Federal Signal Corporation Legend Bedienungsanleitung

Installing the Legend®and LPX

Replacement Panel Assemblies

2562302 Rev. B1 0520

Safety Message to Installers of Warning Light Equipment

People’s lives depend on your safe installation of Federal Signal products. It is important to read,

understand, and follow all instructions shipped with this product. Listed below are some other

important safety instructions and precautions you should follow:

• To properly install a light assembly, you must have a good understanding of automotive electrical

procedures and systems, along with proﬁciency in the installation and use of safety warning

equipment.

• A light system is a high current device. In order for it to function properly, make a separate ground

connection. If practical, connect it to the negative battery terminal. At a minimum, attach to a solid

metal body or chassis part that provides an eective ground path as long as the light system is to

be used.

• To be an eective warning device, this product produces bright light that can be hazardous to your

eyesight when viewed at close range. Do not stare directly into this lighting product at close range

or permanent damage to your eyesight may occur.

• Frequently inspect the light system to ensure that it is operating properly and that it is securely

attached to the vehicle.

• Refer to the instruction sheets included with related products for additional precautions and

information.

• File these instructions in a safe place and refer to them when maintaining or reinstalling the

product.

Failure to follow all safety precautions and instructions may result in property damage, serious injury,

or death.

Product Overview

The Legend/LPX light bar family uses three ROC Big Board panel assemblies. End and Intermediate

panels are two per bar, all lengths; center panels are one for 53-inch bars, two for 61-inch bars, and

three for 70-inch bars. These panels, supplied with LED Options installed, are available from the

factory on a custom order basis.

Unpacking

After unpacking the Legend and LPX Replacement Panel Assemblies, inspect the unit for damage that

may have occurred in transit. If the contents have been damaged, do not install the panel assemblies.

File a claim immediately with the carrier, stating the extent of the damage. Carefully check all

envelopes, shipping labels, and tags before removing or destroying them.

Installing the Legend and LPX Replacement Panel Assemblies

Legend and Legend LPX Replacement Panel Assemblies

Federal Signal www.fedsig.com

Installation

DISCONNECT POWER: Disconnect ALL power to the light bar before any maintenance is

performed. Failure to do so may result in property damage, serious injury, or death to you or

others.

COOL BEFORE HANDLING: After prolonged operation, the unit gets hot and can cause burns.

Do not touch the unit while or shortly after it has been operating. Always allow the unit to cool

before handling.

Removing and Inspecting the Dome

PROPERLY TIGHTEN NUTS: To prevent damage to the light bar, do not overtighten nuts.

To remove the dome:

1. Remove the barrel nuts, and then carefully remove the dome to avoid damaging the lip seal.

2. Verify that an O-ring is under the head of each barrel nut and not stuck to the dome. Use a wooden

or plastic pick to remove the O-ring from the dome to prevent tearing the O-ring.

3. Inspect lip seal (on base) and O-rings to ensure that they are not torn, brittle, or damaged. Replace if

necessary. See “Ordering Replacement Parts” on page 4.

4. Back the barrel nut counterclockwise until you hear an audible click of the threads engaging, and

then tighten normally to prevent cross-threading on reassembly.

Figure 1 Four barrel nuts in dome

290A5678

Replacing Panel Assembly

To replace the panel assembly:

1. Remove the dome. (See “Removing and Inspecting the Dome” above.) Remove the PCB ground

screw and invert thePanel assembly.

2. Note and record the connections, and then disconnect the wires and harnesses.

3. If required, remove the controller. See “Replacing the PCB Controller” on page 3.

4. Assembly is the reverse of disassembly. Ensure that the ground leads are in place. Do not

overtighten the screws.

Installing the Legend and LPX Replacement Panel Assemblies

Legend and Legend LPX Replacement Panel Assemblies

Federal Signal www.fedsig.com 3

Replacing the PCB Controller

To replace the PCB controller:

1. Remove the passenger .side end dome (See “Removing and Inspecting the Dome” on page 2.)

Remove the PCB ground nut from the end PCB, and invert the PCB, noting ground lead placement

on the ground bracket.

2. Note and record the connections, and then disconnect the wires and harnesses.

3. Compress the lock tab on the nylon standos and remove the controller with standos from the main

PCB.

4. Compress the secondary lock tabs and remove the standos from the controller.

5. Assembly is the reverse of disassembly. Ensure that the ground leads are in place.

Figure 2 Controller and stando󰀨s removed from panel

Passenger Side

End PCB

Controller

290A6861

Nylon Standoff (4)

Getting Technical Support

For technical support, please contact:

Federal Signal Corporation

Service Department

Phone: 1-800-433-9132

Email: [email protected]

Getting Repair Service

The Federal Signal factory provides technical assistance with any problems that cannot be handled

locally. Any product returned to Federal Signal for service, inspection, or repair must be accompanied

by a Return Material Authorization (RMA). Obtain a RMA from a local Distributor or Manufacturer’s

Representative. Provide a brief explanation of the service requested, or the nature of the malfunction.

Installing the Legend and LPX Replacement Panel Assemblies

Legend and Legend LPX Replacement Panel Assemblies

Federal Signal www.fedsig.com

Address all communications and shipments to the following:

Federal Signal Corporation

Service Department

2645 Federal Signal Dr.

University Park, IL 60484-3167

Limited Warranty

This product is subject to and covered by a limited warranty, a copy of which can be found at

www.fedsig.com/SSG-Warranty. A copy of this limited warranty can also be obtained by written request

to Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to info@fedsig.

com or call +1 708-534-3400.

This limited warranty is in lieu of all other warranties, express or implied, contractual or statutory,

including, but not limited to the warranty of merchantability, warranty of ﬁtness for a particular purpose

and any warranty against failure of its essential purpose.

Ordering Replacement Parts

To order replacement parts, call Customer Support at 1-800-264-3578, 7AM to 5 PM, Monday through

Friday (CT) or contact your nearest distributor.

Table 1 Replacement Parts

Description Part Number

PCB Assembly, End (Congured) Contact Customer Support

PCB Assembly, Intermediate (Congured) Contact Customer Support

PCB Assembly, Center (Congured) Contact Customer Support

PCB Assembly, Controller Contact Customer Support

Fuse, Mini, 15 Amp 148181-06

Seal, Lip, Clear (5.5 ft per end section; 3.5 ft per center section) 8583020-01

O-Ring, Dome Nut 7067016

Stando󰀨, Nylon 230315

2645 Federal Signal Drive

University Park, Illinois 60484-3167

www.fedsig.com

Customer Support

Police/Fire-EMS: 800-264-3578 • +1 708 534-3400

Work Truck: 800-824-0254 • +1 708 534-3400

Technical Support: 800-433-9132 • +1 708 534-3400

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Federal Signal Corporation Autozubehör Handbücher

Federal Signal Corporation

Federal Signal Corporation RAYDIAN Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CUDA TRIOPTIC 351011 Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Vision SLR Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation Vision SLR Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation SIFMH Handbuch

Federal Signal Corporation

Federal Signal Corporation DFC-WC-DUR21 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Vision SLR Original Betriebsanleitung

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120A Handbuch

Federal Signal Corporation

Federal Signal Corporation Spectralux Rear ILS Light Bar Handbuch

Federal Signal Corporation

Federal Signal Corporation CAMLCD-AHD-70 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Fireball FB2LED Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Vista Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation VIPER EXT Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Legend LGD Einrichtungshandbuch

Federal Signal Corporation

Federal Signal Corporation Cuda TriOptic 351014F Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ML-PT Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Commander 371LED-120B Handbuch

Federal Signal Corporation

Federal Signal Corporation GH1K Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation CAMSET56-AHD-NTSC2 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation 7000 Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation ESB-IMP08R Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation Viewpoint FV Series Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation LEDTCL97 Kurzanleitung

Federal Signal Corporation

Federal Signal Corporation CommCenter D1 Series Kurzanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung