Front Runner SSAM009 Bedienungsanleitung

4 Cub Box DrawER WIDE

SSAM009

ENG

45 min

IMPORTANT WARNING!

READ ME !

FRONT RUNNER CAN NOT RECOMMEND A MAXIMUM LOAD CARRYING CAPACITY. PLEASE REFER TO YOUR VEHICLE MANUFACTURER'S RECOMMENDATIONS. IT IS CRITICAL

THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN

AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS

TO YOUR VEHICLE. CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE. THEREFORE YOU

MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU

DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE

INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

SSAM009_REV_A01

Thank you for purchasing a Front Runner 4 Cub Box Drawer Wide.

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received.

Refer to Page 2 for a list of all the components, quantities and tools required.

READ ME !

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please cal us if you have any questions about the installation of this product.

SSAM009_REV_A01

In order for your Drawer to open freely over the vehicles plastic trim you may need a Drawer Mount Kit SSCA020 / SSCA021. (SOLD SEPARATELY)

Refer to these ﬁtting instructions ﬁrst should you be using a mount kit.

READ ME !

TOOLS NEEDED

10MM

1 1 X 4 Cub Box Drawer Wide

2 4 X M6 x 30 Hex Bolt

3 4 X M6 Spring Washer

4 4 X M6 x 30 x 1 Fender Washer

5 4 X M6 Rivnut

6 1 X SSCA020

7 1 X SSCA021

FIGURE 1.1

13MM

4MM

6.5MM

GET ORGANIZED

IN THE BOX

SOLD SEPARATELY

Sealant

FIT AND SECURE

2.1

2.2

FITMENT WITHOUT MOUNTING KIT

Place the Drawer (Item 1) in the vehicle

and position it. Make sure the Drawer

opens & closes freely without touching

the plastic trim on the trunk ﬂoor.

Once the Drawer (Item 1) is in position,

mark the four mounting hole positions.

Remove the Drawer and check for

clearance on all marked holes, above &

below the mounting surface. Start with a

4mm drill bit and drill pilot holes. Finally

use the 6.5mm drill bit and redrill holes.

Use anti-rust on all holes drilled.

Secure the Drawer (Item 1) to the vehicle

using M6 x 30 Hex Bolts, M6 x 30 x 1

Fender Washers, M6 Spring Washer and M6

Rivnut. (Item 2,3,4 & 5) as shown. Use

silicon to create a water proof seal.

FITMENT USING A MOUNTING KIT

Use the hardware & ﬁtting instructions

received with (SSCA020 / SSCA021)

After ﬁtting the mounting kit slide three

M8 Channel Nuts into each of the

Aluminium Extrusions. Secure using the

M8 x 25 Hex Bolts, M8 Spring Washers and

M8 x 25 x 2 Flat Washers through the

Drawer base frame into the M8 Channel

nuts.

10MM

4MM

6.5MM

13MM

Congratulations. You did it. Take a step back and admire your work!

Be sure to tag us. We love to see our gear in action! #FrontRunnerOutfitters #BornToRoam

Share your adventures on:

INSTALL OTHER VEHICLE AND RACK ACCESSORIES

Now's the time to visit your favorite Front Runner Dealer in person or Online.

COMPLETION

3.1

Inhaltsverzeichnis

Andere Front Runner Autozubehör Handbücher

Front Runner

Front Runner Slimline II KRVA002T Bedienungsanleitung

Front Runner

Front Runner LAMS001 Bedienungsanleitung

Front Runner

Front Runner LAVT003 Bedienungsanleitung

Front Runner

Front Runner 200 Series Bedienungsanleitung

Front Runner

Front Runner LASS026 Bedienungsanleitung

Front Runner

Front Runner GOFR001 Bedienungsanleitung

Front Runner

Front Runner FAJL004 Bedienungsanleitung

Front Runner

Front Runner VACC120 Bedienungsanleitung

Front Runner

Front Runner LALD005 Bedienungsanleitung

Front Runner

Front Runner KRTT001T Bedienungsanleitung

Front Runner

Front Runner TRCA004 Bedienungsanleitung

Front Runner

Front Runner FAMG001 Bedienungsanleitung

Front Runner

Front Runner FAJK009 Bedienungsanleitung

Front Runner

Front Runner SSDR012 Bedienungsanleitung

Front Runner

Front Runner STRA057 Bedienungsanleitung

Front Runner

Front Runner SSLD001 Bedienungsanleitung

Front Runner

Front Runner SLIMLINE II Montageanleitung

Front Runner

Front Runner KRRK001T Bedienungsanleitung

Front Runner

Front Runner LAMS004 Bedienungsanleitung

Front Runner

Front Runner TRCA008 Bedienungsanleitung

Front Runner

Front Runner LALD004 Bedienungsanleitung

Front Runner

Front Runner LALD009 Bedienungsanleitung

Front Runner

Front Runner TRAC003 Bedienungsanleitung

Front Runner

Front Runner KRTT950T Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung