Metra Electronics 99-3413 Bedienungsanleitung

2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft

nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the shaft supports. Slide the DIN cage into the Radio

Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit

into the cage until secure. (see Fig. B)

(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure.

If an equalizer will NOT be included, snap the Equalizer Dummy Plate into the opening).

ALL VEHICLES

6 7

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

COROLLA: Re-connect the battery terminal and

test the unit for proper operation. Mount the head

unit/kit assembly to the sub-dash with (4) Phillips

screws previously removed in step #1.

PRIZM: Re-connect the battery terminal and test

the unit for proper operation. Mount the head

unit/kit assembly to the sub-dash with (2) Phillips

screws previously removed in step #1 ("A") and

(2) Phillips Screws supplied ("B").

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

99-3413

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

CHEVROLET

Prizm 1998-2003.........................................................1

TOYOTA

Corolla 1998-2002.....................................................2

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Wrench

Phillips screwdriver

Prizm

Spacers

Equalizer

Dummy Plate

(2) Phillips

Screws

Fig. B

"B"

"A"

"B"

Fig. A

KIT FEATURES

Shaft and

DIN unit

provisions

Cupholder

provisions

Equalizer

provisions

Radio Housing

1-800-221-0932 www.metraonline.com

rev. 06-13-07

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the ashtray. Unclip the radio trim bezel and

disconnect the wiring. Remove (4) Phillips

screws se c u r i n g the factory he a d

unit/cupholder assembly, slide the assembly

out and disconnect the wiring.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Unclip

the radio trim bezel (upper dash). Remove

(4) Phillips screws from the factory head

unit, slide the unit out and disconnect the

wiring. Remove the ashtray and unclip the

trim bezel (lower dash). Remove (4) Phillips

screws from the factory pocket/cupholder

assembly and remove the assembly. (Metra

recommends ordering the 88-00-8000 or

88-00-9000 to fill the space left in the upper

dash location).

Locate the faceplate supplied with the

aftermarket head unit. Place the faceplate

into the recessed opening in the Radio

Housing. If the faceplate fits easily into the

opening with no interference, leave the

Housing intact. If the faceplate does NOT fit

easily into the opening, trim away the ribs

located on the top and bottom of the opening

("A").

Locate the faceplate supplied with the

aftermarket head unit. Place the faceplate

into the recessed opening in the Radio

Housing. If the faceplate fits easily into the

opening with no interference, leave the

Housing intact. If the faceplate does NOT fit

easily into the opening, trim away the ribs

located on the top and bottom of the opening

("A").

Convert the Radio Housing by cutting and

removing the pins located under the

equalizer opening ("A"). Trim no less than

1/8" and no more than 1/4" from the bottom

of each upper mounting tab ("B"). Snap the

Prizm Spacers onto the back of the lower

mounting tabs ("C").

Remove the cupholder from the factory head

unit assembly. Slide the cupholder into the

bottom of the Radio Housing until the

locating pins engage the slots in the kit.

(Once the locating pins are engaged, PUSH

the cupholder into the Housing until it stops).

Skip to the Installation Instruction for ALL

VEHICLES on Page #3.

Remove the cupholder from the factory head

unit assembly. Slide the cupholder into the

bottom of the Radio Housing until the

locating pins engage the slots in the kit.

(Once the locating pins are engaged,

maneuver the cupholder until it is flush with

the face of the Housing). Skip to the

Installation Instruction for ALL VEHICLES on

Page #3.

CHEVROLET Prizm 1998-2003 TOYOTA Corolla 1998-2002

1 1

2 2

Locate the v-cut along the top lip of the

Radio Housing. Using the v-cut as a guide,

cut and remove the top portion of the

Housing as indicated above.

"A"

"C"

"A"

"B"

"C"

Inhaltsverzeichnis

Andere Metra Electronics Autozubehör Handbücher

Metra Electronics

Metra Electronics 95-7376B Bedienungsanleitung

Metra Electronics

Metra Electronics 70-5511 Bedienungsanleitung

Metra Electronics

Metra Electronics MPS-GEN01 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-8715 Bedienungsanleitung

Metra Electronics

Metra Electronics 71-6522 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7581 Bedienungsanleitung

Metra Electronics

Metra Electronics 82-3043 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7477 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-3411 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-5808 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-3305 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-9615B Bedienungsanleitung

Metra Electronics

Metra Electronics 95-7418 Bedienungsanleitung

Metra Electronics

Metra Electronics AW-333GM Bedienungsanleitung

Metra Electronics

Metra Electronics 95-6549 Bedienungsanleitung

Metra Electronics

Metra Electronics AW-PW22 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-7325 Bedienungsanleitung

Metra Electronics

Metra Electronics 70-6522 Bedienungsanleitung

Metra Electronics

Metra Electronics 95-9403B Bedienungsanleitung

Metra Electronics

Metra Electronics 95-5818 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7504 Bedienungsanleitung

Metra Electronics

Metra Electronics CADILLAC 95-2004 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-9000 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-7863 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung