Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068
www.crosswaterlondon.com
email: technical@crosswaterlondon.com
Issue date: 18112019
NOTE: For illustration purposes
cross handle shown.
LEVER
RETAINING
SCREW
CROSS HANDLE
RETAINING
SCREW
OUTER
INDICE
SPOUT
SPOUT RING
WASHER
AERATOR
AERATOR
HOUSING
RING
CONNECTOR
O RING
DIVERTER
BODY
HANDSHOWER
O RING
O RING
INNER
INDICE
CERAMIC
INDICE
OUTER
INDICE
DIVERTER
CONNECTOR
ESCUTCHEON
O RING
WASHER
NUT
O RING
SPRING
RING
O RING
RING
WASHER
T CONNECTION
STEEL BRAIDED
HOSE
O RING
RING
O RING
CHECK
VALVE CONNECTOR
NUT WASHER
NUT
SHOWER HOSE
ESCUTCHEON
CONNECTOR
SHOWER
SUPPORT
CHECK
VALVE
O RING
WASHER
NUT
VALVE
COVER
HANDLE
EXTENSION
ESCUTCHEON O RING
CERAMIC
VALVE
WASHER
WASHER
NUT
SIDE
BODY
CARTRIDGE
Replacement parts
X1A018N-C for cold
X2A018N-H for hot
lShut off the water heating system then, with the main water
supply turned o, open the lowest hot and cold faucets and
allow to drain until supply pipes are empty.
lIdentify all components before installation.
lUse the rubber seal and lock nut provided to install the faucet to
the basin as shown below.
lConnect the hot and cold water supplies.
ATTENTION:Check all new connections for leaks.
lTurn on the main water supply, close all faucets except for the new
installed faucet and as the system refills, check for leaks.
lOnce satisfied there are no leaks, switch on the heating system.
1Installation
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any overspray. This will
maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup. Follow instructions to
ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or disinfectants will
alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to remain
on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
3 Cleaning Instructions
2Parts list
