Samsung VAC-9073R Merkblatt
Operating lnstructions
Instrucciones de Operación
For household use only
Model
VAC-9073R
VACUUM CLEANER
ASPIRADORA
☞Before operating this unit, please read the instructions carefully.
☞Antes de usar esta unidad, lea cuidadosamente las instrucciones por favor.
EN
ES
-1
EN
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following :
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM
CLEANER
WARNING
To reduce the risk of fire, electric shock, or injury.
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
4. Use only as described in this manual. Use only manufacturer’s recommended attachments.
5. Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, take it to a service center.
6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked: keep free of dust, lint, hair,
and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all other parts of the body away from openings and moving
parts.
11. Do not vacuum anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
12. Do not use without dust bag and filters in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to vacuum flammable or combustible liquids such as gasoline or use in areas where they
may be present.
16. Store your vacuum cleaner indoors in a cool, dry area.
17. Do not use extension cords or an outlet with inadequate current carrying capacity.
18. Hold plug when rewinding onto cord reel. Do not allow plug to whip when rewinding.
19. Unplug electrical appliances before vacuuming them.
20. The hose contains electrical wires. Do not use if damaged, cut, or punctured. Avoid picking up sharp
objects.
21. Always turn off this appliance before connecting or disconnecting either hose, wand or motorized
nozzle.
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug(one blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug
in any way.
-2
EN
PARTS IDENTIFICATION
DUST-FULL INDICATOR
If the “Dust-Full” indicator switches to “RED” while you are cleaning, the dust bag is full and must be
replaced.
If the “Dust-Full” indicator continues to display “RED” even after changing the dust bag, turn
the cleaner off and check whether the hose, tube or nozzle is clogged.
NOTE :
-3
EN
ASSEMBLING THE VACUUM CLEANER FOR USE
EXTENSION WAND
Attaching the Hose to the Canister
Slide the Hose Clamper into the canister Inlet until it
“Clicks” into place.(Fig. A-A)
Attaching the Extension Wand to the Hose
Slide the handle end of hose over the end of the wand
until it “Clicks” into place. (Fig. A-B)
They can be removed by pressing the button on the
Hose.
Attaching the Power Brush
Slide the end of the Extension Wand onto the Power
Brush Wand unitl it “Clicks” into place. (Fig. A-C)
They can be removed by pressing the button on the
Extension Wand.
The Extension wand can be adjusted to your height.
Hold the central area with one hand while pulling the
smallest tube out or pushing into the desired length with
the other hand.
POWER CORD
1) PULLING OUT
The power cord is long enough to be drawn out for
convenience.
2) REWINDING
Upon finishing cleaning, disconnect the plug from the electrical
outlet and press the cord rewind button lightly with your toe.
When removing the power cord from the electrical outlet, grasp the plug, not the cord.
NOTE :
-4
EN
ON/OFF SWITCH
POWER CONTROL
USING THE ACCESSORIES
OPERATING THE BRUSH HEAD
PARK POSITION
With the cord plugged into an electrical outlet, start or stop
the vacuum cleaner by stepping lightly on the switch button.
The suction power can be adjusted with the electrical power
control to suit any situation.
MIN = For delicate fabrics, like net curtains.
MAX = For hard floors and heavily soiled carpets.
* Manual suction power control
The flexible hose hose handle(suction control) has a manual
air flow regulator which allows you to briefly alter the suction
level : the further open the regulator is, the weaker the suc-
tion power.
• Dusting brush - for furniture,shelves,books,etc.
• Upholstery brush - for cushions and drapery.
• Crevice tool - for radiator,crevices,corners,between cushions.
• Power brush -The rotating brush ensures that cleaning is
carried out more thoroughly.
Push the ON/OFF switch(A) down.
(The brush switches on)
Located in the top rear side of the vacuum cleaner, there is
a support for a convenient park position during pauses when
using the nozzle.
-5
EN
TRANSPORTING AND STORING THE VACUUM CLEANER
For easy storage and transportation, this vacuum cleaner
has a clip system built onto the body, which will keep the
tube, hose and nozzle in a vertical position.
REPLACING THE DUST BAG
If you are using a cloth filter bag, clean it when it’s full and use it again.
2) Remove the dust bag from the cleaner.
4) Press the dust cover down gently until the
clamp relocks.
3) After removing the used dust bag, insert the
cardboard bag collar of the new dust bag into
the suction inlet all the way.
A used dust bag can be sealed by removing the paper from the adhesive strip and sealing the
strip over the suction opening.
1) To open the dust cover of the dust bag com-
partment, press the clamp upward located at the
side of the dust cover.
NOTE :
NOTE :
-6
EN
VACUUMING WITH THE POWER BRUSH
1. Attaching the Power Brush
The hose must be plugged into the canister and the power brush
must be plugged into the hose and extension wand (see page 3).
2. Vacuuming
● For best results, move the power brush slowly using short,
overlapping strokes.
● For heavily soiled areas, repeat strokes in several directions.
●
Turn height adjustment knob to match the surface being cleaned.
3. Checking the Performance of the Power Brush
You may check whether the power brush is operating correctly by lifting up the extension tube slightly
to view the back of the brush.
The Power Brush will not operate when it is jammed or the unit is turned off.
If the Power Brush is jammed, Unplug the power cord from the electrical outlet. Turn the power brush over
and remove the jammed object.
Turn the power brush back to vacuuming position and resume vacuuming.
CAUTION: Do not invert the power brush while it is running
MAINTAINING THE POWER BRUSH
2) Remove the old bulb from the bulb socket.
Insert the new bulb. You can use a vacuum
cleaner lamp rated 120V, 20W.
1) Remove the Brush Cover as
described below.
1. Removing the Brush Cover
● Before replacing any parts, unplug the vacuum
cleaner from the electrical outlet.
● Remove 6 screws from the bottom plate and
open the brush cover.
2. Replacing the Headlight Bulb(optional)
-7
EN
2)
Remove the flat belt from the motor shaft and the
brushroller. Loop the new belt around the motor
shaft and then loop it around the
brushroller.
4)
Be sure that the belt is not twisted. Rotate the belt
3 or 4 times to position it correctly on the roller and
to make sure all rotating parts move smoothly.
Replace the brush cover.
3) Reinsert the brushroller, making sure that both
ends of the brushroller are fitted into the grooves
of the nozzle head.
1) Remove the brush cover. Grasp the
brushroller firmly, and pull it out.
Use with caution when replacing the belt that drives the brushroller. Tension on the belt is high.
1) Turn off the vacuum cleaner and unplug the
power cord.
2) Remove the cover to expose the brushroller.
3) Cut off any lint, carpet pile or hair that has
accumulated around the brushroller with a pair
of scissors. Replace the brush cover.
3. Replacing the Brushroller Belt
4. Cleaning the Brushroller
-8
EN
REPLACING THE MICROFILTER
TROUBLESHOOTING
• The microfilter filters the air which comes out from the vacuum cleaner.
• To open the filter cover, press down and pull it simultaneously.
• Remove and replace the dirty microfilter.
• Close the cover.
PROBLEM CAUSE REMEDY
Motor does not start No voltage Check cable, plug and
socket.
Suction force is
gradually reduced Filter,nozzle,suction
hose tube blocked, or
bag full.
Remove the obstruction or
replace bag.
Cord does not rewind
fully Check that the cord is
not twisted or wound
unevenly
Pull the cord out 6~10ft &
push down the cord rewind
button
CARE OF MOTOR FILTER
The motor filter protects the motor from dirt and ensures long-lasting and efficient operation.
When the filter becomes dirty, wash it in warm water, dry it thoroughly, and position it in place.
-9
EN
Model Specifications
The model and serial number are
located on the nameplate on the
underside of the cleaner as illustrated
below :
Inhaltsverzeichnis
Sprachen:
Andere Samsung Staubsauger Handbücher
Samsung
Samsung SC8200 Series Bedienungsanleitung
Samsung
Samsung SC12F50 series Bedienungsanleitung
Samsung
Samsung DJ68-00339U Bedienungsanleitung
Samsung
Samsung Vacuum cleaner Bedienungsanleitung
Samsung
Samsung VS15A60 Series Bedienungsanleitung
Samsung
Samsung VC-RA84V Series Bedienungsanleitung
Samsung
Samsung VC-7114H Bedienungsanleitung
Samsung
Samsung VAC-7049B Bedienungsanleitung
Samsung
Samsung POWERbot SR2 M70 Series Bedienungsanleitung
Samsung
Samsung SS60K60 Series Bedienungsanleitung
Samsung
Samsung DJ68 Bedienungsanleitung
Samsung
Samsung sc7400 Bedienungsanleitung
Samsung
Samsung VS15T70 Series Bedienungsanleitung
Samsung
Samsung DJ68-00330A Bedienungsanleitung
Samsung
Samsung SC88 series Bedienungsanleitung
Samsung
Samsung SU3480 Bedienungsanleitung
Samsung
Samsung POWERbot VR20R72 Series Bedienungsanleitung
Samsung
Samsung VR5000 Bedienungsanleitung
Samsung
Samsung POWERbot SR10M70 Series Bedienungsanleitung
Samsung
Samsung SR8875 Bedienungsanleitung
Beliebte Staubsauger Handbücher anderer Marken
Bissell
Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung
Panasonic
Panasonic MC-YL637S147-AE Bedienungsanleitung
NEFF
NEFF N17XH10 0 Series Bedienungsanleitung
LG
LG A9 Series Bedienungsanleitung
Oreck
Oreck Cordless Captura BK51700 Series Bedienungsanleitung
Kogan
Kogan KAVACROBVWA Bedienungsanleitung
