Crosswater Belgravia US-BL002 Bedienungsanleitung

Installation Instructions

27-7/8"

3-1/8"

1/2” NPSM

Tape

measure

Safety

glasses

Set

square

Pencil Spirit

level

Silicone

sealant

Tools required

DimensionsIntroduction

The floor-standing legs have been fully inspected throughout the

production process and only leaves our factory after a 15-step QC

process.

Carefully remove the floor-standing legs from the box and check that

all parts have been supplied.

Before beginning installation, please check for any damage that may

have occurred during transport. Note: Damage claims cannot be

made during or after installation.

Improper installation shall result in loss of warranty in case of damage

caused by impacts or rubbing against rough surfaces.

Prior to installing the floor-standing legs prepare a connection of water

inlet/outlet.

The customer may choose the type and location of the faucet,

installation instructions should be supplied by the faucet manufacturer.

IMPORTANT: Please read these instructions carefully before

beginning and retain for future reference.

We do not accept responsibility for any problems that may occur

through incorrect installation.

Belgravia Floor-standing Pillar Legs

US-BL002

Installation notes

The installation must comply with all plumbing codes including

local

codes and be installed by a licensed plumbing contractor.

Anti-scald protection is the responsibility of the installer and

according to applicable codes.

Install US-AA002ROUGH first using the instructions provided with

it.

IMPORTANT! Before installing a new faucet it is essential that the

supply pipes are thoroughly flushed in order to remove any remaining

debris, solder or other impurities. Failure to carry out this simple

procedure can cause problems or damage to the working of the

faucet. Installing shut-off valves on incoming supply lines is

recommended for ease of maintenance.

Turn off the main water supply before connecting to any existing

pipework or doing any maintenance.

WARNING! Please check for any hidden pipes and cables, electric

or otherwise, before drilling holes in a wall or floor.

11/

” - 15/

”

Pre-installed US-AA002ROUGH

Floor

GASKET

SET SCREW

COLLAR

TUBE

SUPPORT

STEEL BRAIDED

HOSE

COLLAR FIXING

SCREWS

SUPPORT

SCREWS

US-AA002ROUGH

Installation

lShut off the water heating system then, with the main water supply

turned o, open the lowest hot and cold faucets and allow to drain

until supply pipes are empty.

lIdentify all components before fitting.

lBefore installing the floor-standing legs, it is necessary to install the

US-AA002ROUGH first. Follow the instructions supplied with it,

making sure the distance between floor and the bottom of the

rough is between 1-1/2” and 1-5/8”.

lInstall the floor-standing legs as per the detailed instructions that

follow.

lOnce the floor-standing legs are installed, connect the chosen

faucet.

ATTENTION:Check all new connections for leaks.

lTurn on the main water supply, close all faucets except for the new

installed faucet and as the system refills, check for leaks.

lOnce satisfied there are no leaks, switch on the heating system.

Parts list

HEIGHT ADJUSTEMT

SCREWS

FIXING SCREWS

Installation

lInstall the supports onto the rough. Line up the fixing screws and

ensure the small screw hole is facing the front, as shown opposite.

lThere are 4 height adjustment screws located in the support. Use

these to set the desired height of the support.

lSecure with the fixing bolts.

lConnect the steel braided hose onto the rough outlets.

lInstall the collar using the fixing screws supplied.

lSlide the steel braided hose through the tube.

lSlide the gasket onto the leg of the mixer.

lConnect the hose onto the leg of the mixer.

lPull the tube up tight against the gasket, then secure with the set

screw through the gasket.

Issue date: 15092019

Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.

For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757

Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068

www.crosswaterlondon.com

email: technical@crosswaterlondon.com

Rinse away any traces of soap and gently dry with a clean, soft

cloth after each use. Rinse completely with water and dry any

overspray. This will maintain the finish and avoid water spotting.

To remove mineral deposits, use a 50/50 solution of white vinegar

and water. Do not allow the solution to soak on the product.

Simichrome Polish® contains a protective film to enhance

maintenance and is helpful in preventing water spot buildup.

Follow instructions to ensure optimum results.

Never use an abrasive material such as a brush or scouring pad to

clean the surface. The use of abrasive cleaners, cleansers or

disinfectants will alter the surface finish and void the warranty.

Do not allow certain materials such as toothpaste, cologne,

shaving cream, nail polish remover, vinegar, wine, drain and glass

cleaners to remain on the surface. Prolonged contact will alter

surface finishes and void the warranty.

We DO NOT recommend using any household cleaners as

many can cause damage to the finish.

Please see the website for care instructions for specific finishes.

 Cleaning Instructions

Installation

lPush the tube fully down onto the collar, as shown

opposite.

lSecure with the set screw through the collar.

Inhaltsverzeichnis

Andere Crosswater Sanitärprodukte Handbücher

Crosswater

Crosswater KL322DC Bedienungsanleitung

Crosswater

Crosswater INFINITY 500mm FURNITURE Bedienungsanleitung

Crosswater

Crosswater Arcade US-ARC600 Bedienungsanleitung

Crosswater

Crosswater Berea 11-02-T Bedienungsanleitung

Crosswater

Crosswater Leyden 14X-03-T Bedienungsanleitung

Crosswater

Crosswater US-SP380 Bedienungsanleitung

Crosswater

Crosswater Belgravia US-BL440 Bedienungsanleitung

Crosswater

Crosswater Taos 17-19-T Bedienungsanleitung

Crosswater

Crosswater BTW0241C Bedienungsanleitung

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Crosswater

Crosswater US-PRO120 Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF0613 Bedienungsanleitung

Crosswater

Crosswater US-AL7005CW Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF135 Bedienungsanleitung

Crosswater

Crosswater 11-04 Bedienungsanleitung

Crosswater

Crosswater Berea 11-19-T Bedienungsanleitung

Crosswater

Crosswater Taos Deck-mount Tub Faucet with Handshower Trim... Bedienungsanleitung

Crosswater

Crosswater US-BTW0201 Bedienungsanleitung

Crosswater

Crosswater LIBRA LB6117C Series Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF422175 Bedienungsanleitung

Crosswater

Crosswater PRO125DNJ Bedienungsanleitung

Crosswater

Crosswater Leyden Robe Hook 14-51 Bedienungsanleitung

Crosswater

Crosswater Waldorf US-WF130 Bedienungsanleitung

Crosswater

Crosswater ATOLL SQUARE EXPOSED THERMO SHOWER VALVE... Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema