Code Alarm CATX110 Betriebsanleitung

Model CATX110

Programming Guide

The keychain transmitters included with the system have

been pre-programmed at the factory, with each button pre-

assigned to control a specific function of the system.

It is important to remember that during programming, each

individual step of the procedure must be executed within 15

seconds of the previous step.

When the 15 second time limit is allowed to expire, the

system will automatically terminate the programming mode.

This is indicated by a long chirp from the siren.

Additionally, the system will store codes from up to 4

different transmitters. If a 5th transmitter is programmed to

any receiver channel, then the first transmitterprogrammed

to that channel will be erased from the system’s memory.

To program new or additional transmitters, the alarm must

be disarmed and the valet switch must be in the OFF

position:

1. Enter the vehicle, and turn the ignition key to the ON

position.

2. Flip the valet switch ON then OFF 3 times

3. The dash LED will flash one time, and the sounding

device will beep one time, indication the system is ready to

accept programming for receiver channel 1.

4. Press and hold the Arm/Disarm Icon button until the

sounding device emits a long beep, indicating the signal

has been stored into memory.

5. If you have additional transmitters (up to 4) that need to

be programmed, repeat step 4 for each transmitter.

Changing the Remote Control Battery

The 12-volt alkaline battery supplied in your remote transmitter should last

approximately one year, depending on usage. When the battery begins to

weaken, you will notice a decrease in range, or the distance from your vehicle

that your remote transmitter will operate. Follow the instructions below to

change the remote transmitter battery.

For Customer Service and Product information Call

1-800-421-3209

1. Insert the edge of a coin into the slot at the side of the remote

control. Twist the coin to pry the remote control halves apart.

2. Remove the old battery and replace with a new one. Besure to

observe the (+) and (-) signs in the battery compartment.

3. Carefully snap the case halves back together, then test the

remote control.

Model CATX110

Programming Guide

Inhaltsverzeichnis

Andere Code Alarm Autoalarmanlage Handbücher

Code Alarm

Code Alarm CA-130 Bedienungsanleitung

Code Alarm

Code Alarm CA 180 Bedienungsanleitung

Code Alarm

Code Alarm CA- 550 Bedienungsanleitung

Code Alarm

Code Alarm ca6355E Bedienungsanleitung

Code Alarm

Code Alarm CA 510 Bedienungsanleitung

Code Alarm

Code Alarm CATX510 Betriebsanleitung

Code Alarm

Code Alarm ca 1151 Bedienungsanleitung

Code Alarm

Code Alarm CA 650 Bedienungsanleitung

Code Alarm

Code Alarm Ca 1053 Bedienungsanleitung

Code Alarm

Code Alarm ca1554 Bedienungsanleitung

Code Alarm

Code Alarm Elite ca1155E Bedienungsanleitung

Code Alarm

Code Alarm Professional ca6153 Bedienungsanleitung

Code Alarm

Code Alarm CA 421 Bedienungsanleitung

Code Alarm

Code Alarm CA1B5 Bedienungsanleitung

Code Alarm

Code Alarm CA 110 Bedienungsanleitung

Code Alarm

Code Alarm CA 610 Bedienungsanleitung

Code Alarm

Code Alarm CA-640 Bedienungsanleitung

Code Alarm

Code Alarm CATX2LCD Betriebsanleitung

Code Alarm

Code Alarm ca1153 Bedienungsanleitung

Code Alarm

Code Alarm 2000 Bedienungsanleitung

Code Alarm

Code Alarm ca 1051 Bedienungsanleitung

Code Alarm

Code Alarm Professional 1000 Bedienungsanleitung

Code Alarm

Code Alarm CA 671 Bedienungsanleitung

Code Alarm

Code Alarm CA-135 Bedienungsanleitung

Beliebte Autoalarmanlage Handbücher anderer Marken

Clifford

Clifford 3606X Bedienungsanleitung

Ultra Start

Ultra Start 2500M SERIES Bedienungsanleitung

Ultra Start

Ultra Start 650 Series Bedienungsanleitung

Audiovox

Audiovox Prestige Platinum+ APS-511C Bedienungsanleitung

Sparkrite

Sparkrite SRA8 Bedienungsanleitung

Viper

Viper 4708V Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Pathfinder Siren Series Handbuch

Falcon

Falcon Predator XL3 Benutzerhandbuch

Audiovox

Audiovox Auto Security XR91 Betriebsanleitung

Clifford

Clifford Sabre II Bedienungsanleitung

CrimeStopper

CrimeStopper CS-8717 Kurzanleitung

Ultra Start

Ultra Start 450 SERIES Bedienungsanleitung

Scytek electronic

Scytek electronic Vectra X3 Bedienungsanleitung

Excalibur

Excalibur AL-1860-EDPB Bedienungsanleitung

Clifford

Clifford CYBER 2 Bedienungsanleitung

Gemini

Gemini 7057 Bedienungsanleitung

FlashLogic

FlashLogic FLRSBA PRESTIGE Bedienungsanleitung

Magicar

Magicar FAI-440 Bedienungsanleitung