Samsung VC-8918V Bedienungsanleitung

Operating Instructions

VACUUM CLEANER

❈Before operating this unit, please read the instructions carefully.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 1

FEATURES

Features include indicator and automatic cord rewind.

IMPORTANT SAFEGUARDS

1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity sup-

ply is the same as that indicated on the rating plate on the bottom of the cleaner.

2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.

3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vac-

uum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. Use

the vacuum cleaner only for its intended use as described in these instructions.

4. Do not use the vacuum cleaner without a dust bag. Change the dust bag before it is full in order to

maintain the best efficiency.

5. Do not use the vacuum cleaner to pick up matches,live ashes or cigarette butts. Keep the vacuum

cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of

the unit.

6. Avoid picking up hard,sharp objects with the vacuum cleaner as they may damage the cleaner parts.

Do not stand on the hose assembly. Do not put a weight on the hose. Do not block the suction or the

exhaustion part.

7. Switch the vacuum cleaner off at the machine before unplugging from the electrical outlet. Grasp the

plug to disconnect cord from electrical outlet before changing the dust bag.

8. The use of an extension cord is not recommended.

9. If your vacuum cleaner is not operating correctly,switch off the power supply and consult an autho-

rized service agent.

10. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a simi-

larly qualified person in order to avoid a hazard.

WARNING

1. Do not use to suck up water.

2. Do not immerse in water for cleaning

3. The hose should be checked regularly and must not be used if damaged.

NOTE : Not all models have the same features.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 2

IDENTIFICATIONS OF PARTS

Features marked with

may vary according to model.

REMOTE POWER CONTROL *

(REMOTE CONTROL TYPE ONLY)

CARRYING HANDLE

DUST COVER

TOOL STORAGE COVER

BUTTON FOR SUCTION HOSE REMOVAL

ON/OFF

BUTTON

POWER CONTROL SWITCH *

AUTO BUTTON

CORD REWIND BUTTON

FLOOR NOZZLE *

TUBE *

TRANSPARENT TUBE *

SUCTION REGULATOR *

HANDLE *

HOSE *

CLAMPER FOR DUST BAG COMPARTMENT

DJ68-00093B(EN) 5/20/02 8:01 PM Page 3

ASSEMBLING THE VACUUM-CLEANER READY FOR USE

Adjust the suction tube(depending on model).

Open the hose connection cover.

Connect the nozzle to the suction tube.

①EXTENDING :

Holding the narrow part of

the telescopic tube with one

hand, push the handle in the

opposite direction with your

other hand.

➁ SHORTENING :

Holding the narrow part of

the telescopic tube with

one hand, pull the handle

towards it using the other hand.

OPTION :

Connect the suction tubes together.

Connect the suction hose to the suction tube.

Connect the body connector to the body of the

cleaner.

NOTE :

Adjustable telescopic tube is not

available with all models.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 4

You can start or stop your vacuum cleaner by pressing the

on/off switch lightly with your toe.

ON/OFF SWITCH

POWER CONTROL(VARIABLE CONTROL TYPE ONLY)

The vacuuming power can be adjusted to suit any situation with electrical power control.

MIN = For delicate fabrics, e.g. net curtains.

ECO = Economy setting for normally soiled carpets.

MAX = For hard floors and heavily soiled carpets.

1) For slider control types

Slide the controller to upwards or downwards to adjust the power output.

■Model with controller on the body of cleaner

2) For button control types

Press (+)button to heighten the power.

Press (

)button to lower the power.

■Model with controller on the handle

NOTE :

When removing the power cord from the electrical outlet,grasp the plug,not the cord.

POWER CORD

1) PULLING OUT :

The power cord is long enough to

drawn out for convenience.

2) REWINDING :

When you have finished cleaning,discon-

nect the plug from the electrical outlet

and simply press the cord rewind button

lightly with your toe.

■Model with controller on the handle

DJ68-00093B(EN) 5/20/02 8:01 PM Page 5

Using Exbug Elimination System

(DEPENDING ON MODEL)

AUTO MODE (BUTTON CONTROL TYPE ONLY)

If you press AUTO MODE, the power is automatically set at

1200~1300 watt.

This mode reduces the suction power fluctuation which is caused by

the fluctuation of airflow quantity to the motor.

For example, when dust bag is full, the quantity of air to the motor will

be decreased and power will be down followingly. AUTO MODE, in

this case, increases the power automatically for sufficient suction.

If you want to go back to the normal control type, just press "+" or "-"

buttons.

It is best to use the Mite Killing cycle immediately after you have finished

your cleaning.

Ensure machine is plugged in and the power point is switched on.

Disconnect the hose from the cleaner by pressing in the two but-

tons on the hose end and lift the hose out.

Close the hose connection cover on the top of the cleaner until

tone is heard. Make sure that it is fully shut.

Switch the cleaner on and the cleaner will run.

The Mite Killer cycle will automatically stop when complete.

Unplug the cleaner, rewind the cord, open the hoses connection cover and re-connect the hose.

Your cleaner can be used immediately after the Mite Killer cycle stop or by interrupting the cycle. To do

this,switch cleaner off,open the hose connection cover and re-connect the hose.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 6

Open the tool storage cover upwards.

USING THE ACCESSORIES

CREVICE DUSTING UPHOLSTERY

Crevice tool for radiators, crevices,

corners, between cushions. Dusting brush for furniture,

shelves, books, etc. Upholstery brush for cushions

and drapery.

PARK POSITION

TRANSPORTING AND STORING THE VACUUM CLEANER

Located in the top rear side of the vacuum cleaner,there is

a nozzle support that can be used to park the nozzle during

pauses in cleaning

For easy storage and transportation, this vacuum cleaner has a

clip system built into body, which will keep the wand, hose and

nozzle in an upright position.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 7

FOR CLOTH FILTER BAG

After using,if the cloth filter bag is full of dust, clean the cloth filter bag and use it again.

NOTE :

Used dust bags can be sealed by removing

the film from the paper and sticking over the

suction opening.

REPLACING THE DUST BAG

Remove the dust bag from the cleaner

To open the dust cover of the dust bag com-

partment, press the clamper upwards(the clam-

per is located at the front of the dust cover).

Press the dust cover down gently until the

clamper relocks.

After removing the used dust bag, insert the

cardboard bag collar of the new dust bag into

its original position.

DUST-FULL INDICATOR

If the “Dust-Full” indicator switch changes to “RED” while you are cleaning, the dust bag is

full and must be replaced.

NOTE :

If the “Dust-Full” indicator continues to display “RED” even after changing the dust

bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 8

MAINTENANCE OR REPLACEMENT OF THE FILTERS

INLET FILTER

▲

The secondary filter, located behind the grille in the back of dust bag compartment, protects the motor from

dirt particles.

Do not allow the filter to become clogged.

Suction power reduction or motor damage may result. If filter becomes dirty, pull off the grille and lift out filter.

After cleaning the secondary filter attach it in place.

For HEPA Filter Type For Micro Filter Type

OUTLET FILTER

▲

Open the dust cover and lift off the grille.

Grasp filter and pull it out with preliminary filter.

After cleaning preliminary filter, reposition new filter

and preliminary filter by reversing this procedure.

Grasp grille filter and pull it out with preliminary filter.

After cleaning preliminary filter, reposition new filter

compartment and preliminary filter by reversing this

procedure.

NOTE :

The filters must be completely dried before being replaced in the dust compartment.

HEPA Filter

Preliminary

Filter

Grille Filter

Micro Filter

Preliminary Filter

DJ68-00093B(EN) 5/20/02 8:01 PM Page 9

NOTE: For optimum efficiency, clean floor brush with crevice tool.

TRANSPARENT TUBE

Transparent tube prevent the tube and hose

from being clogged by obstacle like as socks

and clothes.

When transparent tube is clogged.

Separate the nozzle from the tube. Remove

the alien substance with a stick from it. After

cleaning it, reassemble the nozzle to the tube.

USAGE OF FLOOR NOZZLE

Select the carpet indicator ➀when cleaning carpets.

Select flat surface indicator ➁when cleaning the floors, tiles, etc.

FOR RUG / FLOOR SELECTOR

Before use make sure that the position of the selector is in the right position for the type of surface to be

cleaned.

FOR UNIVERSAL BRUSH

Use the floor nozzle for cleaning all surfaces.

DJ68-00093B(EN) 5/20/02 8:01 PM Page 10

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Samsung Staubsauger Handbücher

Samsung

Samsung SS7555 Bedienungsanleitung

Samsung

Samsung VS20R90 Series Bedienungsanleitung

Samsung

Samsung SC4520 Bedienungsanleitung

Samsung

Samsung SR8874 Bedienungsanleitung

Samsung

Samsung su10f70 series Bedienungsanleitung

Samsung

Samsung SC21F50 Series Bedienungsanleitung

Samsung

Samsung SC52 Series Bedienungsanleitung

Samsung

Samsung POWERbot SR1 M70 Series Bedienungsanleitung

Samsung

Samsung SS60M60 Series Bedienungsanleitung

Samsung

Samsung SR8930 Bedienungsanleitung

Samsung

Samsung VS20A95 Series Bedienungsanleitung

Samsung

Samsung SC07M25 Series Bedienungsanleitung

Samsung

Samsung SU10H30 SERIES Bedienungsanleitung

Samsung

Samsung Vacuum cleaner Bedienungsanleitung

Samsung

Samsung Vacuum cleaner Bedienungsanleitung

Samsung

Samsung SC21K5130VB Series Bedienungsanleitung

Samsung

Samsung SC52 Series Bedienungsanleitung

Samsung

Samsung VAC6013R Bedienungsanleitung

Samsung

Samsung VAU5863B Bedienungsanleitung

Samsung

Samsung SS75N80 Series Bedienungsanleitung

Samsung

Samsung SC07F50 series Bedienungsanleitung

Samsung

Samsung VC-5953 Bedienungsanleitung

Samsung

Samsung RC-5510 Bedienungsanleitung

Samsung

Samsung SC6580 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch