Kohler K-6356 Bedienungsanleitung

Installation Guide

Kitchen Sink Faucet

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-6356

1025491-2-C

Tools and Materials

Before You Begin

Observe all local plumbing and building codes.

Shut off the water supplies.

Carefully inspect waste and supply tubing for any sign of

damage and replace if necessary.

Do not attach a dishwasher to the faucet spray outlet.

For new installations, assemble the faucet to the sink before

installing the sink.

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Adjustable

Wrench Tube Cutter Pliers

5/64" Hex

Wrench

Plumbers

Putty Socket Wrench with

7/16" Deep Socket

Assorted

Screwdrivers

1025491-2-C 2 Kohler Co.

1. Install the Mounting Stud

Screw the mounting stud into the threaded hole at the bottom of

the faucet body. The mounting stud should extend slightly

beyond the threaded hole in the body.

For 1-hole Installations:

NOTE: The escutcheon, spacer, and O-ring are not required.

Slide the rubber washer over the faucet tubing and hose.

Insert the faucet tubing and hose into the hole.

2. Install the Escutcheon (Optional)

NOTE: For installation on marble, do not use plumbers putty. Use

the self-adhesive gaskets provided. Remove the paper backing and

apply the gaskets (adhesive side down) over the outside holes.

Apply a bead of plumbers putty or other sealant to the underside

of the escutcheon according to the manufacturer’s instructions.

Insert the O-ring into the groove of the spacer.

Slide the rubber washer, escutcheon, and spacer (O-ring side

down) over the faucet tubing and hose.

Insert the faucet tubing and hose into the center hole, carefully

aligning the escutcheon.

Press down on the escutcheon. Remove any excess putty.

Faucet Body

Mounting Stud

Threaded Hole

Rubber

Washer

Spacer and

O-Ring

Escutcheon

Faucet Body

Kohler Co. 3 1025491-2-C

3. Secure the Faucet

Position the bracket, washer, and nut to the mounting stud from

the underside of the sink.

Position the faucet and escutcheon on the sink to obtain the

desired alignment.

Tighten the nut to secure the faucet to the sink. For best access,

use a socket wrench with a 7/16” deep socket.

Nut

Washer

Bracket

1025491-2-C 4 Kohler Co.

4. Connect the Spray Hose

Apply a ring of plumbers putty or other sealant to the spray

guide according to the manufacturer’s instructions.

Insert the spray guide into the sink hole.

Attach and tighten the spray guide nut.

Insert the spray hose end through the spray guide from the top.

Secure the hose to the external threads on the spray tube.

Apply

plumbers

putty.

Spray Hose

Spray Tube

Spray

Guide Nut

Kohler Co. 5 1025491-2-C

5. Install the Supplies

NOTE: If the supply tubes need to be cut, allow for required

penetration of the tube into the supply stop.

NOTE: If the sink is not installed, install it at this time. Be sure to

follow all instructions packed with the sink.

Allow for required penetration of the supply tubes into the

supply stops.

Cut the supply tubes as needed.

Slide the coupling nut then the ferrule onto the copper tubing.

Set the compression ﬁttings over the copper tubing.

Hand tighten the coupling nuts.

Slide the coupling nut then the ferrule onto each supply tube.

Set the compression ﬁttings over the supply tubes.

Hand tighten the coupling nuts.

NOTE: Do not apply torque to the supply ﬁttings at the bottom of

the faucet while installing or tightening the compression ﬁttings.

Carefully bend the supply tubes to align them with the supply

stops.

Slide the coupling nuts and ferrules from the stops onto the

supply tubes.

Copper

Tubing

Coupling

Nut

Compression

Fitting

Supply

Tube

Coupling

Nut

Ferrule

1025491-2-C 6 Kohler Co.

Install the Supplies (cont.)

Insert the supply tubes into the outlets of the shut-off valves.

Tighten the coupling nuts on the shut-off valves.

Turn on the water supply.

6. Installation Checkout

Remove the aerator from the end of the spout by turning it

counterclockwise.

Turn on the main water supply.

Open the faucet handle to the ON position.

Flush hot then cold water through the faucet for about one

minute.

Push the faucet handle down to the OFF position.

Reattach the aerator by turning it clockwise.

Kohler Co. 7 1025491-2-C

7. Optional Temperature Limiting Adjustment

NOTE: Before adjusting the water temperature, ensure the handle is

turned all the way to the left. This is the maximum hot position.

Loosen the setscrew.

Remove the handle and bonnet.

Turn on the water to the maximum temperature by pushing the

valve stem up and turning it clockwise.

