Crosswater Classic Console Series Bedienungsanleitung

Installation Instructions

Tape

measure

Safety

glasses

Hammer Flat head

screwdriver

1/4”

drill

Pencil Spirit

level

Tools required

Floor nipples

Rubber washers

Floor nipple washers

Installation notes

The installation must comply with all plumbing codes including local

codes and be installed by a licensed plumbing contractor.

Assemble the parts on a mat to protect against scratching the surface.

Avoid getting cement, grit, sand or masonry products on to the surface.

Protect and cover the basin during the installation period to prevent

damage from occurring.

IMPORTANT: Turn off the main water supply before connecting to

any existing pipework or doing any maintenance.

WARNING! Please check for any hidden pipes and cables, electric

or otherwise,before drilling holes in a wall or floor.

Introduction

All parts have been fully inspected throughout the production

process and only leaves our factory after a 15-step QC process.

Carefully remove the items from the box and check that all parts have

been supplied.

Installation should be completed by at least two suitably competent

installers

Before beginning installation, please check for any damage that may

have occurred during transport. Note: Damage claims cannot be

made during or after installation.

Improper installation shall result in loss of warranty in case of

damage caused by impacts or rubbing against rough surfaces.

Wall fixings are not supplied. Source fixings which are suitable to the

site wall.

IMPORTANT: Please read these instructions carefully before

beginning and retain for future reference.

We do not accept responsibility for any problems that may occur

through incorrect installation.

Classic Console US-B15/US-T49

Classic Pedestal Basin US-B15/US-P6

Parts supplied - basin stand

NOTE: At this stage, if you are using the US-T49 basin stand

extension kit (sold separately), refer to step 5 and then

proceed to step 6.

2 3/8”

1Installation - basin stand

4 5

Please make sure you have the correct basin suitable for the basin legs, US-B15 is recommended.

Attach the two horizontal rails to the front rail. Attach both feet to the legs.

Screw the legs into the rail. If the US-T49 basin stand extension kit is being installed,

please refer to the illustration shown below. The kit will raise

the final height of the basin by 2-3/8".

1/4”

Fix the oor nipples onto the

oor. There are 6 oor nipple

washers supplied. These can

be inserted onto the oor nipples

to adjust for an uneven oor.

6 7

Check that the horizontal bracket bar is vertical using a spirit

level.

Determine the nal installation position and mark the 4 wall

and two oor xing hole positions in pencil. Please make sure

to include the floor nipples (and washers if necessary) when

determining the installation position because the stand may

elevate after the oor nipples are tted.

8 9

Using a 1/4”drill bit,drill the six holes on the marked

positions.

Fit the two legs over the oor nipples.

Issue date: 05122019

Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.

For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757

Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068

www.crosswaterlondon.com

email: technical@crosswaterlondon.com

The top part of the rail

can be adjusted slightly

if the basin is not level.

1Installation - pedestal

2Installation

10 11

Fix each of the two brackets onto the wall.

Ensure that the screw heads are parallel to the floor.

Place 4 rubber washers into the 4 recesses as shown.

Place the basin in position ensuring that it is level. The basin

must be fixed to the wall at the rear using appropriate wall

fixing screws. For a marble basin, please refer to installation

instructions that come with the basin.

lPlace the basin in position, against the wall and sitting on top of the

pedestal.

lEnsure that the basin is level and then mark the required fixing hole

locations on the wall, then proceed to drill.

lUsing appropriate fixings, attach the basin to the wall securely.

lThe pedestal under the basin is for decoration only and is not

designed to support the weight of the basin.

A simple routine of regular care will keep your vitreous china and fireclay products clean and fresh.

Rinse away any traces of soap and gently dry with a clean soft cloth after each use. A mild detergent, warm water and a soft cloth will remove

normal dirt and soap accumulations from surfaces. Soft abrasive cleaners may be used on vitreous china and fireclay. Never use abrasive

cleaners without water. Do not use caustic cleaners or disinfectants as they can alter the surface finish and void the warranty.

Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to

remain on the surface. Prolonged contact can alter surface finishes and void the warranty.

3 Cleaning Instructions

Note: We recommend that the 4 rubber washers

are not to be used if installing a marble basin on to

the stand.

Length and width dimensions

are measured at the narrowest

part of the opening:

L 4-1/2", W 3", H 25-3/4"

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Crosswater Sanitärprodukte Handbücher

Crosswater

Crosswater Arcade US-ARC15 Bedienungsanleitung

Crosswater

Crosswater INFINITY 500mm FURNITURE Bedienungsanleitung

Crosswater

Crosswater Leyden 14-05 Bedienungsanleitung

Crosswater

Crosswater US-ARC953 Bedienungsanleitung

Crosswater

Crosswater Fenmore 28-15P-T Bedienungsanleitung

Crosswater

Crosswater US-PRO120 Bedienungsanleitung

Crosswater

Crosswater SIMPONS CLIC DOUBLE PANE BATH SCREEN... Bedienungsanleitung

Crosswater

Crosswater 11-04 Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL422 Bedienungsanleitung

Crosswater

Crosswater MPRO US-PRO418 Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL130 Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL440 Bedienungsanleitung

Crosswater

Crosswater US-BSW0101 Bedienungsanleitung

Crosswater

Crosswater Belgravia Wall Union US-BL004 Bedienungsanleitung

Crosswater

Crosswater Darby 15-16-T Bedienungsanleitung

Crosswater

Crosswater WS2001RC Bedienungsanleitung

Crosswater

Crosswater Leyden 14X-03-T Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARC14 Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF0613 Bedienungsanleitung

Crosswater

Crosswater Solo Produkthandbuch

Crosswater

Crosswater US-SP380 Bedienungsanleitung

Crosswater

Crosswater ATOLL SQUARE EXPOSED THERMO SHOWER VALVE... Bedienungsanleitung

Crosswater

Crosswater 1000 Series Bedienungsanleitung

Crosswater

Crosswater KWC DOMO 10.061.033.000 Kurzanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema