Mazda 0000-8P-R04 Bedienungsanleitung

GENUINE ACCESSORIES

INSTALLATION INSTRUCTIONS

PART NUMBER

0000-8P-R04

KIT CONTENTS

Installation

Gasket Removal Tool

Push Pin Retainer

Service Part Number

J001-56-741

Alcohol Wipe

Fig. 2

TOOLS REQUIRED

HOOD PROTECTOR APPLICABLE MODEL:

2013 > CX-5

12/29/11 Rev-0Page 1 of 4

Before Installation

1. Read entire installation instruction before beginning.

2. Clean the area around vehicle hood using a mixture of 50/50 isopropyl alcohol and water.

3. It is not recommended to install this accessory over paint protection ﬁlm.

1. Open hood and locate the plastic fasteners to be

removed (Fig. 1). Use the hood protector as a guide

to locate fasteners (4 locations).

2. Using the gasket removal tool, remove the fasteners.

Be careful not to tear the rubber seal (Fig. 1).

3. While holding the rubber seal down, lower the hood

protector onto hood aligning the holes in the tabs of

the hood protector with corresponding holes in the

hood (Fig. 2). Restore the rubber seal once part is

aligned with the holes.

Fig. 1

Protector

12/29/11 Rev-0Page 2 of 4

Installation (Continued)

5. Repeat this step for the remaining 3 holes.

PRESS FIRMLY!!

6. Properly locate the protector and ensure:

a. The protector is seated in contours.

b. The protector is centered side to side.

c. The holes in the protector are aligned with

holes into hood.

7. Close hood.

8. Locate the tape liner ﬂag for the lower (leading)

edge of part. (Fig. 5; Flag 1 in Fig 6) Slowly remove

tape liner along the length of the part. (Fig. 6)

NOTE: For proper installation, the lower leading

edge tape liner MUST be removed ﬁrst!

The leading edge tape liner must be removed

from the back of the part (trailing edge) due to the

mechanical fasteners installed under the hood,

(reference Fig. 3).

4. Using your ﬁngers, insert the supplied Push Retainer

through the rubber seal, protector, and hood (Fig. 3).

Push the fastener ﬁrmly into the hole until it is fully

engaged and sits ﬂush. (Fig. 4).

Fig. 3

Fig. 4

Fig. 5

Sheet Metal

Protector

Fastener

Rubber Seal

Trailing Edge

Leading Edge

End

Fig. 6

12/29/11 Rev-0Page 3 of 4

Installation (Continued)

9. Locate the tape liner ﬂag for the end of part. (Fig. 5;

Flag 2 in Fig. 7) Slowly remove tape liner along the

end of the part. (Fig. 7)

10. Locate the tape liner ﬂag for the upper (trailing)

edge of part. (Fig. 5; Flag 3 in Fig. 8) Slowly remove

tape liner along the length of the part. (Fig. 8)

11. Apply 30 PSI downward pressure for 10 seconds

to all taped areas for proper bond. Tape reaches

maximum bond after 24 hours of contact (Fig. 9).

30 PSI 10 SEC

Fig. 9

Fig. 7

Fig. 8

Use mild soap to clean the hood deﬂector. Do not use ammonia or glass cleaners containing ammonia. This

will damage the surface ﬁnish on the protector.

NOTE: To minimize the potential of color fade between the area of the protector and the rest of the hood,

vehicle should be waxed at least twice per year.

Cleaning Instructions

12. Provide installation instructions to customer.

13. Do not wash car in automatic car wash for 24 hours.

12/29/11 Rev-0Page 4 of 4

Installation (Continued)

Inhaltsverzeichnis

Andere Mazda Autozubehör Handbücher

Mazda

Mazda GENUINE ACCESSORIES Bedienungsanleitung

Mazda

Mazda 0000-8E-R10 Bedienungsanleitung

Mazda

Mazda 0000 8C Z01 Bedienungsanleitung

Mazda

Mazda 0000-8G-L12 Bedienungsanleitung

Mazda

Mazda DC3L-V1-370A Bedienungsanleitung

Mazda

Mazda Connect Bedienungsanleitung

Mazda

Mazda 2005 Miata MX-5 Bedienungsanleitung

Mazda

Mazda CB01-V4-701 Bedienungsanleitung

Mazda

Mazda MVG 4507 F Bedienungsanleitung

Mazda

Mazda CT-L1005 Installationsanleitung

Mazda

Mazda Bluetooth Handsfree System Bedienungsanleitung

Mazda

Mazda 0000-8G-N03 Bedienungsanleitung

Mazda

Mazda 0000 81 L25 Bedienungsanleitung

Mazda

Mazda A2DP Bedienungsanleitung

Mazda

Mazda KMV6V7210 Bedienungsanleitung

Mazda

Mazda CX-9 Bedienungsanleitung

Mazda

Mazda GENUINE SIDE UNDER SPOILER Bedienungsanleitung

Mazda

Mazda TD91 79 CFZ Bedienungsanleitung

Mazda

Mazda Connect Bedienungsanleitung

Mazda

Mazda TD11 V3 460F Leitfaden

Mazda

Mazda PROTEGE 5 Bedienungsanleitung

Mazda

Mazda GS2A -V1-132 Bedienungsanleitung

Mazda

Mazda 0000-8G-K01 Bedienungsanleitung

Mazda

Mazda 0000-89-N01 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung