ETC Sensor IQ DALI Control Option Card Bedienungsanleitung

ETC Installation Guide

Sensor IQ DALI Control Option Card

Corporate Headquarters Middleton, WI, USA +1 608 831 4116 London, UK +44 (0)20 8896 1000

Holzkirchen, DE +49 (80 24) 47 00-0 Rome, IT +39 (06) 32 111 683 Hong Kong +852 2799 1220 Paris, FR +33 1 4243 3535

Web etcconnect.com Support support.etcconnect.com Contact etcconnect.com/contactETC

Product information and specifications subject to change. ETC intends this document to be provided in its entirety.

7131M2160 Rev B Released 2020-06

Overview

The Sensor IQ DALI Control Option Card (IQ-DALI) controls 24 loops of 64 DALI compatible fluorescent

ballasts in broadcast mode. This document details the installation of this card in the Sensor IQ Intelligent

Breaker Panel. Information on installing option cards in other ETC panels is available at etcconnect.com.

Installation

The DALI Control Option Card can be installed on either interior wall of the low voltage

cavity.

1: There are four plastic standoffs included with the option card kit. Align the standoffs with the

mounting holes on the option card so the fins are located opposite the connectors.

2: Press gently until the plastic tabs pass through the mounting hole, locking into place.

3: Align the standoffs with the mounting holes on the interior of the low voltage cavity.

4: Press gently until the plastic tabs pass through the mounting hole, locking the option card into place.

Connect Wiring

• The Sensor IQ DALI Control Option Card provides four bus connections for termination of up to

24 DALI loops total.

• A screw connector is provided for each bus, and is labeled for ease of identification of each output.

• Each terminal accepts 4–0.25 mm2 (12–24 AWG) Class 2 or Class 1 wire. See the white paper

Understanding 0-10V LED Drivers

for Class 2 and Class 1 wiring considerations.

Note:

It is best to install any panel option kits after conduit rough-in and load wiring terminations are

complete to reduce the likelihood of damage to the option card. Reference the

Sensor IQ

Installation Manual

Note:

Control wiring must be routed in separate conduit from the line voltage wiring for DALI

ballasts.

Standoff

Mounting

hole

DALI Control

Option Card

Install option card on

either interior wall.

Fins

ETC Installation Guide

DALI Control Option Card

DALI Control Control Option Card Page 2 of 2 ETC

1: Pull DALI ballast control wiring pairs into the Sensor IQ low voltage trough. Reference the

Sensor IQ

Installation Manual

for cable routing and conduit access information.

2: Strip the insulation back from each wire pair 6 mm (1/4 in).

3: Using a 3 mm (1/8 in) flatblade screwdriver, loosen the terminals and insert each of the data + and

data - wire set into the appropriate terminal for the circuit.

• Notice the connector is labeled for your wire termination reference.

4: Tighten each screw terminal until the wire is securely held.

5: Repeat steps 1–4 for the remaining DALI outputs in the panel.

• Connect up to 24 DALI loops per system.

Connect the Wire Harness

1: Noting connector orientation, plug one end of the wire harness (supplied with the option kit) into

the option card connector.

2: Noting connector orientation, plug the second end of the wire harness into one of the option card

headers found on the circuit board mounted on the inside rear of the panel as shown below.

Remove the Option Card

1: Use a small pliers to compress the plastic tabs on the mounting pins.

2: While the tabs are compressed, gently pull the option card away from the panel.

Note:

The associated output loop terminal number should always match the relay circuit number

inside the relay panel. For example: If relay 1 is connected to a DALI ballast load, control

wiring would terminate to the IQ-DALI option board output terminals labeled “+ 1 -”.

Option card 1

header

Option card

2 header

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ETC Beleuchtungsausrüstung Handbücher

ETC

ETC Source Four jr Bedienungsanleitung

ETC

ETC Desire D22 Bedienungsanleitung

ETC

ETC Desire Fresnel Bedienungsanleitung

ETC

ETC Source Four HID jr Bedienungsanleitung

ETC

ETC Source Four LED series Bedienungsanleitung

ETC

ETC Source Four MultiPAR Bedienungsanleitung

ETC

ETC ColorSource Spot VXT Bedienungsanleitung

ETC

ETC Irideon WLZ Bedienungsanleitung

ETC

ETC Prodigy FlyPipe Studio Bedienungsanleitung

ETC

ETC fos/4 Fresnel Bedienungsanleitung

ETC

ETC fos/4 Series Bedienungsanleitung

ETC

ETC Halcyon Gold Bedienungsanleitung

ETC

ETC Express Bedienungsanleitung

ETC

ETC F-Drive W1 Series Bedienungsanleitung

ETC

ETC fos/4 Series Bedienungsanleitung

ETC

ETC Source 4WRD Bedienungsanleitung

ETC

ETC Source 4WRD Bedienungsanleitung

ETC

ETC Source Four LED Series Bedienungsanleitung

ETC

ETC Source 4WRD II Bedienungsanleitung

ETC

ETC fos/4 Series Bedienungsanleitung

ETC

ETC High End Systems SolaPix 7 Bedienungsanleitung

ETC

ETC Hog 4 Series Bedienungsanleitung

ETC

ETC Acclaim 100 series Bedienungsanleitung

ETC

ETC Desire D60 XTI Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung