Panasonic Photo IC PNA4601M Bedienungsanleitung

SHE00064AEK

This product complies with the RoHS Directive (EU 2002/95/EC).

Publication date: October 2008 1

Photo IC

PNA4601M

Photodiode with Photodetection Function

For infrared remote control systems

Features

Extension distance: 8 m or more

External parts not required

Adoption of visible light cutoff resin

Absolute Maximum Ratings Ta= 25°C

Parameter Symbol Rating Unit

Operating supply voltage VCC – 0.5 to +7 V

Power dissipation PD200 mW

Operating ambient temperature Topr –20 to +75 °C

Storage temperature Tstg –40 to +100 °C

Soldering temperature *Tsol 260 °C

Note) *: Less than 5 s

Electrical-Optical Characteristics Ta= 25°C±3°C

Parameter Symbol Conditions Min Typ Max Unit

Operating supply voltage VCC 4.7 5.0 5.3 V

Supply current ICC No signal condition 1.8 2.4 3.0 mA

Maximum reception distance *1Lmax 8.0 10.0 m

Low level output voltage *2VOL L ≤8.0 m, IOL = 400 μA 0.35 0.5 V

High level output voltage VOH No signal condition, IOH = −10 μA 4.75 4.80 V

Low level pulse width *1TWL1 L = 8.0 m, 16 pulse 200 400 600 μs

TWL2 L = 0.2 m, 16 pulse, Ta= 65°C ± 3°C 100 700 μs

High level pulse width *1TWH L = 8.0 m, 16 pulse 200 400 600 μs

Center frequency fO36.7 kHz

Load resistance RL15 20 25 kW

Note) 1. Measuring methods are based on JAPANESE INDUSTRIAL STANDARD JIS C 7031 measuring methods for diodes.

2. *1:Burst wave form ﬁgure 1.

*2:Constant wave form Figure 2..

400 µs400 µs 20 ms

Carrier frequency: fOCarrier frequency: fO

Figure 2Figure 1

SHE00064AEK

This product complies with the RoHS Directive (EU 2002/95/EC).

PNA4601M

Block Diagram

GND

AGC

VCC

Peak hold

Constant voltage

Comparator

(20 kΩ)

Integrator

BPF DemodulatorAmplifier

Panasonic Transmitter Speciﬁcations

GND

10 V

PNZ323B

20 cm

10 kΩ

10 µF

VO55 mV

LED transmitter unit Standard receiver unit

1.The output of the LED transmitter unit is adjusted so that the output standard receiver unit, VOmay be 55 mV when transmitting waves

(duty = 50%) are output from the transmitter unit, where the sensitivity to infrared emitters (SIR) of PNZ323B is 0.53 μA when the

irradiance H is 12.45 μW/cm2.

2.The maximum detection distance of this speciﬁcation is guaranteed by TWH and TWL being within the limits when constant 16 pulses are

transmitted with the output of the transmitter unit corresponded to the maximum detection distance in the system above. (The maximum

detection distance is measured in the darkness without disturbing noises.)

SHE00064AEK

This product complies with the RoHS Directive (EU 2002/95/EC).

PNA4601M

Ambient temperature Ta(°C)

Relative reception distance

∆

Lmax (%)

120

100

00 20 40 60 80 100

−20

VCC =5 V

Transmitter: Standard LED

Transmission unit used

0°10°20°

30°

40°

50°

60°

70°

80°

90°

Note:

The peak is fO.

100

Relative sensitivity ∆S (%)

Carrier frequency (kHz)

Relative sensitivity ∆S (%)

100

35 39 434137

033

100

Wavelength λ(nm)

Relative sensitivity ∆S (%)

700 900 1

200800 1

000 1

100

600

∆

Lmax Ta

∆

S Carrier frequency

∆

S 

Directive characteristics

SHE00064AEK

This product complies with the RoHS Directive (EU 2002/95/EC).

PNA4601M

Package (Unit: mm)

LPTLSN3S0001

Pin name

1: VO

2: GND

3: VCC

Request for your special attention and precautions in using the technical information and

semiconductors described in this book

(1)If any of the products or technical information described in this book is to be exported or provided to non-residents, the laws and

regulations of the exporting country, especially, those with regard to security export control, must be observed.

(2)The technical information described in this book is intended only to show the main characteristics and application circuit examples

of the products. No license is granted in and to any intellectual property right or other right owned by Panasonic Corporation or any

other company. Therefore, no responsibility is assumed by our company as to the infringement upon any such right owned by any

other company which may arise as a result of the use of technical information described in this book.

(3)The products described in this book are intended to be used for standard applications or general electronic equipment (such as office

equipment, communications equipment, measuring instruments and household appliances).

Consult our sales staff in advance for information on the following applications:

–Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support

systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the prod-

ucts may directly jeopardize life or harm the human body.

–Any applications other than the standard applications intended.

(4)The products and product specifications described in this book are subject to change without notice for modification and/or im-

provement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product

Standards in advance to make sure that the latest specifications satisfy your requirements.

(5)When designing your equipment, comply with the range of absolute maximum rating and the guaranteed operating conditions

(operating power supply voltage and operating environment etc.). Especially, please be careful not to exceed the range of absolute

maximum rating on the transient state, such as power-on, power-off and mode-switching. Otherwise, we will not be liable for any

defect which may arise later in your equipment.

 Even when the products are used within the guaranteed values, take into the consideration of incidence of break down and failure

mode, possible to occur to semiconductor products. Measures on the systems such as redundant design, arresting the spread of fire

or preventing glitch are recommended in order to prevent physical injury, fire, social damages, for example, by using the products.

(6)Comply with the instructions for use in order to prevent breakdown and characteristics change due to external factors (ESD, EOS,

thermal stress and mechanical stress) at the time of handling, mounting or at customer's process. When using products for which

damp-proof packing is required, satisfy the conditions, such as shelf life and the elapsed time since first opening the packages.

(7)This book may be not reprinted or reproduced whether wholly or partially, without the prior written permission of our company.

20080805

Inhaltsverzeichnis

Andere Panasonic Netzwerk-Hardware Handbücher

Panasonic

Panasonic Transistors 2SC5846 Bedienungsanleitung

Panasonic

Panasonic Transistors 2SB1218G Bedienungsanleitung

Panasonic

Panasonic Zener Diodes MAZSxxx Series Bedienungsanleitung

Panasonic

Panasonic BB-HCS301A - Network Camera Server Betriebsanleitung

Panasonic

Panasonic Multi Chip Discrete UP05C8GF Bedienungsanleitung

Panasonic

Panasonic WJ-PB85Y08 Bedienungsanleitung

Panasonic

Panasonic GA-ML Series Bedienungsanleitung

Panasonic

Panasonic Switching Diodes MA2S101 Bedienungsanleitung

Panasonic

Panasonic EZADT series Bedienungsanleitung

Panasonic

Panasonic Transistors 2SB1722G Bedienungsanleitung

Panasonic

Panasonic KX-HTS Series Bedienungsanleitung

Panasonic

Panasonic WJ-NXF02 Bedienungsanleitung

Panasonic

Panasonic Schottky Barrier Diodes MA2SD31 Bedienungsanleitung

Panasonic

Panasonic Transistors 2SD1819G Bedienungsanleitung

Panasonic

Panasonic Zener Diodes MALS068X Bedienungsanleitung

Panasonic

Panasonic Schottky Barrier Diodes MA2SE01 Bedienungsanleitung

Panasonic

Panasonic WJ-NV200K Bedienungsanleitung

Panasonic

Panasonic Transistors 2SC3931 Bedienungsanleitung

Panasonic

Panasonic Schottky Barrier Diodes MA6J786Y Bedienungsanleitung

Panasonic

Panasonic Transistors 2SC4562G Bedienungsanleitung

Panasonic

Panasonic Switching Diodes MA2Z001 Bedienungsanleitung

Panasonic

Panasonic Transistors 2SC3930G Bedienungsanleitung

Panasonic

Panasonic Chip RC Networks EZACT Benutzerhandbuch

Panasonic

Panasonic Schottky Barrier Diodes MA3X716 (MA716) Bedienungsanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Lanner

Lanner NCA-1525 Bedienungsanleitung