Crosswater Arcade US-ARC14 Bedienungsanleitung

Installation Instructions

5-1/2"

3/4" dia

2-1/2" dia

1-3/8" dia

4-3/4"

3/4" max

8-1/2"

Adjustable

wrench

Channel

locks

Plumbers’ putty

or caulking

Flat head

screwdriver

Cross head

screwdriver

Hexagonal

key

Arcade Single-hole Basin Faucet

US-ARC14

Introduction

Installation notes

The faucets in this range are single flow (hot and cold water mix in

the body) and should therefore be supplied with hot and cold water

at balanced pressures. If the faucets are not supplied at balanced

pressures then the mixer will not function correctly.

The minimum water pressure required for these faucets is 7.2 psi.

The maximum water pressure is 72 psi, (beyond which pressure

reducing valves must be installed).

The faucets are fitted with quarter-turn ceramic disc cartridges which

provide a good flow rate with very smooth movement.

IMPORTANT: Please read these instructions carefully before you

begin and retain for future reference. These instructions have

been prepared for your guidance, you must exercise due care at

all times.

Before beginning installation, check for any damage that may have

occurred during transport. Note: Damage claims cannot be made

during or after installation.

We do not accept responsibility for any problems that may occur

through incorrect installation.

Dimensions

Tools required

The installation must comply with all plumbing codes including

local

codes and be installed by a licensed plumbing contractor.

WARNING! Before installing a new faucet,it is essential that the

supply pipes are thoroughly flushed in order to remove any remaining

debris, solder or other impurities. Failure to carry out this simple

procedure can cause problems or damage to the working of the

faucet.

Installing shut-off valves on incoming supply lines is recommended

for ease of maintenance.

Turn off the main water supply before connecting to any existing

pipework or doing any maintenance.

WARNING! Please check for any hidden pipes and cables, electric

or otherwise,before drilling holes in a wall or floor.

FAUCET BODY

SPOUT

MALE SCREW

FLEXIBLE HOSE

“O” RING

RUBBER WASHER

BRASS WASHER

FEMALE SCREW

SPANNER

Flow Straightener

Aerator

lShut off the water heating system then, with the main water

supply turned off, open the lowest hot and cold faucets and

allow to drain until supply pipes are empty.

Fit the “O” ring into the groove on the underside of the faucet

body.

Screw the male screw and the flexible hoses into the mixer

body, and fully tighten by hand.

Pass the tail of flexible pipes through the hole on the basin from

above, and place the mixer in position on the basin, to see if any

alteration to the existing supply pipework is necessary. Make

any necessary alterations to the pipework.

lTighten the rubber washer, the brass washer with the female screw

from the underside of the counter/basin.

lCheck that the mixer body is correctly positioned, fully tighten the

female screw.

lConnect the water supply pipes to the tails of the flexible hoses for

the hot water and cold water.

ATTENTION:Check all new connections for leaks.

lOnce satisfied there are no leaks, turn on the heating system.

1Installation

Cleaning the cartridge

lThe concealed cartridge should give trouble-free service

however servicing is a straightforward process.

To remove the cartridge

lWith the water supply turned off, carefully unscrew the top of the

faucet and then use a suitable adjustable spanner to loosen the nut.

lTake the cartrudge out and wash it with clean running water.

lMake sure any trapped debris has been removed.

lDry and lightly grease the seal, (only use silicone grease).

lRefit the cartridge followed by the handle body and lever.

2Maintenance

lThe faucet is supplied with factory-fitted flow straightener filters

for low pressure water systems. If the water pressure is high

(above 14.5 psi ), replace the flow straightener filter with the high

pressure Neoperl aerator filter (supplied in the box).

lUse the Neoperl key supplied to unscrew the flow straightener

from the nozzle. Replace with the

aerator filter. If the supplied Neoperl key is misplaced,

use the top of the spare filter to unscrew the

lter from the nozzle.

lTighten the set screw back up.

Before use

lUnscrew the filter and allow the

water to run freely for 5 minutes.

Screw the filter back into the nozzle

once all impurities have been

flushed from the water supply.

Periodically

lUnscrew the lter from the nozzle

and rinse with clean running

water. Once all loose debris and

dirt has been cleared replace the

lter into the nozzle and tighten.

3Filter Nozzle Maintenance

Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.

For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757

Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068

www.crosswaterlondon.com

email: technical@crosswaterlondon.com

Issue date: 15092019

4 Cleaning Instructions

Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any overspray.

This will maintain the finish and avoid water spotting.

To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product.

Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup. Follow instructions

to ensure optimum results.

Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or disinfectants

will alter the surface finish and void the warranty.

Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to

remain on the surface. Prolonged contact will alter surface finishes and void the warranty.

We DO NOT recommend using any household cleaners as many can cause damage to the finish.

Please see the website for care instructions for specific finishes. Follow instructions to ensure optimum results.

Inhaltsverzeichnis

Andere Crosswater Sanitärprodukte Handbücher

Crosswater

Crosswater Waldorf US-WF0613 Bedienungsanleitung

Crosswater

Crosswater US-SP380 Bedienungsanleitung

Crosswater

Crosswater Solo Produkthandbuch

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Crosswater

Crosswater US-BSW0101 Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF135 Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF130 Bedienungsanleitung

Crosswater

Crosswater US-PRO120 Bedienungsanleitung

Crosswater

Crosswater WS2001RC Bedienungsanleitung

Crosswater

Crosswater Fenmore 28-20-T Bedienungsanleitung

Crosswater

Crosswater Wisp US-WP418 Bedienungsanleitung

Crosswater

Crosswater Leyden Robe Hook 14-51 Bedienungsanleitung

Crosswater

Crosswater Leyden 14-05 Bedienungsanleitung

Crosswater

Crosswater Classic Console Series Bedienungsanleitung

Crosswater

Crosswater SIMPONS CLIC DOUBLE PANE BATH SCREEN... Bedienungsanleitung

Crosswater

Crosswater LIBRA LB6117C Series Bedienungsanleitung

Crosswater

Crosswater 1000 Series Bedienungsanleitung

Crosswater

Crosswater Belgravia Wall Union US-BL004 Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL422 Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARC600 Bedienungsanleitung

Crosswater

Crosswater Berea 11-01 Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARC15 Bedienungsanleitung

Crosswater

Crosswater 17-20-T Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL002 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema