Clarke CAX3TA Bedienungsanleitung

INSTRUCTIONS

GC0219 - ISS 2

1.5 TONNE AXLE STAND

MODEL NO: CAX3TA

PART NO: 7600030

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12 months from

the date of purchase. Please keep your receipt which will be required as proof of

purchase.

This guarantee is invalid if the product is found to have been abused or tampered with

in any way, or not used for the purpose for which it was intended.

Faulty goods should be returned to their place of purchase, no product can be

returned to us without prior permission. This guarantee does not effect your statutory

rights

SAFETY WARNINGS

• Read these instructions carefully

before use.

• Do not exceed the axle stands

maximum load (1500 kg each /

3000 kg per pair), The vehicle

weight will be stated in the owners

manual.

• Use only as specified in this manual.

• NEVER let children play in or around

a vehicle that is on axle stands.

• ALWAYS make sure that before you

work below the vehicle, a

responsible person is aware in case of injury or accident.

• Do not use more than one pair of axle stands.

• Replace the warning label if it becomes unreadable.

• Use only on a hard, flat surface, for example concrete.

• Make sure that you chock all the wheels that remain on the ground.

• Make sure that the supported vehicle cannot move.

• Set each axle stand below an appropriate point on the vehicle - See your vehicle

owners manual for advice.

• Take care when using the axle stands on a three-wheeled vehicle or trailer.

• Use stands as a matched pair to support one end of a vehicle only.

• For your safety, do not modify these axle stands.

WARNING: NEVER WORK UNDER A VEHICLE SUPPORTED ONLY BY A JACK.

WARNING: AFTER LIFTING THE VEHICLE, SUPPORT IMMEDIATELY WITH PROPERLY

RATED AXLE STANDS

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY

1. Slide the lower column into the base.

2. Secure in place using the spring washer

and bolt as shown on the right.

USING THE AXLE STANDS

1. Refer to the vehicle handbook for the

correct jacking procedure and

location of support points.

2. Raise the vehicle using a suitable lifting

jack.

ADJUST THE AXLE STAND

1. Remove the locking pin (if fitted).

2. Raise the upper column to the required

height and replace the locking pin.

3. Position the axle stand under a suitable

supporting point. See your vehicle

manual for the location.

WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY PART OF

THE AXLE STAND, IF THERE IS, DO NOT USE.

WARNING: DO NOT EXCEED THE RATED LOAD OF 3000 KG PER PAIR OR 1500 KG

PER STAND.

WARNING: USE ONLY ON A HARD, FLAT SURFACE, E.G. CONCRETE.

WARNING: IT MUST BE ENSURED THAT THE VEHICLE/LOAD IS CAREFULLY LOCATED

ONTO THE CENTRE OF THE AXLE STAND SADDLE. FAILURE TO DO THIS CAN RESULT

IN DAMAGE TO THE AXLE STANDS, LOSS OF SUPPORT TO THE LOAD, SERIOUS

PERSONAL INJURY OR LOSS OF LIFE.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

LOWERING THE VEHICLE

1. Slowly lower the vehicle onto the centre of the saddle.

TO REMOVE THE AXLE STANDS

1. Raise vehicle clear of the axle stands.

2. Remove stands.

3. Ensure that all tools, equipment and personnel are clear before carefully

lowering the vehicle to the ground.

SPECIFICATION

WARNING: DO NOT LOAD THE STANDS OFF CENTRE. FAILURE TO HEED THIS

WARNING MAY CAUSE DAMAGE, INJURY OR LOSS OF LIFE.

Maximum Height 391 mm

Minimum Height 266 mm

Maximum Load 3000 kg per pair or 1500 kg per stand

Product Weight 4.6 kg per pair

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Rack & Stand Handbücher

Clarke

Clarke LB7S Bedienungsanleitung

Clarke

Clarke CWMWR1 Bedienungsanleitung

Clarke

Clarke CT100PR Bedienungsanleitung

Clarke

Clarke CSR4550BO Bedienungsanleitung

Clarke

Clarke CBS3 Bedienungsanleitung

Clarke

Clarke CGR1 Bedienungsanleitung

Clarke

Clarke LB5S Bedienungsanleitung

Clarke

Clarke CMSS Bedienungsanleitung

Clarke

Clarke CTA150 Bedienungsanleitung

Clarke

Clarke CAX3TBC Bedienungsanleitung

Clarke

Clarke CTS4000B Bedienungsanleitung

Clarke

Clarke CAX3TAB Bedienungsanleitung

Clarke

Clarke CES680F Betriebsanleitung

Clarke

Clarke CARS1 Bedienungsanleitung

Clarke

Clarke STRONG-ARM CAX3TPB Bedienungsanleitung

Clarke

Clarke CWR1 Bedienungsanleitung

Clarke

Clarke CWC80B Bedienungsanleitung

Clarke

Clarke CMS1 Bedienungsanleitung

Clarke

Clarke MDS1 Bedienungsanleitung

Clarke

Clarke CHT399 Bedienungsanleitung

Clarke

Clarke MCD1 Bedienungsanleitung

Clarke

Clarke CSR4200 Bedienungsanleitung

Clarke

Clarke CSM5175 Series Bedienungsanleitung

Clarke

Clarke Strong-Arm CES340 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung