Bradley S96-085 Bedienungsanleitung

P.O. Box 309, Menomonee Falls, WI 53052-0309

Phone: 1.800.BRADLEY Fax: 262.253.4161

bradleycorp.com

215-737 Rev. E; ECN 10-02-010

Page 1 of 6 1/31/2011

Bradley Multi-Station

Wall Sink

S96-085 (6951A-2) 2 station

S96-083 (6951A-3) 3 station

S96-080 (6951A-4) 4 station

S96-051 (6951A-5) 5 station

Table of Contents

Supplies Required for Installation..............2

Wall Sink Components .......................2

2-&3-Station Wall Sink Rough-Ins .............3

4-&5-Station Wall Sink Rough-Ins .............4

Installation Instructions .......................5

Cleaning Stainless Steel......................6

Installation

*FAUCETS BY OTHERS

IMPORTANT!

Read this entire installation manual to ensure proper installation. When

ﬁnished with the installation, ﬁle this manual with the owner or maintenance

department. Compliance and conformity to local codes and ordinances is

the responsibility of the installer.

Separate parts from packaging and make sure all parts are accounted for

before discarding packaging material. If any parts are missing, do not begin

installation until you obtain the missing parts.

Make sure that all water supply lines have been ﬂushed and then

completely turned off before beginning installation. Debris in supply lines

can cause valves to malfunction.

Product warranties may be found under “Products” on our web site at

bradleycorp.com.

Installation

THIS

SIDE

Packing List

•

6951A-2 thru 6951A-5 Installation

21-31-2011 Bradley Corporation • 215-737 Rev. E; ECN 10-02-010

Supplies recommended for installation:

• 1-1/4" anchors and bolts to secure sink to wall

• Wall reinforcement (if required)

• Trap and drain pipe to 1/-1/2" O.D. tailpiece

• Supply pipe to faucets (if required)

• OPTIONAL: 1/4" anchors and bolts to secure footing to floor

WALL SINK

2-STATION (S39-375)

3-STATION (S39-374) (shown above)

4-STATION (S39-373)

5-STATION (S39-151)

1/4"-20 x 3/8"

SOCKET-HEAD

SETSCREW

(160-246)

LEG (PIPE)

(113-744)

SUPPORT BRACKET

(140-112)

2- and 3-STATION (qty. 2)

4-STATION (qty. 3)

5-STATION (qty. 4)

DRAIN SPUD

(112-028)

WASHER

(142-063)

OVAL-HEAD

SCREW

(160-042)

TAILPIECE

(S29-083) ADJUSTABLE

FOOTING

(S36-020)

LOCKNUT

(161-148) STRAINER

(173-002)

Installation 6951A-2 thru 6951A-5

Bradley Corporation • 215-737 Rev. E; ECN 10-02-010 1-31-2011 3

23-1/2" - 25"

(597) (635)

43" - 44-1/2"

(1092)(1130)

31"-32-1/2"

(787)(826)

18"

(457)

23-1/2" - 25"

(597) (635)

43" - 44-1/2"

(1092)(1130)

31"-32-1/2"

(787)(826)

18"

(457)

2-Station Wall Sink

Dimensions

3-Station Wall Sink

Dimensions

6951A-2 thru 6951A-5 Installation

41-31-2011 Bradley Corporation • 215-737 Rev. E; ECN 10-02-010

23-1/2" - 25"

(597) (635)

43" - 44-1/2"

(1092)(1130)

31"-32-1/2"

(787)(826)

18"

(457)

23-1/2" - 25"

(597) (635)

43" - 44-1/2"

(1092)(1130)

31"-32-1/2"

(787)(826)

18"

(457)

4-Station Wall Sink

Dimensions

5-Station Wall Sink

Dimensions

Installation 6951A-2 thru 6951A-5

Bradley Corporation • 215-737 Rev. E; ECN 10-02-010 1-31-2011 5

1Mount sink to wall

Use a carpenter’s level to make sure that all of the brackets

are level with the ﬂoor and with each other before securing

them to the wall. An improperly installed bracket will lead to

an improperly installed sink that is not level.

To avoid leakage, use plumber’s putty to caulk the drain spud.

2Assemble Drain

1. Install suitable wall anchors for 1/4" bolts at the dimensions shown in

the rough-in drawings (anchors and bolts supplied by installer).

• 2- and 3-station sinks require 10 wall anchors and bolts.

• 4-station sink requires 12 wall anchors and bolts.

• 5-station sink requires 16 wall anchors and bolts.

2. Mount the support brackets to the wall anchors with 1/4" bolts (supplied

by installer).

• 2- and 3-station sinks require two brackets and six bolts.

• 4-station sink requires three brackets and nine bolts.

• 5-station sink requires four brackets and 12 bolts.

3. Hang the wall sink onto the support brackets.

Make the connection to the pipe (suppied by the installer) AFTER

the sink legs have been installed.

1. Insert the drain spud into the hole in the wall sink and secure the spud to

the sink with the washer and locknut provided as shown.

2. Attach the strainer to the drain spud and secure with the two screws

provided as shown.

3. Insert the flanged plastic washer into the top of the tailpiece. Slide the

tailpiece nut up to the top of the tailpiece and screw the nut into the spud

to secure the tailpiece to the sink.

6951A-2 thru 6951A-5 Installation

61-31-2011 Bradley Corporation • 215-737 Rev. E; ECN 10-02-010

3Attach Legs and Footings

4Complete Installation

1. Screw the adjustable footings into the bottom of the legs.

2. Insert the legs into the flanges located at the underside of the sink. Secure the

legs to the sink with the setscrews provided.

3. Adjust the foot pads on the bottom of the legs to level the unit and provide proper

drainage.

1. Secure the sink to the wall with four 1/4" bolts (supplied by installer) through the

wall anchors installed in Procedure #1.

2. OPTIONAL FAUCETS: Make the proper supply connections to the faucets

as outlined in the faucet manufacturer’s installation manual (pipe supplied by

installer).

3. Make the drain connection to the 1-1/2" O.D. tailpiece on the sink (pipe supplied

by installer).

Cleanliness is of utmost importance. Do not permit salty solutions to evaporate and dry on stainless steel. Never use

ordinary steel wool or steel brushes on stainless steel. Always use stainless steel wool or stainless steel brushes.

1. Remove ordinary deposits of dirt and grease with soap and water. Whenever possible, the metal should be thoroughly rinsed

and dried after washing.

2. Use stainless steel polishing powder to get rid of tightly adhering deposits.

3. Look for the source of the rust in some iron or steel not actually a part of the stainless steel structure. Sometimes the

appearance of rust streaks on stainless steel leads to the belief that the stainless steel is rusting. Asteel nail or screw may be

the cause of the trouble.

4. If the sprayhead delivers an uneven spray, remove the sprayhead from the unit, disassemble, and remove foreign matter.

Reassemble sprayhead and reinstall into unit.

Cleaning Stainless Steel

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bradley Sanitärprodukte Handbücher

Bradley

Bradley Sentry SN2013/IR Bedienungsanleitung

Bradley

Bradley Aerada 900 Series Bedienungsanleitung

Bradley

Bradley Express MG Series Bedienungsanleitung

Bradley

Bradley S19-230 Bedienungsanleitung

Bradley

Bradley Verge LVLD Series Bedienungsanleitung

Bradley

Bradley S19-304GA Bedienungsanleitung

Bradley

Bradley Sentry SN2004/IR Bedienungsanleitung

Bradley

Bradley S24-210 Bedienungsanleitung

Bradley

Bradley Express MG Series Bedienungsanleitung

Bradley

Bradley Terreon Classic WF2500 Series Bedienungsanleitung

Bradley

Bradley S19-110SS Bedienungsanleitung

Bradley

Bradley S19-210FW Bedienungsanleitung

Bradley

Bradley S19-120FMBF Bedienungsanleitung

Bradley

Bradley Verge Crestt Series Kurzanleitung

Bradley

Bradley HN200 Bedienungsanleitung

Bradley

Bradley S19-270C Bedienungsanleitung

Bradley

Bradley S19-125SBF Bedienungsanleitung

Bradley

Bradley Aerada 90-80 Series Bedienungsanleitung

Bradley

Bradley S19-630 Bedienungsanleitung

Bradley

Bradley S19294 Series Bedienungsanleitung

Bradley

Bradley S19-220SC Bedienungsanleitung

Bradley

Bradley COMBI5500 Handbuch

Bradley

Bradley S19-788 Bedienungsanleitung

Bradley

Bradley HN-400 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema