insert the stopper into the drain assembly.

Remove and adjust the stopper so it lifts approximately 3/8″(1

cm) when opened. To adjust, hold the stopper bolt and turn the

stopper counterclockwise to raise and clockwise to lower.

Reinstall the stopper.

For Vandal-Resistant Installations: Remove the rod nut. While

the stopper is in place, insert the end of the rod through the hole

in the stopper bolt. Secure the rod with the rod nut.

For All Other Installations: Tighten the rod nut to secure the rod.

Identify the best hole in the link to allow full operation of the rod

and the lift rod.

Align the link hole with the rod and slide the clip and the link

onto the rod with the thumbscrew facing the back of the lavatory.

To move the link to the proper position, squeeze the clip and

slide it along the rod.

Align the link with the faucet lift rod and push the lift rod

through the hole in the link. If required, loosen the thumbscrew

on the link.

Verify that the lift rod knob rests on the escutcheon when the

drain is in the full open position.

Tighten the thumbscrew to secure the lift rod position.

3. Supply Connections

If the lavatory is not installed, install it at this time according to

the lavatory manufacturer’s instructions.

Connect the supply hoses to the supply stops. (Left is hot - right

is cold).

Tighten all connections.

4. Installation Checkout

Connect the P-trap.

Make sure all connections are tight.

1048638-2-B 6 Kohler Co.

Installation Checkout (cont.)

Remove the aerator by turning it counterclockwise.

Open the drain.

Turn on the main water supply and check for leaks. Adjust as

needed.

Open both hot and cold valves and run water through the spout

for about a minute to remove debris. Check for leaks.

Close the hot and cold valves.

Remove any debris from the aerator and reinstall.

Kohler Co. 7 1048638-2-B

Guide d’installation

Robinet de lavabo

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de performance. Nos numéros de téléphone

et notre adresse du site internet sont au verso. Merci encore d’avoir

choisi la compagnie Kohler.

Avant de commencer

Respecter tous les codes de plomberie et de bâtiment locaux.

Couper l’alimentation d’eau principale.

Vériﬁer avec soin si les tubes d’évacuation et d’alimentation d’eau

sont endommagés.

Pour de nouvelles installations, installer le robinet et le drain au

lavabo avant d’installer celui-ci.

Kohler Co. se réserve le droit d’apporter toutes modiﬁcations au

design des robinets et ceci sans préavis, comme spéciﬁé dans le

catalogue des prix.

Clé à molette

Mastic de

plombier

Clé

hexagonale

de 1/8"

Kohler Co. Français-1 1048638-2-B

1. Installer le robinet

Assembler le robinet

REMARQUE : Si le robinet est déjà assemblé, continuer à ″Installer

le robinet″.

Retirer le bouchon du corps du robinet et le capuchon du bec.

Jeter le bouchon et le capuchon.

Insérer le bec dans le corps du robinet et le presser fermement

pour engager le joint.

Positionner le bec.

En utilisant les vis de retenue fournies et la clé, sécuriser le bec

au corps du robinet.

Installer le robinet

Nettoyer la surface du lavabo pour éliminer toute graisse, huile

ou débris.

Insérer les tuyaux d’alimentation du robinet et les montants dans

les oriﬁces de montage du lavabo.

Tige de levage

Corps du robinet

Joint

Applique

Flexibles d'alimentation

Écrous de fixation

Montant

Trou de fixation

Capuchon

Bouchon

Vis de retenue

Kohler Co. Français-2 1048638-2-B

Installer le robinet (cont.)

Glisser un écrou de montage sur chaque tuyau d’alimentation et

visser sur les montants.

Serrer à la main les écrous de montage pour sécuriser le robinet à

la surface de montage.

Insérer la tige de levage dans l’oriﬁce de l’applique.

1048638-2-B Français-3 Kohler Co.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler OVE Bedienungsanleitung

Kohler

Kohler Evoke 6332A-4 Bedienungsanleitung

Kohler

Kohler K-7323 Bedienungsanleitung

Kohler

Kohler JULY Series Bedienungsanleitung

Kohler

Kohler K-7397 Bedienungsanleitung

Kohler

Kohler K-2826 Bedienungsanleitung

Kohler

Kohler K-4918 Bedienungsanleitung

Kohler

Kohler Mira Move 8.5 Bedienungsanleitung

Kohler

Kohler Castia K-TS35917-4Y-2MB Bedienungsanleitung

Kohler

Kohler K-13132 Bedienungsanleitung

Kohler

Kohler K-T16237 Bedienungsanleitung

Kohler

Kohler Clearflo K-7147 Bedienungsanleitung

Kohler

Kohler K-6330 Bedienungsanleitung

Kohler

Kohler K-12266 Montageanleitung

Kohler

Kohler K-1110 Kurzanleitung

Kohler

Kohler PURIST Series Bedienungsanleitung

Kohler

Kohler Reve K-5036BR Bedienungsanleitung

Kohler

Kohler Tableau K-14293 Bedienungsanleitung

Kohler

Kohler K-116 Bedienungsanleitung

Kohler

Kohler K-3487 Bedienungsanleitung

Kohler

Kohler K-2268 Bedienungsanleitung

Kohler

Kohler KT6908 Bedienungsanleitung

Kohler

Kohler Wave 72687X-4 Bedienungsanleitung

Kohler

Kohler 72218T-B7-CP Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung