ResMed Mirage Activa LT Bedienungsanleitung

Mirage Activa™ LT

nasal mask

User Guide

English • Français • Español • Português

English

Mirage Activa™ LT

nasal mask

Thank you for choosing the Mirage Activa™ LT.

Intended Use

The Mirage Activa LT channels airﬂow noninvasively to a patient from a positive

airway pressure device such as a continuous positive airway pressure (CPAP)

or bilevel system.

The Mirage Activa LT is:

to be used by adult patients (>66 lb/30 kg) for whom positive airway

•

pressure has been prescribed

intended for single-patient re-use in the home and multipatient re-use in

•

the hospital/institutional environment.

Device Setting

Select ‘Activa’ (if available) or ‘Standard’ as the mask option when using the

Mirage Activa LT with ResMed devices that have mask setting options.

For a full list of compatible devices for this mask, see the Mask/Device

Compatibility List on www.resmed.com on the Products page under Service

& Support. If you do not have internet access, please contact your ResMed

representative.

Rx Only

Parts of the Mask & Ordering Information

Forehead

support pad

60123 (1)

60124 (10)

Upper straps

Lower straps

*S Small

#St Standard

Forehead support

16393

Dial

61289

Mask cushion

and Clip

60177 (M)

60178 (L)

60179 (LW)

Ports cap

16570 (2)

16571 (10)

Elbow

16387

Swivel

16565

Mask frame

60180

Cushion clip

60176

Headgear

16118 (S)*

60114 (St)#

16119 (L)

Headgear clip

16569 (2)

16734 (10)

Complete System Frame System

(No headgear)

Medium (M) 60148 Medium (M) 60172

Large (L) 60149 Large (L) 60173

Large-Wide (LW) 60150 Large-Wide (LW) 60174

Frame assembly (no headgear, no cushion): 60175

Elbow assembly (elbow, swivel): 16399

English

Fitting

12 3

45 6

Disassembly

Removal

1 2 3

4 5 6

7 8 9

English

Cleaning the Mask at Home

The mask and headgear should be cleaned by handwashing.•

The headgear may be washed without removing the headgear clips.•

WARNING

Do not use aromatic-based solutions or scented oils (eg, eucalyptus

or essential oils), bleach, alcohol or products that smell strongly (eg,

citrus) to clean any of the mask components. Residual vapors from these

solutions can be inhaled if not rinsed thoroughly.They may also damage

the mask, causing cracks.

CAUTION

If any visible deterioration of a mask component is apparent (cracking,•

crazing, tears etc.), the mask component should be discarded and

replaced.

Avoid connecting ﬂexible PVC products (eg, PVC tubing) directly•

to any part of this mask. Flexible PVC contains elements that can

be detrimental to the materials of the mask, and may cause the

components to crack or break.

Daily/After Each Use

To optimize the mask seal, facial oils should be removed from the cushion

after use.

Handwash the mask by gently rubbing in warm (86°F/30°C) water using mild

soap.

If the vent requires cleaning use a soft bristle brush.

Rinse all components well with drinking quality water and allow them to air

dry out of direct sunlight. Do not soak the mask.

Weekly

Handwash the headgear in warm (86°F/30°C) water using mild soap.

Reprocessing the Mask between Patients

This mask should be reprocessed when used between patients.

Cleaning, disinfection and sterilization instructions are available from the

ResMed website, www.resmed.com/masks/sterilization/americas.

If you do not have Internet access, please contact your ResMed

representative.

Storage

Ensure that the mask is thoroughly clean and dry before storing it for any

length of time. Store the mask in a cool dry place out of direct sunlight.

Reassembly

123

4 5 6

English

Troubleshooting

Possible reason Solution

Mask is uncomfortable

Headgear straps are too tight. Adjust the straps evenly. The forehead support

“anchors” your mask and should sit ﬁrmly on

your forehead.

Cushion incorrectly inﬂated. With the air turned off, adjust the straps so that

you can insert two ﬁngers between your cheek

and the lower headgear strap.

Mask is too noisy

Cushion clip is not inserted

correctly.

Check that the cushion clip is correctly inserted

into the cushion, and that the cushion is

correctly clipped to the frame.

Ports cap or elbow incorrectly

inserted.

Check the the ports cap and elbow are correctly

inserted.

Vents are blocked or partially

blocked.

Clean vents according to instructions in

“Cleaning the Mask at Home”.

Air leaking around the face

Mask not positioned correctly. Reposition the mask upon the face.

Air leaking around the bridge of the

nose.

Wind the dial in.

Air leaking around the top of the lip. Wind the dial out.

The mask does not ﬁt properly

Cushion could be the wrong size. Talk to your clinician.

Mask is incorrectly assembled. Reassemble the mask according to the

instructions in “Reassembly”.

Cushion may be dirty. Clean cushion according to instructions in

“Cleaning the Mask at Home”.

Cannot insert forehead support into mask frame

When assembling the mask, you

have inserted the dial into the frame

before the forehead support.

Push dial base onto a hard surface until the dial

comes out of the frame.

Disposal

The mask does not contain any hazardous substances and may be disposed of

with your normal household refuse.

Technical Speciﬁcations

The mask system does not contain latex, PVC or DEHP materials.

Pressure–Flow

Curve

The mask contains passive venting to protect against rebreathing.

As a result of manufacturing variations, the vent ﬂow rate may

vary.

468101214161820

Pressure

(cm H2O)

Flow

(L/min)

419

8 28

12 34

16 40

20 45

Vent Flow Rate (L/min)

Mask Pressure (cm H2O)

Dead Space

Information

The dead space of the mask varies according to cushion size. It is

185 mL for the Medium size.

