Assa Abloy Norton 7570 Series Bedienungsanleitung

Installation Instructions80-9377-0601-020 (03-13)Security Door CloserSeries 7570 / 7770Pull Side InstallationCloser mounts on hinge (pull) side of door.Left Hand Door - LHRight Hand Reverse - RHRRegular Non-Hold Open ArmRegular Arm is not available with a Hold Open Function

CAUTION

*For closers with or without "DA" suffix Delayed Action closing featureSeriesProduct TypeSized*CloserMulti-Sized**Closer77707570Security Door Closer(Door Closer with both a Security Cover and Security Arm)*7770 Series are sized door closers with 50% power increase capability. Power size 2 weakest power; power size 6 strongest.*7570 Series can be adjusted from power size 1 thru 6.NOTE: For special applications a separate door and frame preparation template is packed with these instructions.Use this instruction sheet for installation sequence and closer adjustments only.Right Hand Door - RHLeft Hand Reverse - LHR!MAXIMUM HINGE SIDE FRAME REVEAL IS 1/8" (3mm).!Security Door Closers only: Door closer cover is handed and cannot be reversed. All other components are non handed.!It is recommended that the door, on which the door closer will be installed, be hung on ball bearing hinges or offset pivots. Door must swing freely.!A separate door stop, supplied by others, is recommended to prevent damage to the door closer, closer arm, door, frame, or adjacent walls.!Door and frame must be properly reinforced, or use of special fasteners employed, to prevent the mounting screws from pulling out.!All dimensions are given in inches with corresponding metric dimensions (millimeters) in parenthesis.!Torx tamper resistant drive machine screws are normally supplied with this product.**Note:

Page 280-9377-0601-020 (03-13)TemplateRight Hand Door Shown (Left Hand Installation is opposite.)Preparation for Fasteners

Standard

Door orFrameFastenersDrill-Sizes1/4" - 20Machine ScrewMetalDrill: #7 (0.201" dia.)Tap: 1/4" - 20

Optional

Sex Nuts and Bolts(SNB)HollowMetal9/32" (7 mm); through3/8" (9.5 mm) on door or transom-faceopposite to closerAluminumor Wood3/8" (9.5 mm) through• For 7570 MODELS ONLY set closer power for door size using chart below.NOTE: Maximum of 16 360° turnsof Power Adjustment Nut-Turns from ZeroInterior DoorExterior Door025825811DoorSizeInches(mm)28-32(711-813)33-36(838-914)37-42(940-1067)43-48(1092-1219)Install closer per instructionswith the proper pre-load applied to the arm then adjust spring power. The power adjustment will notwork properly if the closerspring is not pre-loaded.To increase power, use 11/16"wrench to turn poweradjustment nut clockwise.To decrease power, turn nutcounter clockwise. DO NOT use a power drill or driver to turn adjustment nut. This will damagecloser and void warranty."Spring PowerAdjustment Nut"+

Page 380-9377-0601-020 (03-13)3. Mount closer on door. (A drop plate is available for use on doors having narrow top rails.) Power Adjustment Nut should be away from hinge. Valves are DOWN for Left Hand Door. Valves are UP for RIGHT HAND DOOR.Right Hand Door Shown4. Place main arm on shaft, aligning "S" mark on arm with pinion flat on pinion shaft. Push down into position. Secure with 1/4-20 x 1/2 (13) with hex head machine screw.Main Arm Screw5. With door closed, rotate arm away from hinge and align shoe with mounting holes in frame. Fasten arm shoe to frame with round head screws provided.CAUTION: Closer arm is under spring tension and may be difficult to rotate.CAUTION: Do not back valves out of closer or a leak will result!6. Make closer adjustments (see back page) before installing cover.7. Install Cover:Screw Standoffs into holes in closer. 8. Fasten cover to closer with 4 #8-32 x 1/4 RHMS provided.8-32 x 1/4 RHMS (4 Req'd)ScrewStandoffsintocloser.Installation Sequence1. Use template on page 2 to locate holes on door and frame:4 on door for closer or backplate2 on frame face for arm shoe.2. Prepare door and frame for fasteners using chart above.

Unit AdjustmentOpening Door ControlsFigure 4BackcheckFigure 5

1/8"HexKey

IncreaseDecrease

1/8"HexKey

Opening Door Control (Figure 4.)• Backcheck ("B") valve controls the hydraulic resistance to door opening. NEVER close this valve completely – it is not to provide a positive stop.• Backcheck position ("P") valve controls the door angle where backcheck cushioning starts. Valve normally closed.Backcheck CushionBackcheck PositionOpen for backchecklater in door-openingcycle.Closing Speed ControlsClosing Speed ControlsFigure 2Figure 32B2A

1/8"HexKey

SlowFast"L" (Latch)"L" (Latch)"S/D” (Sweep)"S" (Sweep)"S/D" (Delayed Action)StandardClosing CycleDelayed ActionClosing CycleClosed

10°

70°

Closed

10°

Standard CloserDelayed ActionCloserAll ValvesDo not force valvescounter-clockwise outof closer body or a fluidleak will occur.Do not force valvescounter-clockwise outof closer body or a fluidleak will occur.Closing Power ControlFigure 1Install closer per instructionswith the proper pre-load applied to the arm then adjust spring power. The power adjustment will notwork properly if the closerspring is not pre-loaded.To increase power, use 11/16"wrench to turn poweradjustment nut clockwise.To decrease power, turn nutcounter clockwise. DO NOT use a power drill or driver to turn adjustment nut. This will damage closer and void warranty.For 7570 OnlySet closer to desired size. For recommended sizes, refer to the Power Adjustment Chart on page 2.Norton® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company. Copyright © 1991, 2013, Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.

3000 Highway 74 East • Monroe, NC 28112Tel: (877)- • Fax: (800)-338-0965www.nortondoorcontrols.com974-2255

ASSA ABLOY

80-9377-0601-020 (03-13)Page 4Opening Cycle

"P"(Normally Closed)"B"(NEVER CloseCompletely)+

Dieses Handbuch passt für folgende Modelle

Andere Assa Abloy Türöffnungssystem Handbücher

Assa Abloy

Assa Abloy DC3210 Series Bedienungsanleitung

Assa Abloy

Assa Abloy 78PRA-8L Bedienungsanleitung

Assa Abloy

Assa Abloy 5800 ADAEZ PRO Bedienungsanleitung

Assa Abloy

Assa Abloy Corbin Russwin DC8200 Series Bedienungsanleitung

Assa Abloy

Assa Abloy Yale 2500 Series Bedienungsanleitung

Assa Abloy

Assa Abloy Corbin Russwin PED5200 Bedienungsanleitung

Assa Abloy

Assa Abloy 1370 Bedienungsanleitung

Assa Abloy

Assa Abloy Adams Rite EX88 Betriebsanleitung

Assa Abloy

Assa Abloy Sargent Electroguard-59 80 Series Montageanleitung

Assa Abloy

Assa Abloy Norton 6300 Series Bedienungsanleitung

Assa Abloy

Assa Abloy NORTON RIXSON 5200 Series Bedienungsanleitung

Assa Abloy

Assa Abloy Corbin Russwin ED4000 Series Bedienungsanleitung

Assa Abloy

Assa Abloy NORTON RIXSON 6200 Series Bedienungsanleitung

Assa Abloy

Assa Abloy RIXSON W91DCP Bedienungsanleitung

Assa Abloy

Assa Abloy Norton UniTrol UNI-1600BC Series Bedienungsanleitung

Assa Abloy

Assa Abloy Norton Narrow Profile Series Bedienungsanleitung

Assa Abloy

Assa Abloy Besam SW300 Bedienungsanleitung

Assa Abloy

Assa Abloy King 70 Series Bedienungsanleitung

Assa Abloy

Assa Abloy DC140 Bedienungsanleitung

Assa Abloy

Assa Abloy NORTON RIXSON 6332 Bedienungsanleitung

Assa Abloy

Assa Abloy SARGENT 1130-HU Series Bedienungsanleitung

Assa Abloy

Assa Abloy G-CO-FMS Bedienungsanleitung

Assa Abloy

Assa Abloy Norton 6300 Series Installationshandbuch

Assa Abloy

Assa Abloy effeff ePED 1386Z1LB7 04S0 Series Referenzhandbuch

Beliebte Türöffnungssystem Handbücher anderer Marken

Pamex

Pamex KT-INP35 Bedienungsanleitung

Cal-Royal

Cal-Royal N-F77CVR Bedienungsanleitung

Scrigno

Scrigno OPEN1000 Bedienungsanleitung

TriMark

TriMark UM 34 Bedienungsanleitung

BFT

BFT WIND RMB 130B 200 Bedienungsanleitung

Alecto

Alecto ADI-250 Bedienungsanleitung

Besam

Besam Swingmaster MP Leitfaden

CRL

CRL SENIOR PRIMA Bedienungsanleitung

GAL

GAL MOVFR Technisches Datenblatt

Normstahl

Normstahl IDO7 Bedienungsanleitung

Häfele

Häfele Finetta T 70 VF Bedienungsanleitung

AGS

AGS D-PL Handbuch

Stanley

Stanley MA900ñ Montageanleitung

WITTUR

WITTUR Hydra Plus UD300 Handbuch

Alutech

Alutech TR-3019-230E-ICU Montage- und Bedienungsanleitung

MPC

MPC ATD ACTUATOR 50 ATD-313186 Operating and Technisches Datenblatt

GEZE

GEZE ECturn Bedienungsanleitung

Chamberlain

Chamberlain T Bedienungsanleitung