Pickering PXI 41-181 Bedienungsanleitung
Page 1
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
USER MANUAL
2.3GHz PROGRAMMABLE STEP ATTENUATOR MODULE
(MODEL No. 41-181)
Issue E July 2012
www.pickeringtest.com
pickering
ISO 9002
Reg No. FM38792
NOTE: Provided for information only.
Use 41-180 for all new requirements.
Page ii
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
© COPYRIGHT (2012) PICKERING INTERFACES. ALL RIGHTS RESERVED.
No part of this publication may be reproduced, transmitted, transcribed, translated or stored in any form, or
by any means without the written permission of Pickering Interfaces.
Technical details contained within this publication are subject to change without notice.
Page iii
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
TECHNICAL SUPPORT
For Technical Support please contact Pickering Interfaces either by phone, fax, the website or via e-mail.
WARRANTY
All products manufactured by Pickering Interfaces are warranted against defective materials and workmanship for a
period of two years, excluding PXI chassis, from the date of delivery to the original purchaser. Any product found to be
defective within this period will, at the discretion of Pickering Interfaces be repaired or replaced.
Products serviced and repaired outside of the warranty period are warranted for ninety days.
Extended warranty and service are available. Please contact Pickering Interfaces by phone, fax, the website or via
e-mail.
ENVIRONMENTAL POLICY
Pickering Interfaces operates under an environmental management system similar to ISO 14001.
Pickering Interfaces strives to full all relevant environmental laws and regulations and reduce wastes and releases
to the environment. Pickering Interfaces aims to design and operate products in a way that protects the environment
and the health and safety of its employees, customers and the public. Pickering Interfaces endeavours to develop
and manufacture products that can be produced, distributed, used and recycled, or disposed of, in a safe and
environmentally friendly manner.
Observe the Electrostatic Sensitive Device Caution detailed in Section 8.
Worldwide Technical Support and Product Information
http://www.pickeringtest.com
Pickering Interfaces Headquarters
Stephenson Road Clacton-on-Sea CO15 4NL United Kingdom
Tel: +44 (0)1255-687900
Fax: +44 (0)1255-475058
E-Mail: [email protected]
Pickering Interfaces GmbH
Johann-Karg-Straße 30
D-85540
Haar-Salmdorf
Germany
Tel: +49 89 125 953 160
Fax: +49 89 125 953 189
E-Mail: [email protected]
Pickering Interfaces AB
Karl Nordströmsväg 31
432 53
Varberg
Sweden
Tel: +46 340-69 06 69
Fax: +46 340-69 06 68
E-Mail: [email protected]
Pickering Interfaces Inc.
2900 Northwest Vine Street
Grants Pass
Oregon 97526
USA
Tel: +1 541 471 0700
Fax: +1 541 471 8828
E-Mail: [email protected]
Pickering Interfaces Inc.
(East Coast Regional Office)
12 Alfred Street Suite 300-3
Woburn Massachusetts 01801
USA
Tel: +1 781 897 1710
Fax: +1 781 897 1701
E-mail: [email protected]
Pickering Interfaces s.r.o.
Smetanova 525
Trinec
739 61
Czech Republic
Tel: +42 0558 339 168
Fax: +42 0558 340 888
E-mail: [email protected]
ˇ
Pickering Interfaces SARL
6 Rue De La Mare Blanche
77186 Noisiel
Marne Le Vallee
France
Tel +33 1 60 53 55 50
Fax +33 1 60 53 55 99
email [email protected]
Page iv
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
THIS PAGE INTENTIONALLY BLANK
Page v
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
Copyright Statement .......................................................... ii
Technical Support and Warranty....................................... iii
Contents (this page)........................................................... v
Section 1
Introduction......................................................................... 1.1
Section 2
Technical Specication...................................................... 2.1
Section 3
Installation........................................................................... 3.1
Section 4
Programming ...................................................................... 4.1
Section 5
Connector Pin Outs............................................................ 5.1
Section 6
Troubleshooting ................................................................. 6.1
Section 7
General Description ........................................................... 7.1
Section 8
Warnings and Cautions ..................................................... 8.1
CONTENTS
Page vi
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
THIS PAGE INTENTIONALLY BLANK
Section 1 - introduction
Page 1.1
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
SECTION 1 - INTRODUCTION
GENERAL
The 41-181 Programmable 0 to 63 dB Attenuator Module which forms part of the System 40 PXI RF Instrumentation
range comprises either one or two independently programmable attenuators in a single width 3U PXI module. Each
attenuator comprises seven attenuator pads ranging in value from 1 dB to 16dB. A combination of attenuator pads
are mechanically switched-in to provide attenuation values from 0 to 63 dB in 1 dB steps.
The module is provided in the following versions:
•41-181-021 Single Attenuator, 63 dB range, 1dB Step, 0Mhz to 2.3Ghz 50 Ohm SMA Connector.
•41-181-022 Dual Attenuator, 63 dB range, 1dB Step, 0Mhz to 2.3Ghz 50 Ohm SMA Connector.
Page 1.2
Section 1 - introduction
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
THIS PAGE INTENTIONALLY BLANK
Section 2 - SPeciFicAtion
Page 2.1
2.3GHz ProGrammable SteP attenuator module 41-181
pickering
SECTION 2 - SPECIFICATION
GENERAL CHARACTERISTICS
Frequency range: DC to 2.3 GHz
Maximum Input Power: 1 Watt continuous
Input Impedance: 50 ohms, DC coupled
VSWR (SMA connector): Less than 1.5, Typically less than 1.3
Typical Crosstalk Versus Frequency With No Attenuation Set
ATTENUATION
The attenuator is made up 1, 2, 4, 8 and 16 (3 off) switched pads, attenuator set to 0 dB with no power applied.
Insertion Loss (0 dB set): Typically 3.6 dB at 2.3 GHz
Attenuation Range: 0 to 63 dB in 1 dB steps relative to 0 dB condition
Attenuation Accuracy (individual pads measured in 50 ohm system referenced to 0 dB condition):
Attenuator Pad DC to 1 GHz at 3 GHz
1 dB ±0.05 dB ±0.15 dB
2 dB ±0.05 dB ±0.1 dB
4 dB ±0.2 dB ±0.25 dB
8 dB ±0.15 dB ±0.3 dB
16 dB ±0.2 dB ±0.65 dB
Page 2.2
Section 2 - SPeciFicAtion
2.3GHz ProGrAmmAble SteP AttenuAtor module 41-181
pickering
Typical Insertion Loss Versus Frequency (0 dB Set)
Attenuation accuracy versus frequency, 8 dB set.
Inhaltsverzeichnis
Andere Pickering Steuereinheit Handbücher
Pickering
Pickering 40-870 Bedienungsanleitung
Pickering
Pickering PXI 40-664A Bedienungsanleitung
Pickering
Pickering Pxi 41-660 Bedienungsanleitung
Pickering
Pickering 41-760 Bedienungsanleitung
Pickering
Pickering SYSTEM 10 Bedienungsanleitung
Pickering
Pickering 40-580 Bedienungsanleitung
Pickering
Pickering PXI BRIC 40-595A Bedienungsanleitung
Pickering
Pickering 45-542 Bedienungsanleitung
Pickering
Pickering 40-727 Bedienungsanleitung
Pickering
Pickering SYSTEM 10 Bedienungsanleitung
Pickering
Pickering 40-528A Bedienungsanleitung
Pickering
Pickering 40-527A Bedienungsanleitung
Pickering
Pickering 41-765 Bedienungsanleitung
Pickering
Pickering 40-884A Bedienungsanleitung
Pickering
Pickering PXI 40-145 Bedienungsanleitung
Pickering
Pickering 40-170 Bedienungsanleitung
Pickering
Pickering 40-519A Bedienungsanleitung
Pickering
Pickering 40-331 Bedienungsanleitung
Pickering
Pickering 40-581 Bedienungsanleitung
Pickering
Pickering 40-534 Bedienungsanleitung
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