Mark the current position of the temperature stop tab (top edge)

on the mounting nut with a marker or pencil.

Lift the indexer and top disc just enough to clear the valve

splines and to allow rotation.

NOTE: Each spline notch is an average 9.5°F (5.3°C) change in

temperature.

Turn the indexer, top disc, and valve stem counterclockwise until

the desired temperature is achieved.

Reinstall the indexer and top disc to the valve, making sure the

top disc is snapped fully into the indexer.

Turn off the water by pulling the valve stem down.

Reinstall the bonnet and handle.

Tighten the setscrew.

Top Disc

Indexer

Handle

Setscrew

Bonnet

Mounting Nut

Splines

Valve Stem

Stop Tab

1025491-2-C 8 Kohler Co.

Guide d’installation

Robinet d’évier de cuisine

Outils et matériels

Avant de commencer

Respecter tous les codes de plomberie et de bâtiment locaux.

Couper les alimentations d’eau.

Vériﬁer avec soin si l’évacuation ou les tubes d’alimentation pour

déceler tout signe d’endommagement et remplacer si nécessaire.

Ne pas connecter un lave vaisselle à la sortie du vaporisateur du

robinet.

Pour de nouvelles installations, installer le robinet sur l’évier

avant d’installer ce dernier.

Kohler Co. se réserve le droit d’apporter toutes modiﬁcations au

design des robinets et ceci sans préavis, comme spéciﬁé dans le

catalogue des prix.

Clé à molette Coupe-

tubes Pinces

Clé

hexagonale

de 5/64"

Mastic de

plombier Clé à douille

profonde de 7/16"

(1,1 cm)

Tournevis

assortis

Kohler Co. Français-1 1025491-2-C

1. Installer la tige de ﬁxation

Visser la tige de ﬁxation dans l’oriﬁce ﬁleté à la base du corps du

robinet La tige de ﬁxation devrait s’étendre légèrement au-delà de

l’oriﬁce ﬁleté dans le corps.

Pour des installations à 1 oriﬁce:

REMARQUE : L’applique, l’espaceur et le joint torique ne sont pas

nécessaires.

Glisser la rondelle en caoutchouc sur le tuyau et le ﬂexible du

robinet.

Insérer la tuyauterie du robinet et le ﬂexible dans l’oriﬁce.

2. Installer l’applique (Optionnelle)

REMARQUE : Pour une installation sur marbre,ne pas utiliser du

mastic de plombier. Utiliser les joints autocollants fournis. Retirer le

papier et appliquer les joints (côté adhésif vers le bas) sur les oriﬁces

extérieurs.

Appliquer du mastic de plombier ou un joint semblable sous

l’applique selon les instructions du fabricant du mastic.

Insérer le joint torique dans la rainure de l’espaceur.

Glisser la rondelle en caoutchouc, l’applique, et l’espaceur (joint

torique vers le bas) sur le tuyau et le ﬂexible du robinet.

Bec

Tige de

fixation

Trou fileté

Rondelle en

caoutchouc

Espaceur et

joint torique

Applique

Corps du robinet

1025491-2-C Français-2 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Loure T97330-4-CP Bedienungsanleitung

Kohler

Kohler K-6487 Bedienungsanleitung

Kohler

Kohler Portrait K-2272 Bedienungsanleitung

Kohler

Kohler 23510-BL Bedienungsanleitung

Kohler

Kohler K-13453 Betriebsanleitung

Kohler

Kohler K-4108T Bedienungs- und Wartungsanleitung

Kohler

Kohler K-14431 Montageanleitung

Kohler

Kohler Singulier 10861-4ND Bedienungsanleitung

Kohler

Kohler K-1188 Bedienungsanleitung

Kohler

Kohler K-T13140 Bedienungsanleitung

Kohler

Kohler K-7779 Montageanleitung

Kohler

Kohler K-18647 Montageanleitung

Kohler

Kohler K-13960 Bedienungsanleitung

Kohler

Kohler 10282 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Kohler

Kohler K-7779 Bedienungsanleitung

Kohler

Kohler Tableau K-14293 Bedienungsanleitung

Kohler

Kohler K-697 Montageanleitung

Kohler

Kohler C3-050 Montageanleitung

Kohler

Kohler ELLISTON 72782T-4 Bedienungsanleitung

Kohler

Kohler C3-050 Bedienungsanleitung

Kohler

Kohler Brenham K-1999-8-0 Bedienungsanleitung

Kohler

Kohler ARCHER K-2595-GW Bedienungsanleitung

Kohler

Kohler K-6665 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung