Kohler K-6352 Bedienungsanleitung

Installation Guide

Single-Control Kitchen Sink Faucets

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page“ Français-1”

Español, página“ Español-1”

K-6352 K-6353

1025494-2-B

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and web site are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing codes and building codes.

Shut off the water supplies.

Carefully inspect waste and supply tubing for any sign of

damage and replace if necessary.

For new installations, assemble the faucet and drain to the sink

before installing it.

Before installation, unpack the new faucet and inspect it for

damage. Return the faucet to the carton until you are ready to

install it.

Do not remove the faucet ground joints, as they contain

important back-siphonage protection.

Do not attach a dishwasher to the faucet spray outlet.

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Adjustable

Wrench Pipe

Wrench Tube Cutter Pliers

5/64" Hex

Wrench

Plumbers

Putty Strap

Wrench Thread

Sealant Socket Wrench with

7/16" Deep Socket

Assorted

Screwdrivers

1025494-2-B 2 Kohler Co.

1. Install the Mounting Stud

Disconnect the hose from the hose connector.

Screw the mounting stud into the threaded hole at the bottom of

the faucet body. The mounting stud should extend slightly

beyond the threaded hole in the body.

1. Install the Escutcheon (Optional)

NOTE: For installation on marble, do not use plumbers putty. Use

the self-adhesive gaskets provided. Remove the paper backing and

apply the gaskets (adhesive side down) over the outside holes.

For 1-hole Installations:

The escutcheon, spacer, and O-ring are not required. .Slide the

rubber washer over the faucet tubing and hose.

Insert the faucet tubing and hose into the hole.

For 3–hole Installations:

Apply a ring of plumbers putty to the underside of the

escutcheon according to the putty manufacturer’s instructions.

Insert the O-ring into the groove in the spacer.

Slide the rubber washer, escutcheon, and spacer (O-ring side

down) over the faucet tubing and hose.

Insert the faucet tubing and hose into the center hole, carefully

aligning the escutcheon.

Press down on the escutcheon and remove any excess putty.

Rubber

Washer

O-Ring

Spacer

Hose

Escutcheon

Faucet Body

Kohler Co. 3 1025494-2-B

1. Faucet Installation

From the underside of the sink, position the bracket, washer and

nut onto the mounting stud.

Position the faucet and escutcheon on the sink to obtain the

desired alignment.

Tighten the nut securing the faucet to the sink. For best access,

use a socket wrench with a 7/16” deep socket.

NOTE: The weight must be installed to act as a pull stop and to

prevent kinking damage to the hose.

For best performance, attach the weight to the hose 23” (58.4cm)

from the loose end of the hose. The weight may be moved to

adjust the pull-out length of the hose.

Carefully tighten the weight screws. Do not overtighten.

Reconnect the hose to the hose connector.

2. Install the Supplies

CAUTION: Risk of restricted waterﬂow and product damage.

Use extreme care to avoid kinking and twisting when connecting

the hoses. Hoses must not be taut when installed.

CAUTION: Risk of back siphonage. Do not remove the ground

joints from this faucet. The ground joints contain very important

back-siphonage protection. .

23" (58.4 cm)

Hose

Connector Bracket

Washer

Nut

Weight Screw

Hose

Weight

3" (7.6 cm)

or Larger Hot Cold

1025494-2-B 4 Kohler Co.

Install the Supplies (cont.)

Install the sink using the sink manufacturer’s instructions.

Connect the supply hoses to the supply stops.

Tighten all connections.

Kohler Co. 5 1025494-2-B

3. Installation Checkout

Ensure that all coupling nuts are tight.

Ensure that the lever handle is in the down position.

Open the drain.

Remove the sprayhead and screen from the end of the hose.

Position the hose in the sink.

Turn on the main water supply and open the valve for one

minute to ﬂush the ﬁtting.

Reattach the spray and screen. Turn on the water and check for

leaks. Adjust as needed.

1025494-2-B 6 Kohler Co.

4. Water Temperature Adjustments

NOTE: Prior to adjustment, make sure the handle is in the

maximum hot position.

Remove the setscrew, handle, and bonnet.

Turn on the water to the maximum temperature by pushing the

valve stem up and turning it clockwise.

Mark the current position of the temperature stop tab (top edge)

on the mounting nut with a marker or pencil.

Lift the indexer and top disc just enough to clear the valve

splines and to allow rotation.

NOTE: Each spline notch is an average 9.5_F (5.3_C) change in

temperature.

Turn the indexer, top disc, and valve stem counterclockwise until

the desired temperature is achieved.

Reinstall the indexer and top disc to the valve, making sure the

top disc is snapped fully into the indexer.

Turn off the water by pulling the valve stem down.

Reinstall the bonnet, handle, and setscrew.

Top Disc

Indexer

Handle

Setscrew

Bonnet

Mounting Nut

Splines

Valve Stem

Stop

Tab

Kohler Co. 7 1025494-2-B

USA: 1-800-4-KOHLER

Canada: 1-800-964-5590

México: 001-877-680-1310

kohler.com

1025494-2-B

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler STRAYT 37331-4 Bedienungsanleitung

Kohler

Kohler ECO 72685T-B7 Bedienungsanleitung

Kohler

Kohler STRAYT 37331M Bedienungsanleitung

Kohler

Kohler Escale 19046W Bedienungsanleitung

Kohler

Kohler Mira Showers Escape Thermostatic 9.8 kW Bedienungsanleitung

Kohler

Kohler NEW MEMOIRS K-76555T Bedienungsanleitung

Kohler

Kohler K-19481 Montageanleitung

Kohler

Kohler 31138T-4 Bedienungsanleitung

Kohler

Kohler K-5665 Montageanleitung

Kohler

Kohler K-6487 Bedienungsanleitung

Kohler

Kohler K-7776 Bedienungsanleitung

Kohler

Kohler K-514 Bedienungsanleitung

Kohler

Kohler 77980T-4 Bedienungsanleitung

Kohler

Kohler K-6946 Bedienungsanleitung

Kohler

Kohler K-T15880 Bedienungsanleitung

Kohler

Kohler K-6284 Montageanleitung

Kohler

Kohler K-476, K-477 Montageanleitung

Kohler

Kohler K-7179 Montageanleitung

Kohler

Kohler SINGULIER 8161A Bedienungsanleitung

Kohler

Kohler Mira Escape Thermostatic 9.0 kW J95Hb/c Bedienungsanleitung

Kohler

Kohler K-16230 Bedienungsanleitung

Kohler

Kohler Brenham K-1999-8-0 Bedienungsanleitung

Kohler

Kohler K-78172-BN Bedienungsanleitung

Kohler

Kohler K-7702 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung