Town & Country Fireplaces TC36.NGST03 Bedienungsanleitung

210705-12 TC36.NGST03 5056.42801.3

TC36 See-Thru

BLACK DIAMOND

BURNER KIT

IMPORTANT:

THESE INSTRUCTIONS ARETO REMAIN

WITH THE APPLIANCE INSTRUCTIONS

These instructions are supplementary to the Installation and

Operating Instructions supplied with the fireplace and should

be kept together. Refer to the Installation and Operating

Instructions for proper gas supply, safety requirements and

operating instructions.

PART#

TC36.NGST03

FOR TC36

SEE-THRU

2210705-12 TC36.NGST03 5056.42801.3

Package Contents

BURNER TUBE PART# TC36.50118398

SHUTTER CONTROL ROD PART# 5002.9692

BURNER TRAY ASSEMBLY PART# TC36.9690

2 BURNER SHIELD, FRONT/REAR PART# TC36.9693 PBK

LEFT BURNER SHIELD PART# TC36.9693.2 PBK

RIGHT BURNER SHIELD PART# TC36.9693.5 PBK

AIR CHANNEL INSERT PART# TC36.9697 PBK

INLET COVER PART# TC36.9699 PBK

PILOT SHIELD PART# TC36.9626.PBK

MANIFOLD ASSEMBLY PART# TC36.9692

2 MEDIA SPACER, FRONT/REAR PART# 9695

MEDIA SPACER, CENTER PART# 9694

TUMBLED GLASS MEDIA PART# 5012.01

HARDWARE PACKAGE PART# TC36.STHK03

Fig. #1

210705-12 TC36.NGST03 5056.42801.3

Black Diamond Burner Installation

1. Attach the manifold assembly to the

floor of the firebox using two screws.

(Fig. #2)

2. Connect the flex gas line to the

manifold ensuring a gas-tight

connection (Fig. #3).

3. If porcelain panels are not installed, install the left panel (Fig. #4) securing with panel retainer clip located on the

upper heat shield, and position the air channel insert into the air channel. (Fig. #5)

NOTE:The right side of the unit is the side with the control box inlet.

Fig. #2

Fig. #3

Fig. #4

Fig. #5

4210705-12 TC36.NGST03 5056.42801.3

4. Attach the inlet cover using the top

two screws of the control inlet

(Fig. #6) and install the right porcelain

panel.

5. Position the right burner shield over

the inlet cover ensuring that the pilot

assembly is protruding though the

half-hole between the inlet cover and

the right burner shield (Fig. #7).

6. While supporting the right burner

shield,install the rear burner shield

resting the edge of the right burner

shield onto the support tab of the rear

burner shield (Fig. #8).

Fig. #6

Fig. #7

Fig. #8

210705-12 TC36.NGST03 5056.42801.3

7. Install the front burner shield

positioning the support tab under the

right burner shield.

8. Install the left burner shield.This will

be a snug fit requiring some

alignment (Fig. #10).

9. Position the burner tray assembly on

top of the assembled shields and

attach it using four screws (Fig. #11).

NOTE: Ensure that the square

access hole of the tray is

positioned to the right (control

inlet side). (Fig. #11)

Fig. #11

Fig. #10

Fig. #9

6210705-12 TC36.NGST03 5056.42801.3

10. If the fireplace is equipped with a

millivolt pilot, attach it to the burner

tray before attaching pilot bracket.

If the fireplace is equipped with an

electronic pilot attach it to the pilot

bracket (Fig. #12) and then attach

the bracket to the burner tray

(Fig. #13).

11. Position a front/rear media spacer

at the rear of the burner tray

(Fig. #14).

12. Position the other at the front of the

tray (Fig. #15).

13. Loosen the screw on the burner tube

shutter enough to allow smooth

movement from open to closed

positions (visible in Fig. #17).

Fig. #12

Fig. #13

Fig. #14

Fig. #15

210705-12 TC36.NGST03 5056.42801.3

14. Install the burner tube by tipping the

inlet into the slot in the bottom of the

burner tray (Fig. #16).

15. Hold the burner tube in a position so

that the shutter control rod can be

inserted into the shutter tab (Fig.

#17) after passing through the rod

hole in the top right corner of the

front burner shield.

16. Set the burner tube into place

ensuring that it slips over the orifice

on the manifold assembly.

17. Attach the burner tube to the tray

with two screws (Fig. #18).

NOTE: Shutter must be fully open

for propane or fully closed for

natural gas (push down on the

shutter control rod to open, pull

up to close). Some adjustment

may be required (see page 9).

Fig. #16

Fig. #17

Fig. #18

8210705-12 TC36.NGST03 5056.42801.3

18. Position the center media spacer on

the inside of the burner tube

(Fig. #19).

19. Apply just enough tumbled glass

to lightly cover the burner tube

(Fig. #20).

20. Spread glass evenly over top of tube

and media spacers (Fig. #21).

NOTE:Too much tumbled glass

over the burner will cause sooting.

Fig. #19

Fig. #20

Fig. #21

210705-12 TC36.NGST03 5056.42801.3

Burner Flame Adjustment

The air shutter on the burner inlet

tube controls the primary combustion

air to the gas burner. It is set closed

at the factory for natural gas fuel.

Some adjustment may be necessary

to obtain desired flame and to

eliminate carbon deposits. Evaluate

flame appearance after the fireplace

has reached operating temperature.

See Fig. # 22 for proper flame

pattern.

Open primary air if the window glass

and firebox have carbon

accumulation and/or the flames are

long, dark and stringy.The shutter

may also be opened to lessen the

flame height.

CAUTION:

Burner area may be hot!

Turn off the fireplace and allow the

unit to cool before proceeding.

To Adjust: (See Fig. # 23)

Push the shutter control rod to

increase the amount of primary air to

create a more blue flame.

Pull the shutter to decrease the

amount of primary air to create a

more yellow flame.

NOTE:

Proper air shutter setting is

required.

The flame should be just orange

and "lazy". It should NEVER be

set to create sooting on internal

parts and window glass.

Fig. #22

Fig. #23

Shutter Control

10 210705-12 TC36.NGST03 5056.42801.3

Replacement Parts

ITEM PART NUMBER DESCRIPTION

19697 AIR CHANNEL INSERT

29695 MEDIA SPACER, FRONT/REAR

3TC36.50118398 BURNER TUBE

49694 MEDIA SPACER, CENTER

59690.5 TRAY TRIM

69626.002 PILOT SHIELD

79699 INLET COVER

89693.5 BURNER SHIELD, RIGHT

99691 TRAY SUPPORT

10 9693 BURNER SHIELD FRONT/REAR

11 5002.9692 SHUTTER CONTROL ROD

12 9693.2 BURNER SHIELD, LEFT

13 9690 BURNER TRAY

TC36.STHK03 HARDWARE PACKAGE

TC36.9692 MANIFOLD ASSEMBLY

14 9692 MANIFOLD BRACKET

15 5019.21 FITTING, ORIFICE IN

16 5021.01 FITTING, LOCKNUT

17 5022.12 ORIFICE, NG

5021.31 ORIFICE, LP

NOTE:

FIREPLACE & VALVE REPLACEMENT

PARTS ARE LOCATED IN THE

APPLIANCE INSTRUCTIONS

14 15

Inhaltsverzeichnis

Andere Town & Country Fireplaces Kamin im Innenbereich Handbücher

Town & Country Fireplaces

Town & Country Fireplaces TC30 Black Diamond Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.54CE SERIES C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.54STOK Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC54.LP02.C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.54CE SERIES C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.38NG03.C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36ST Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCVT.WSPVB1 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS38D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS54ST SERIES D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36ST Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36ST.NGST04D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30 Black Diamond Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS38 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30 Black Diamond Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36ST Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.CE3 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS38D2 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS54ST SERIES D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCHF.22BODYA Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch