Olympus U-LGPS Bedienungsanleitung

Instructions

This instruction manual is for the Olympus LED and LDP Light Source.

To ensure safety, obtain optimum performance and to familiarize yourself fully with the use of this

product, we recommend that you study this manual thoroughly before operating this product, and

always keep this manual at hand when operating this product.

Retain this instruction manual in an easily accessible place near the work desk for future reference.

For details of products covered by this instruction manual, see page 10.

LED and LDP Light Source

U-LGPS

Optical Microscope Accessory

This product is applied with the requirements of standard IEC/EN61326-1 concerning

electromagnetic compatibility.

- Immunity Applied to industrial and basic environment requirements.

For Korea only

이� 기기는� 업무용� 환경에서� 사용할� 목적으로� 적합성평가를� 받은� 기기로서

가정용�환경에서�사용하는�경우�전파간섭의�우려가�있습니다.

For Korea only

이� 기기는� 업무용� 환경에서� 사용할� 목적으로� 적합성평가를� 받은� 기기로서

가정용�환경에서�사용하는�경우�전파간섭의�우려가�있습니다.

In accordance with European Directive on Waste Electrical and Electronic Equipment, this

symbol indicates that the product must not be disposed of as unsorted municipal waste, but

should be collected separately.

Refer to your local Olympus distributor in EU for return and/or collection systems available in

your country.

Research, Industrial, and In vitro diagnostic medical use Products

This product is categorized as FCC Part15 Class A exempt device. Using this product may affect other

equipment in the environment. The operator of this exempted product shall be required to stop operating

the product upon a finding by the Commission or its representative that the product is causing harmful

interference. Operation shall not resume until the condition causing the harmful interference has been

corrected.

U-LGPS

Concept of this instruction manual............................................................................................. 1

Product Concept.......................................................................................................................................... 2

Safety precautions...................................................................................................................................... 3

Handling precautions............................................................................................................................... 7

List of combinable systems ............................................................................................................... 8

Maintenance and Storage................................................................................................................... 9

1 Nomenclature of main operating portions.....................................................................10

2 Operating Procedures......................................................................................................................11

1Turning ON the lamp............................................................................................................................................................... 11

2Turning OFF the lamp............................................................................................................................................................. 11

3Adjusting the brightness...................................................................................................................................................... 12

4Pilot lamp color and counter display........................................................................................................................12

3 Troubleshooting.....................................................................................................................................13

4 Specifications...........................................................................................................................................14

5 Assembly......................................................................................................................................................15

1Attaching U-LLG150/U-LLG300......................................................................................................................................15

2Attaching the power cord................................................................................................................................................... 16

3Connecting the USB cable................................................................................................................................................16

4Replacing the fuse.................................................................................................................................................................... 17

Contents

U-LGPS

Concept of this instruction manual

Applicable user of this instruction manual

This instruction manual applies to users who use this product according to "Intended use" and Olympus distributors.

This instruction manual describes only the contents related to U-LGPS(LED and LDP light source).

When using this product, read all the instruction manuals supplied with the units you purchased together with this

manual.

GX53

を登りながら

6-1 OOOOOOOOOO

OOOOOOOO

OOOOOOOOOO

OOOOOOOOOOOOOOOOOOOOOOOOOOOOO

OOOOOOOOOOOOOOOOOOOOO

This instruction manual is created as follows.

How to read this instruction manual

Title in second layer

OOOOOOOOOOOOOOOOOOOOOOOOOOOOO

Title in third layer

Title in first layer

1, 2... indicates the operating

procedure and A, B... indicates

the portion you operate.

Operating procedure

The following symbols are used in this instruction manual.

WARNING : Indicates a potentially hazardous situation which, if not avoided, could result in

death or serious injury.

CAUTION : Indicates a potentially hazardous situation which, if not avoided, may result in

minor or moderate injury.

NOTE

: Indicates a potentially hazardous situation which, if not avoided, may result in

damage to the product or other property and/or may cause problems.

TIP

: Indicates the useful knowledge or information for use.

Cautions and references

Loosen the

clamping screw

using

the screwdriver.

Remove the

unit

TIP

NOTE

CAUTION

Loosen the

clamping screw

using

the screwdriver.

Remove the

unit

OOOOOOOOOOOOOOOOOOOOO

TIP

NOTE

CAUTION

Product outline

U-LGPS (LED and LDP Light Source) is a light source used for observing a sample in combination with the microscope.

Product Concept

Cautions and confirmation before use

This product includes the following items. If any item is missing or damaged, contact Olympus.

· U-LGPS

· USB cable

· Instruction manual for U-LGPS (this instruction manual)

This product is used for research, industrial and in vitro diagnostic medical purposes in combination with microscopes.

For details, refer to the instruction manual for the microscope system to be combined.

Intended Use

U-LGPS

Safety precautions

If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the

product may also be damaged. Always use the product according to this instruction manual.

Installation

Laser safety

Secure the space of 5 cm or more around the product.

Otherwise, the ventilation route is not secured and the heat is filled inside the product, which may cause a

fire.

WARNING

Install the product on a sturdy, level table or bench.

For safety in particular, do not place a mat, etc. under the product. Otherwise, the product may overturn.

CAUTION

·Never peel off the warning label.

CAUTION

Warning label position: Right side surface of U-LGPS

This product is specified as CLASS 1 laser product.

This product complies with 21 CFR 1040.10 and 1040.11 except for conformance with

IEC 60825-1 Ed. 3., as described in Laser Notice No. 56, dated May 8,2019.

CLASS 1 LASER PRODUCT (IEC60825-1:2007 / IEC60825-1:2014)

·Do not remove the cover.

It is very dangerous because the laser beam equivalent to CLASS 4 is emitted. And the product may also be

damaged.

This product uses the fluorescence of the phosphor excited by the laser beam emitted from the LD bank as

the illumination light.

Specifications of LD bank:

· Dominant wavelength: 455±5 nm

· Output: 36 W

TIP

Electric safety

·Always use the power cord provided by Olympus.

If the proper power cord is not used, our intended electric safety and the EMC (Electromagnetic Compatibility)

performance of the product cannot be assured. If no power cord is provided, please select the proper power

CAUTION

·Always connect the ground terminal.

Connect the ground terminal of the power cord and that of the power outlet.

If the product is not grounded, our intended electric safety and EMC performance of the product cannot be

assured.

·Do not use the product in close proximity to the sources of strong electromagnetic radiation.

Proper operation may be interfered. The electromagnetic environment should be evaluated prior to operation

of the product.

·If you feel smoke, odor, abnormal sound or abnormal output, etc., stop using the product immediately.

·Disconnect the power cord in case of emergency.

In case of emergency, disconnect the power cord from the power cord connector on the product or from the

power outlet.

Install the product at the location where you can reach the power cord connector or the power outlet at hand

to disconnect the power cord quickly.

·Do not connect or disconnect the power cord, cables and units while the power is on.

·Always use the USB cable provided by Olympus.

If you connect the USB cable that is not provided by Olympus, U-LGPS may not work properly.

Prevention of electric shock

·Never disassemble any part of this product.

It could cause electric shock or failure of the product.

·Be sure to turn OFF the main power of the product and then disconnect the power cord from the

power cord connector on the product or from the power outlet before performing maintenance,

storage or transportation.

It could cause electric shock or failure of the product.

·Do not allow any foreign substance into the product.

In particular, if any metal fragment or similar enters the product, electric shock or failure of the product may be

caused.

·Do not touch the product with wet hands.

In particular, if you touch the main switch of the power unit or the power cord with wet hands, electric shock,

ignition or failure of the product may be caused.

·When you hear thunder, never touch the product until thunder stops.

In particular, if you touch the main switch of the power unit or the power cord, an electric shock may be

caused.

·Do not bend, pull or tie the power cord/cables in a bundle.

The cord/cables could be damaged, causing a fire or an electric shock.

·Disconnect the power cord from the product when replacing the fuses.

To avoid electric shock hazards when replacing the fuses, set the main switch of U-LGPS to ( (OFF) and

disconnect the power cord from the product in advance.

WARNING

If no power cord is provided, please select the proper power cord by referring to the section “Proper selection

of the power cord” at the end of this instruction manual.

U-LGPS

Prevention of eye injury

Do not look directly at the light coming out from U-LGPS.

U-LGPS is categorized as Risk Group 3 defined in IEC62471-1 “Photobiological Safety of Lamps and Lamp

Systems”.

Possibly hazardous optical radiation emitted from this product.

Do not stare at operating lamp. May be harmful to eyes.

Be careful for the possibly hazardous optical radiation emitted from this product and the system with which

this product is combined (see page 8).

Do not stare at the emitted light. It may be harmful to eyes.

The light of invisible wavelengths (such as ultraviolet or infrared) may be emitted depending on the

illumination methods.

CAUTION

Remove the liquid light guide after the liquid light guide and the LDP light source are fully cooled

down.

Otherwise, you may get burned.

CAUTION

Liquid Light Guide

·Do not use the liquid light guide that is not conformed to this product.

You may get burned or your eyes may be damaged. For the liquid light guide that is conformed to this

product, see page 14.

·Do not remove the liquid light guide when the lamp is turned ON.

The light emitted from U-LGPS may cause a fire. In addition, you may get burned or your eyes may be

damaged.

WARNING

Software

If the application software (U-LGPS control software) that controls U-LGPS by connecting USB is hung

up, set the power switch of U-LGPS to (OFF).

The continuous emission from U-LGPS may not only damage the product but also may cause a fire.

WARNING

The following symbols are placed on the product.

Study the meaning of the symbols and always use the product in the safest possible manner.

Symbol Meaning

Indicates a non-specific general hazard. Follow the description given after this symbol or

in the instruction manual.

Indicates that the surface becomes hot. Do not touch with bare hands. You may get

burned.

Indicates that the seesaw type main switch is ON.

(Seesaw type is the type of switch where ON or OFF is selected by pressing it to ON or

OFF side.)

Indicates that the seesaw type main switch is OFF.

If caution labels are dirty or peeled off, contact Olympus for replacement or inquiries.

Safety warning symbols

Label position and instruction

The labels are attached to the portions which require special cautions during use and operation. Be sure to follow these

instructions.

Label Label position Instructions in instruction manual Page

Back of U-LGPS Caution for electric safety and

prevention of electric shock 4

U-LGPS liquid light guide insertion port High temperature 5

If caution labels are dirty or peeled off, contact Olympus for replacement or inquiries.

Inhaltsverzeichnis

Andere Olympus Mikroskop Handbücher

Olympus

Olympus DP21-SAL Benutzerhandbuch

Olympus

Olympus DSX510 Bedienungsanleitung

Olympus

Olympus FH Bedienungsanleitung

Olympus

Olympus SZ-ADD Bedienungsanleitung

Olympus

Olympus BX-URA2 Bedienungsanleitung

Olympus

Olympus BX53-P Bedienungsanleitung

Olympus

Olympus U-MDOB3 Bedienungsanleitung

Olympus

Olympus BX53 Bedienungsanleitung

Olympus

Olympus bx40 Bedienungsanleitung

Olympus

Olympus CX40 Bedienungsanleitung

Olympus

Olympus DP22 Bedienungsanleitung

Olympus

Olympus SZX2-LTTR Bedienungsanleitung

Olympus

Olympus IX70 Bedienungsanleitung

Olympus

Olympus BX41 Bedienungsanleitung

Olympus

Olympus IX73 Bedienungsanleitung

Olympus

Olympus FV3000 Bedienungsanleitung

Olympus

Olympus BH2 Series Bedienungsanleitung

Olympus

Olympus DP21 Bedienungsanleitung

Olympus

Olympus BX3-SSU Bedienungsanleitung

Olympus

Olympus BX61WI Bedienungsanleitung

Olympus

Olympus IX2-RFSPOT Bedienungsanleitung

Olympus

Olympus Fluoview FV1000 Handbuch

Olympus

Olympus BHTP Bedienungsanleitung

Olympus

Olympus BX-RFAA Bedienungsanleitung

Beliebte Mikroskop Handbücher anderer Marken

Thermo Scientific

Thermo Scientific Nicolet iN10 Leitfaden

National

National DC3-163 Bedienungsanleitung

KERN Optics

KERN Optics OPE-1 Bedienungsanleitung

OPTIKA MICROSCOPES

OPTIKA MICROSCOPES B-150D Bedienungsanleitung

Prior

Prior Lux POL Bedienungsanleitung

Opitec

Opitec Smartscoop 115615 Bedienungsanleitung

KERN

KERN OPO-1 Bedienungsanleitung

Topcon

Topcon SP-1P Bedienungsanleitung

Motic

Motic PA43 Bedienungsanleitung

Leica

Leica DVM5000 Benutzerhandbuch

MshOt

MshOt MZ62 Bedienungsanleitung

KERN Optics

KERN Optics OZR-5 Bedienungsanleitung

VWR

VWR VisiScope 384 Series Bedienungsanleitung

Nikon

Nikon ECLIPSE E200 POL Bedienungsanleitung

Leica

Leica DI C800 Handbuch

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Bedienungsanleitung

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Bedienungsanleitung

Leica

Leica FL560 Bedienungsanleitung