Therapy Pressure 4 to 20 cm H2O

Environmental

Conditions

Operating temperature: +41°F to 104°F (+5°C to +40°C)

Operating humidity: up to 95% non-condensing

Storage and transport temperature: -4°F to 140°F (-20°C to +60°C)

Storage and transport humidity: up to 95% non-condensing

Resistance Drop in pressure measured (nominal)

at 50 L/min: 0.1 cm H2O

at 100 L/min: 0.7 cm H2O

Gross

dimensions

M, L, LW: 6.06”/154 mm (H) x 3.74”/95mm (W) x 4.6”/117 mm (D)

Mask fully assembled – no headgear.

The manufacturer reserves the right to change these speciﬁcations without

notice.

English

Before Using the Mask

WARNINGS

The vent holes must be kept clear.•

Follow all precautions when using supplemental oxygen.•

Oxygen ﬂow must be turned off when the ﬂow generator is not operating,•

so that unused oxygen does not accumulate within the ﬂow generator

enclosure and create a risk of ﬁre.

At a ﬁxed ﬂow rate of supplemental oxygen ﬂow, the inhaled oxygen•

concentration varies, depending on the pressure settings, patient breathing

pattern, mask, point of application and leak rate.

The technical speciﬁcations of the mask are provided for your clinician to•

check that they are compatible with the ﬂow generator. If used outside

speciﬁcation or if used with incompatible devices, the seal and comfort of

the mask may not be effective, optimum therapy may not be achieved, and

leak, or variation in the rate of leak, may affect the ﬂow generator function.

Discontinue using the mask if you have ANY adverse reaction to the use of•

the mask, and consult your physician or sleep therapist.

Using a mask may cause tooth, gum or jaw soreness or aggravate an•

existing dental condition. If symptoms occur, consult your physician or

dentist.

As with all masks, some rebreathing may occur at low CPAP pressures.•

Refer to your ﬂow generator manual for details on settings and operational•

information.

Remove all packaging before using the mask.•

Symbols

Caution, consult accompanying documents;

L O T

Lot number;

REF

Part

number; Temperature limitation; Humidity limitation; Does not

contain latex; Manufacturer; Indicates a Warning or Caution and alerts

you to a possible injury or explains special measures for the safe and effective

use of the device.

Limited Warranty

ResMed warrants that your ResMed mask system, including its components:

mask frame, cushion, headgear, tubing and other accessories (“Product”) shall

be free from defects in material and workmanship for a period of ninety (90)

days from the date of purchase by the initial consumer.

For further details refer to the Warranty.

Andere Handbücher für Mirage Activa LT

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ResMed Atemwegsprodukt Handbücher

ResMed

ResMed Quattro Air Bedienungsanleitung

ResMed

ResMed AirFit N20 Bedienungsanleitung

ResMed

ResMed Mirage Quattro Bedienungsanleitung

ResMed

ResMed AirFit F30i Bedienungsanleitung

ResMed

ResMed AirFit N20 Bedienungsanleitung

ResMed

ResMed NV Elbow F20 Bedienungsanleitung

ResMed

ResMed Nasal Mask Mirage Activa Handbuch

ResMed

ResMed Quattro FX Bedienungsanleitung

ResMed

ResMed Mirage Vista Bedienungsanleitung

ResMed

ResMed MIRAGE SWIFT II 60891/1 Bedienungsanleitung

ResMed

ResMed CPAP Bedienungsanleitung

ResMed

ResMed Mirage Activa LT Bedienungsanleitung

ResMed

ResMed AirFit F30i Bedienungsanleitung

ResMed

ResMed Swift FX Nano Bedienungsanleitung

ResMed

ResMed Mirage Quattro Bedienerhandbuch

ResMed

ResMed Mirage FX Bedienungsanleitung

ResMed

ResMed S8 AutoSet Spirit Bedienungsanleitung

ResMed

ResMed Pixi Bedienungsanleitung

ResMed

ResMed Hospital Full Face Mask Bedienungsanleitung

ResMed

ResMed Quattro FX NV Bedienungsanleitung

ResMed

ResMed AutoSet Bedienungsanleitung

ResMed

ResMed Ultra Mirage Bedienungsanleitung

ResMed

ResMed AcuCare F1-0 Bedienungsanleitung

ResMed

ResMed Flow Generator S8 Elite System Bedienungsanleitung

Beliebte Atemwegsprodukt Handbücher anderer Marken

Omron

Omron COMP A-I-R NE-C801 Bedienungsanleitung

CERES

CERES nosko nebulizer kit Bedienungsanleitung

Dr.Frei

Dr.Frei NE-SM1 Bedienungsanleitung

North

North 5400 series Bedienungsanleitung

John Bunn

John Bunn Neb-u-Lite LX2 Bedienungsanleitung

DeVilbiss

DeVilbiss UltraNeb Bedienungsanleitung

Sperian

Sperian Panther Hip-Pac P9684 Series Bedienungsanleitung

Dräger

Dräger X-plore 6570 Bedienungsanleitung

3M 8000 Series Bedienungsanleitung

Respironics

Respironics SideStream HS860 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 Bedienungsanleitung

JARDIBRIC

JARDIBRIC KPBRU20 Bedienungsanleitung

Ombra

Ombra 63506 Bedienungsanleitung

Lotus

Lotus M-9520A Bedienungsanleitung

Philips

Philips Respironics EE Leak 1 AF541 Bedienungsanleitung

EVOLU

EVOLU Nano AiR MINI Bedienungsanleitung

Ambu

Ambu SPUR II Bedienungsanleitung

MSA AUER

MSA AUER 3S-PF Bedienungsanleitung