MikroTik RouterBOARD Groove 52HPn Bedienungsanleitung

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions.

7-Dec-2012

RouterBOARD Groove52HPn&

Quick Setup Guide and Warranty Information

The RouterBOARD Groove comes preinstalled in an outdoor case, with a built‐in wireless interface, an N-

Male antenna connector, and one 10/100 Ethernet connector which supports MDI-X auto detection. The

device is packaged with a 24V power adapter, a PoE injector and two mounting loops. Several models

are available (dual band, single band, AP and CPE variants).

First use

1. Connect the antenna to the N-Male connector

2. Twist to open the Groove case, connect an Ethernet cable to the Ethernet port

3. Use the provided rubber insulator to put on the Ethernet cable, and push it into the case

opening, so that the opening is tightly closed

4. The Groove accepts 8-30V Passive PoE from a PoE injector

5.The default IP address from Ether1 is 192.168.88.1 for configuration

Username is admin and there is no password

6. Depending on the antenna used, you must set it’s gain in the RouterOS software to ensure

that EIRP meets the limit set by authorities. This is done in the Wireless menu.

Powering

The board accepts powering from the Ethernet port (Passive PoE):

•Ethernet port accepts passive Power over Ethernet 8-30V DC. Package contains a 24V

adapter and a PoE injector.

Maximum power consumption of the device is 4W.

Booting process

Initial connection has to be done via the Ethernet cable. Open 192.168.88.1 in your web browser, and choose “Webfig” for

browser based configuration or “Winbox” for a Windows utility with the same functions. Username is admin and there is no

password. In case IP connection is not available, Winbox can be used to connect to the MAC address of the device. More

information here: http://wiki.mikrotik.com/wiki/First_time_startup

In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the

device when starting it until the LED light turns off, and Metal will start to look for Netinstall servers.

Mounting

The Groove is to be mounted vertically, so that the Ethernet cable points downwards.

If you wish to tighten the Groove to a pole, you can do it with the provided mounting loops. The Groove comes bundled with two

mounting loops - guide the loops around the Groove though the provided edge markings, and around the pole where it will be

mounted. You should avoid connecting a loose Ethernet cable to the Ethernet port, secure the cable to a wall or the pole, so that

the cable weight is not pulling the port. It is recommended to secure the Ethernet cable less than 2m from the Groove device.

This is to ensure that the cable doesn't damage the port by it's weight, or doesn't fall out.

Expansion Slots and Ports

•Built in 5GHz or 2GHz (or both) wireless device (depends on model), 1x1 MIMO

GrooveA-52HPn

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions.

7-Dec-2012

•

10/100

Ethernet

port,

supportin

automatic

cross/straight

cabl

correction

(Auto

MDI/X),

you

can

either

straight

cross

over

cable

for

connecting

other

network

devices.

The

Ethernet

port

accepts

30V

powering

from

passive

PoE

injector.

Buttons and

Jumpers

•

RouterOS

reset

jumper

hole (no direct access, board has removed from case) –resets RouterOS software to

defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold

screwdriver in place until RouterOS configuration is cleared.

•RouterBOOT reset button (access through the plastic door) has two functions:

o Hold this button during boot time until LED light starts flashing,

release the button to reset RouterOS configuration (same result as with reset hole)

o Hold this button during boot time longer, until LED turns off,

then release it to make the device look for Netinstall servers.

Operating System

Support

Currently tested operating system is MikroTik RouterOS (starting from version v5.0).

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere MikroTik Drahtloser Zugangspunkt Handbücher

MikroTik

MikroTik DynaDish 6 Bedienungsanleitung

MikroTik

MikroTik RBcAPL-2nD Bedienungsanleitung

MikroTik

MikroTik RouterBOARD OmniTik 5HnD Bedienungsanleitung

MikroTik

MikroTik wAP ac RBwAPG-5HacD2HnD Bedienungsanleitung

MikroTik

MikroTik RBGrooveGA-52HPacn Bedienungsanleitung

MikroTik

MikroTik Audience Bedienungsanleitung

MikroTik

MikroTik RouterBOARD wAP R Bedienungsanleitung

MikroTik

MikroTik RouterBOARD 911 Series Bedienungsanleitung

MikroTik

MikroTik LtAP LR8 LTE kit Bedienungsanleitung

MikroTik

MikroTik RBcAPGi-5acD2nD-XL Bedienungsanleitung

MikroTik

MikroTik Wireless Wire Cube Bedienungsanleitung

MikroTik

MikroTik RouterBOARD SXT G-5HnD Bedienungsanleitung

MikroTik

MikroTik PWR-LINE AP Bedienungsanleitung

MikroTik

MikroTik SXT 6 Bedienungsanleitung

MikroTik

MikroTik SXTG-5HPacD Bedienungsanleitung

MikroTik

MikroTik NetMetal 5 Series Bedienungsanleitung

MikroTik

MikroTik wAP 60G Bedienungsanleitung

MikroTik

MikroTik LHG Series Bedienungsanleitung

MikroTik

MikroTik LDF 5 Bedienungsanleitung

MikroTik

MikroTik cAP ax Bedienungsanleitung

MikroTik

MikroTik RBSXTsq5nD Bedienungsanleitung

MikroTik

MikroTik NetMetal 5 triple Bedienungsanleitung

MikroTik

MikroTik RouterBOARD SXT 5HnD Bedienungsanleitung

MikroTik

MikroTik Cube 60G Series Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung