Kramer TBUS-100XL Bedienungsanleitung

P/N: 2900-301554 Rev 1 www.kramerAV.com

USER MANUAL

MODEL:

TBUS-100XL

Table Connection Bus

Kramer Electronics Ltd.

TBUS-100XL –Contents

Contents

Introduction 1

Getting Started 1

Overview 2

TBUS-100XL Table Connection Bus 3

Installing the TBUS-100XL 4

Cutting a Hole in the Table 4

Connecting the Cables 4

Mounting the TBUS-100XL in the Table 6

Using the TBUS-100XL 7

Technical Specifications 8

Kramer Electronics Ltd.

TBUS-100XL –Introduction

Introduction

Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been providing a world

of unique, creative, and affordable solutions to the vast range of problems that confront the

video, audio, presentation, and broadcasting professional on a daily basis. In recent years, we

have redesigned and upgraded most of our line, making the best even better!

Getting Started

We recommend that you:

•Unpack the equipment carefully and save the original box and packaging materials for

possible future shipment.

•Review the contents of this user manual.

Go to www.kramerav.com/downloads/TBUS-100XL to check for up-to-date user manuals,

application programs, and to check if firmware upgrades are available (where appropriate).

Achieving Best Performance

•Use only good quality connection cables (we recommend Kramer high-performance,

high-resolution cables) to avoid interference, deterioration in signal quality due to poor

matching, and elevated noise levels (often associated with low quality cables).

•Do not secure the cables in tight bundles or roll the slack into tight coils.

•Avoid interference from neighboring electrical appliances that may adversely influence

signal quality.

•Position your Kramer TBUS-100XL away from moisture, excessive sunlight and dust.

Safety Instructions

Caution:

•This equipment is to be used only inside a building. It may only be connected to other

equipment that is installed inside a building.

•There are no operator serviceable parts inside the unit.

Kramer Electronics Ltd.

TBUS-100XL –Introduction

Recycling Kramer Products

The Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC aims to reduce

the amount of WEEE sent for disposal to landfill or incineration by requiring it to be collected

and recycled. To comply with the WEEE Directive, Kramer Electronics has made

arrangements with the European Advanced Recycling Network (EARN) and will cover any

costs of treatment, recycling and recovery of waste Kramer Electronics branded equipment on

arrival at the EARN facility. For details of Kramer’s recycling arrangements in your particular

country go to our recycling pages at www.kramerav.com/il/quality/environment.

Overview

Congratulations on purchasing your Kramer TBUS-100XL Table Connection Bus.

The TBUS-100XL is an elegant furniture-mounted connection bus. The TBUS-100XL features

a mechanism for pneumatic lifting and smooth closing of its lid. It is easily installed into a table

or podium top, and its interface enables you to connect any equipment to systems installed in

a room. It has five pass-through openings for cables, located on the lower surface, enabling

closing of the lid while keeping the cables hidden and protected under the surface.

Kramer Electronics Ltd.

TBUS-100XL –TBUS-100XL Table Connection Bus

TBUS-100XL Table Connection Bus

This section defines TBUS-100XL and its connection surface.

Figure 1: TBUS-100XL Table Connection Bus

Figure 2: TBUS-100XL Connecting Surface

Feature

Function

Pneumatic Mechanism

Enables automatic lifting and smooth closing of the lid.

Outer Rim

Fits over the table surface.

Mounting Screws (x2)

For securing TBUS-100XL to the table.

Locking Butterfly Nuts (x2)

Tighten to lock the mounting butterfly screw.

Mounting Butterfly Nuts (x2)

Tighten to secure the unit to the table surface.

Mounting Brackets (x2)

For securing the unit to the table surface.

Black Anodized or Brushed Aluminum

Semi-Automatic Lid (with Opening for

Cable Pass-Through)

Covers the connecting surface, leaving the table surface neat

and tidy.

Lid Latch

For safely closing the lid.

Lock for latch

To secure lid.

Pass-Through Opening and Bushing

(x5)

Insert a cable through the opening and the bushing (inner

diameter approx. 10 mm Ø).

Frame Screws (x8)

For securing and adjusting the height of the frame.

Kramer Electronics Ltd.

TBUS-100XL –Installing the TBUS-100XL

Installing the TBUS-100XL

To install the TBUS-100XL perform the following steps:

1. Cut a hole in the table surface (see Cutting a Hole in the Table on page 4).

2. Connect the cables (see Connecting the Cables on page 4).

3. Secure the unit to the table (see Mounting the TBUS-100XL in the Table on page 6).

Cutting a Hole in the Table

1. Cut a 104mm X 97mm (5.4” to 5.5”) hole in the table in the desired location.

The thickness of the table should be 3”(76mm) or less.

2. Clean the table surface.

Take care not to damage the table. Kramer AV is not responsible for any damage caused to

the table.

Connecting the Cables

You can install the cables either before mounting the TBUS-100XL on a table, or after it is

mounted (usually if the TBUS-100XL is mounted and you need to replace the cables).

To connect the cables:

1. Insert the cables through the

pass-through openings.

Kramer Electronics Ltd.

TBUS-100XL –Installing the TBUS-100XL

2. Insert a cable into an opening

and place the bushing around

the cable.

3. Push the bushing into the pass-

through opening to secure.

Kramer Electronics Ltd.

TBUS-100XL –Installing the TBUS-100XL

Mounting the TBUS-100XL in the Table

To mount the unit:

1. Before mounting the

TBUS-100XL, pass the cables

through the unit. Insert the

TBUS-100XL into the hole cut into

the table making sure the outer

rim is firm against the surface of

the table.

2. From underneath the table, slide

the mounting brackets into the

appropriate slots.

3. Tighten the butterfly mounting

screws securely upward against

the table.

4. Lock the mounting screws into

position with the locking butterfly

screws.

Kramer Electronics Ltd.

TBUS-100XL –Using the TBUS-100XL

Using the TBUS-100XL

Once the TBUS-100XL is installed, you can easily customize it to your own needs by directly

plugging in the required AV equipment, as illustrated in the example in Figure 3.

Figure 3: TBUS-100XL Boardroom Installation

Kramer Electronics Ltd.

TBUS-100XL –Technical Specifications

Technical Specifications

Environmental

Conditions

Operating Temperature

0° to +40°C (32° to 104°F)

Storage Temperature

-40° to +70°C (-40° to 158°F)

Humidity

10% to 90%, RHL non-condensing

Regulatory

Compliance

Safety

CE, UL

Environmental

RoHS, WEEE

General

Net Dimensions (W,D)

15.5cm x 14.6cmm (6.1" x 5.7")

Shipping Dimensions (W, D, H)

27.5cm x 22cm x 19.5cm (10.8" x 8.7" x 7.7")

Net Weight

1.32kg (2.9lbs) approx.

Shipping Weight

1.9kg (4.2lbs) approx.

Specifications are subject to change without notice at www.kramerav.com

Inhaltsverzeichnis

Andere Kramer Kabel und Steckverbinder Handbücher

Kramer

Kramer WP-210A Bedienungsanleitung

Kramer

Kramer WP-209 Bedienungsanleitung

Kramer

Kramer MODULAR TBUS-1Axl Bedienungsanleitung

Kramer

Kramer WP-210E Bedienungsanleitung

Kramer

Kramer TBUS-3 Bedienungsanleitung

Kramer

Kramer KRT-3 Bedienungsanleitung

Kramer

Kramer 612T Bedienungsanleitung

Kramer

Kramer FODPM Bedienungsanleitung

Kramer

Kramer RTBUS-28XL Bedienungsanleitung

Kramer

Kramer CLS-AOCH/60 Series Bedienungsanleitung

Kramer

Kramer UTBUS-1XL Bedienungsanleitung

Kramer

Kramer RTBUS-28XL Bedienungsanleitung

Kramer

Kramer SV-301 Bedienungsanleitung

Kramer

Kramer T6F-09 Bedienungsanleitung

Kramer

Kramer WP-210 Bedienungsanleitung

Kramer

Kramer TBUS-6 Bedienungsanleitung

Kramer

Kramer UTBUS-2XL Bedienungsanleitung

Kramer

Kramer HDBT Bedienungsanleitung

Kramer

Kramer RTBUS-27xl Bedienungsanleitung

Kramer

Kramer WP-230 Bedienungsanleitung

Kramer

Kramer 6010 Bedienungsanleitung

Kramer

Kramer KRT-4-LAN Bedienungsanleitung

Kramer

Kramer RTBUS-24 Bedienungsanleitung

Kramer

Kramer K-Able Box Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung