Tennsco Z-Line Steel Shelf Unit Bedienungsanleitung

PK-1890719

ASSEMBLY INSTRUCTIONS & PARTS MANUAL

Z-Line Steel Shelf Unit

RETAIN INSTRUCTIONS FOR FUTURE REFERENCERETAIN INSTRUCTIONS FOR FUTURE REFERENCE

Tennsco LLC., Dickson, TN 37056-1888 • (866) 446-8686

GENERAL SAFETY INFORMATIONGENERAL SAFETY INFORMATION

Some parts may have sharp edges. CARE must be taken when handling various pieces to avoid injury.

For safety, wear a pair of work gloves when assembling or performing any maintenance on units.

LIMITED WARRANTYLIMITED WARRANTY

Tennsco warrants goods purchased hereunder to be free of defects in materials and workmanship for a period of one (1) year from the date of shipment, hereunder. This warranty shall not apply in

the event goods are damaged as a result of misuse, abuse, neglect, accident, improper application, modication or repair by persons not authorized by Seller, where goods are damaged during

shipment, or where the date stamps on the goods have been defaced, modied or removed. UNLESS CONSIDERED UNENFORCEABLE OR UNLAWFUL UNDER APPLICABLE LAW:

a. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY EXCLUDED:

b. BUYERS REMEDY, IF ANY, FOR ANY DEFECTIVE GOODS SHALL BE LIMITED TO A REFUND BY SELLER OR REPLACEMENT OF THE GOODS AT SELLER’S OPTION, AND SHALL IN NO

EVENT INCLUDE DAMAGES OF ANY KIND, WHETHER INCIDENTAL, CONSEQUENTIAL OR OTHERWISE.

NO GOODS ACCEPTED FOR RETURN WITHOUT PRIOR APPROVAL. Seller shall have the right to inspect any goods claimed to be defective at Buyers place of business or require Buyer to return the

goods to Seller for inspection on Seller’s premises. Transportation charges covering returned goods will be borne by Seller only if such goods are proven to be defective, are covered by this warranty

and are returned within the warranty period stated above.

LOAD CAPACITIESLOAD CAPACITIES

PER SHELF LEVEL*PER SHELF LEVEL*

36w x 12d

36w x 18d

36w x 24d

36w x 36d

42w x 12d

42w x 18d

42w x 24d

42w x 36d

48w x 12d

48w x 18d

48w x 24d

48w x 36d

750 lbs.

700 lbs.

600 lbs.

550 lbs.

500 lbs.

450 lbs.

UNIT SIZEUNIT SIZE WT. CAPACITYWT. CAPACITY

*Load capacities based on evenly distributed loads

Total unit capacity not to exceed 8,000 lbs.

ASSEMBLY OF STEEL SHELVING

Tools Needed: A rubber mallet for seating the shelf supports into the uprights.

Two people are recommended for assembly. Approximate assembly time: 20-30 minutes per section.

5. Finish installing the remaining left-to-right shelf supports

and front-to-back shelf supports around the top of the unit.

1. The reference numbers used throughout this sheet refer to

the illustration on the back cover. This is to help you to

identify the various parts as they are mentioned.

2. Create a unit end by connecting two uprights (Ref. No. 1

or 2) with one of the front-to-back shelf supports (Ref.No.

3) by inserting the shelf support rivets into the bottom

two keyhole slots of each upright using a rubber mallet to

seat the upright securely in the keyhole slots.

NOTE: Be sure that the narrow

end of the keyhole slots are

pointing downward, and the ﬂat

edge of the shelf support is

facing up.

3. Assemble another unit end by repeating the directions in step 2.

Be sure the shelf support rivets are seated in the bottom of

the slots. If you are creating a starter unit and adder units then

you will need to replace the EUR upright post on one end with

ZTP upright posts.

4. Connect two of the left-to-right shelf supports

(Ref. No. 4) between the two assemblies, one

on each side with angled corners facing

toward each other. Be sure to use

the two keyhole slots

nearest the oor, as

in step 1.

NOTE: As in step one,

make sure the ﬂat

edge of the shelf

supports are facing

upwards. If this has

been done correctly,

there would now be

a ﬂat surface around

all four edges on which to

lay the bottom steel shelf.

If any edges have an upward facing angled edge, the

support has been inserted upside down.

NOTE: Be sure that the support

rivets are seated in the bottom

of the slots of the uprights securly.

6. After building the framework, place a steel shelf (Ref. No. 5) on

the lower level and on the top level of the VDRS supports. These

shelves will lay directly on the at ledge of the support.

7. Next attach the ZSC-1 shelf clips (Ref. No. 6) to the EUR post

as shown. Make sure that all four clips are on the same level

on each of the uprights for the shelves to be level. Be sure to

drive the clips down until they are seated rmly then install the

shelf on top of the four clips, with the shelf sliding into the slot

in the clip.

8. If you were assembling a stater unit, your unit is now ready

for use and will look similar to the drawing below.

9. If you are assembling an adder unit it will not look like

the drawing above. The adder unit will share front and back

supports with the starter unit on the side that the starter unit is

connected using an intermediate “T” post. To attach an adder

unit to a starter unit you will attach the VDRS supports to

the ZTP post and construct the adder unit the same way that you

did the starter unit.

⁭⁭

Shelf ClipShelf Clip

(Ref No. 6)(Ref No. 6)

⁭⁭

Tennsco makes every effort to ensure that all units ship complete with all parts and arrive undamaged.Tennsco makes every effort to ensure that all units ship complete with all parts and arrive undamaged.

However, should your unit contain missing or damaged parts, please contact your purchase location.However, should your unit contain missing or damaged parts, please contact your purchase location.

49B18949B189

⁭⁭

Front to Back SupportFront to Back Support

(Ref No. 3)(Ref No. 3)

Intermediate PostIntermediate Post

(Ref No. 2)(Ref No. 2)

Standard Angle PostStandard Angle Post

(Ref No. 1)(Ref No. 1)

Left to RightLeft to Right

SupportSupport

(Ref No. 4)(Ref No. 4)

Box FormedBox Formed

Steel ShelfSteel Shelf

(Ref No. 5)(Ref No. 5)

REF.REF.

NO. DESCRIPTIONNO. DESCRIPTION PART NUMBERSPART NUMBERS

QTY.QTY.

EUR-84

ZTP-84

VDRS-ww16

ZMS-wwdd

ZSC-1

Standard Angle Post

Intermediate “T” Post

Front to Back Support

Left to Right Support

Box Formed Steel Shelf

Shelf Clip

REPLACEMENT PARTSREPLACEMENT PARTS

STARTERSTARTER

UNITUNIT

ADDERADDER

UNITUNIT

Andere Tennsco Inneneinrichtung Handbücher

Tennsco

Tennsco J1878C-N Bedienungsanleitung

Tennsco

Tennsco ESPC-1236 Bedienungsanleitung

Tennsco

Tennsco 3018 Bedienungsanleitung

Tennsco

Tennsco BK6-121812-1 Bedienungsanleitung

Tennsco

Tennsco 7218 Bedienungsanleitung

Tennsco

Tennsco MB-2-2542 Bedienungsanleitung

Tennsco

Tennsco Standard Combination Cabinet 7220 Bedienungsanleitung

Tennsco

Tennsco 7818 Bedienungsanleitung

Tennsco

Tennsco RGL-1236S Bedienungsanleitung

Tennsco

Tennsco 1872 Bedienungsanleitung

Tennsco

Tennsco 1-Wide Welded Base for Lockers without Legs Bedienungsanleitung

Tennsco

Tennsco DWR-4218 Bedienungsanleitung

Tennsco

Tennsco FB-12 Bedienungsanleitung

Tennsco

Tennsco Enclosed Foreman’s Desk Bedienungsanleitung

Tennsco

Tennsco 1442 Bedienungsanleitung

Tennsco

Tennsco 1470 Bedienungsanleitung

Tennsco

Tennsco FS350 Bedienungsanleitung

Tennsco

Tennsco EB-12 Bedienungsanleitung

Tennsco

Tennsco 1871 Bedienungsanleitung

Tennsco

Tennsco WELDED 3-PERSON LOCKER Bedienungsanleitung

Tennsco

Tennsco APT-3672S Bedienungsanleitung

Tennsco

Tennsco WBHC-1516-MGY Bedienungsanleitung

Tennsco

Tennsco Open Foreman's Desk Bedienungsanleitung

Tennsco

Tennsco 1471 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung