La Crosse Technology DCF-77 Bedienungsanleitung

WIRELESS 868 MHz WEATHER STATION

Instruction Manual

INTRODUCTION:

Congratulations on purchasing this Weather Station with wireless 868

MHz transmission of outdoor temperature and display of indoor

temperature, weather forecast icons and weather tendency indicators. It

is further featuring a DCF-77 radio controlled clock and alarm function.

With four easy to use function keys, this innovative product is ideal for

use in the home or office.

« Instant Transmission+» is the up and coming state-of-the-art

new wireless transmission technology, exclusively designed

and developed by LA CROSSE TECHNOLOGY.

“IT +” offers you an immediate update of all your outdoor data

measured from the transmitters: follow your climatic variations

in real-time!

LCD

Display

FEATURES:

The Weather station

•

DCF-77 Radio controlled time function with manual time setting

options

•

DCF time reception ON/OFF

•

24 hour display

•

Alarm function with snooze

•

Time zone +/- 12 hours

•

Temperature display in degree Celsius (°C)

•

Indoor and outdor temperature with MIN/MAX records

•

Manual reset of MIN/MAX records

•

3 weather forecast with weather tendency indicator

•

Wireless transmission at 868 MHz

•

Signal reception intervals at 4 seconds

•

Low battery indicator

•

Wall mounting or table standing (foldout stand)

Function keys

Foldout stand

Battery

compartment

cover

Hanging hole

The Outdoor Temperature Transmitter

•

Remote transmission of outdoor

temperature to Weather station by 868

MHz signals

•

Shower proof casing

•

Wall mounting and table-standing

SETTING UP:

Note: This weather station receives only one outdoor transmitter.

1. First, insert the batteries into the Temperature transmitter. (see

“Install and replace batteries in the Temperature transmitter“).

2. Immediately after and within 30 seconds, insert the batteries into

Weather station (see “Install and replace batteries in the

Weather station”). Once the batteries are in place, all segments of

the LCD will light up briefly. Following the time as 0:00 and the

weather icon will be displayed. If these are not displayed after 60

seconds, remove the batteries and wait for at least 30 seconds

before reinserting them.

3. After inserting the batteries, the Weather station will start receiving

data from the transmitter. The outdoor temperature and the signal

reception icon should then be displayed on the Weather station. If

this does not happen after 3 minutes, the batteries will need to be

removed from both units and reset from step 1.

4. In order to ensure sufficient 868 MHz transmission however, this

should under good conditions be a distance no more than 100

meters between the final position of the Weather Station and the

transmitter (see notes on “Mounting” and “868 MHz Reception”).

5. Once the remote temperature has been received and displayed on

the Weather station, the DCF time (radio controlled time) code

reception is automatically started. This takes typically between 3-5

minutes in good conditions.

Note:

Daily DCF reception is done at 02:00 and 03:00 every day. If the

reception at 03:00 is not successful, then at 04:00 and 05:00 and 06:00

there are other tries, until one is successful. If the reception at 06:00 is

still not successful, then the next try takes place at 02:00 next day.

If reception is successful, the received time will override the manually set

time. (Please refer also to notes on “DCF-77 Radio Controlled Time”

and “Manual Time Setting”).

HOW TO INSTALL AND REPLACE BATTERIES IN THE WEATHER

STATION

The Weather Station uses 3 x AA, IEC LR6, 1.5V batteries. When

batteries will need to be replaced,

the low battery icon will appear on

the LCD. To install and replace the

batteries, please follow the steps

below:

1. Lift up the battery

compartment cover.

2. Insert batteries observing

the correct polarity (see

marking).

3. Replace compartment cover.

HOW TO INSTALL AND REPLACE BATTERIES IN THE

TEMPERATURE TRANSMITTER

The Temperature Transmitter uses 2 x AA, IEC LR6, 1.5V battery. To

install and replace the batteries, please follow the steps below:

SET key

1. Remove the battery compartment cover at the

back of the transmitter.

2. Insert the batteries, observing the correct

polarity (see marking).

3. Replace the batterycompartment cover on the

unit.

Note:

In the event of changing batteries in any of the units, all units need to be

reset by following the setting up procedures. This is because a security

code is assigned by the transmitter at start-up and this code must be

received and stored by the Weather station in the first 3 minutes of

power being supplied to it.

BATTERY CHANGE:

It is recommended to replace the batteries in all units regularly to ensure

optimum accuracy of these units (Battery life See Specifications below).

Please participate in the preservation of the

environment. Return used batteries to an authorised

depot.

FUNCTION KEYS:

Weather station:

The weather station has four easy to use function keys.

MIN/MAX

RESET

key

ALARM key

key

Outdoor Reception

Signal icon*

MIN/MAX indoor

temperature

MIN/MAX outdoor

temperature

SET key

•

Press the key to enter manual setting modes: Time zone, Time

reception ON/OFF and Manual time

•

Stop the alarm

+ key

•

To make adjustment for various settings

•

Stop the alarm

ALARM key

•

Enter the alarm setting mode

•

Switch the alarm ON/ OFF

•

Stop the alarm

MIN/MAX RESET key

•

Press and hold to reset the MIN/MAX temperature records

•

Activate the snooze

•

Exit manual setting modes

LCD SCREEN AND SETTINGS:

Time

Indoor

Temperature in °C Outdoor

Temperature in °C

Weather tendency

indicator

Weather forecast icon

Low battery indicator

(weather

station)

Low battery indicator

(transmitter)

Radio controlled time

reception icon

Alarm icon

* When the outdoor signal is successfully received by the Weather

Station, this icon will be switched on. (If not successful, the icon will not

be shown in LCD) So user can easily see whether the last reception was

successful (icon on) or not (icon off).

For a better displayclarity, the LCD screen is split into 3sections.

Section 1 - TIME AND ALARM

•

In normal mode display of radio controlled time

•

A reception tower symbol will be shown indicating that the DCF-77

time signal is scanned for (flashing) or received (steady).

Note: The symbol will not be shown when radio time reception is

not successful or when time reception function is turned off.

•

In normal display, the alarm icon will be shown when the alarm is

turned on. Or when the snooze function is activated, the alarm icon

will be flashing.

Section 2 - WEATHER FORECAST AND WEATHER TENDENCY

ICONS

•

Display of the weather to be expected in form of three weather

symbols and two weather tendency indicators in form of an arrow,

which change their appearance depending on the air pressure

development

Section 3 – INDOOR AND OUTDOOR TEMPERATURE

•

Display the current indoor temperature and indoor MIN/MAX

records

•

Display of low battery indicator (weather station)

•

Display the current outdoor temperature and outdoor MIN/MAX

records

•

A signal reception symbol will be shown indicating that receiver is

receiving outdoor temperature

•

Display of low battery indicator (transmitter)

MANUAL SETTINGS:

The following manual settings can be done in the setting mode:

•

Time zone

•

Time reception DCF ON/OFF

•

Manual time

Press and hold the SET key for about 3 seconds to advance to the

setting mode:

TIME ZONE SETTING:

The time zone default is "0" hour. To set a different time zone:

1. The current time zone value starts flashing.

2. Use the +key to set the time zone. The range runs from 0, -1, -2…

-12, 12, 11, 10… 2, 1, 0, in consecutive 1-hour intervals.

3. Confirm with the SET key and enter the Time reception On/Off

setting.

TIME RECEPTION ON/OFF SETTING

In area where reception of the radio-controlled time (DCF time) is not

possible, the time reception function can be turned OFF. The clock will

then work as a normal Quartz clock. (Default setting is ON).

1. The digit “ON” digit will start flashing on the LCD.

2. Use the +key to turn OFF the time reception function if necessary.

3. Confirm with the SET key and enter the Manual time setting.

Time zone (flashing)

flashing

Minutes (flashing)

Hours (flashing)

Alarm icon (ON) Alarm time

Note:

If the Time Reception function is turned OFF manually, the clock will not

attempt any reception of the radio-controlled time (DCF time) as long as

the Time Reception OFF function is activated. The Time Reception icon

and the DCF icon will not be displayed on the LCD.

MANUAL TIME SETTING

In case the Weather station is not able to detect the radio-controlled time

(DCF time) signal (disturbances, transmitting distance, etc.), the time can

be manually set. The clock will then work as a normal Quartz clock.

To set the clock:

1. The hour digits start flashing in the time display section.

2. Use the +key to adjust the hours and then press SET key to go to

the minute setting.

3. The minute will be flashing. Press the +key to just the minutes.

4. Confirm with the SET key and exit the setting mode.

Note :

The unit will still try to receive the signal despite a manual setting. When

the signal is received, the manually set time will automatically be

replaced by the received time. During reception attempts, the DCF tower

icon will flash. If reception has been unsuccessful, the DCF tower icon

will not appear but reception will still be attempted.

ALARM SETTING

To set alarm:

1. Press and hold ALARM for about 3 seconds until the alarm time

display flashes.

2. The hour digit and the alarm icon will be flashing. Press the +key

to adjust the hour.

3. Press ALARM button once and minute digit will be flashing. User

shall then press +button to set the minute.

4. Press ALARM button once to confirm the setting.

5. To activate/ deactivate the alarm function, press the ALARM

button once. The display of the alarm icon represents that the

alarm is "ON".

Note: The duration of alarm sounding is 85 seconds

TO ACTIVATE THE SNOOZE FUNCTION AND STOPPING THE

ALARM:

1. When the alarm is sounding, press the MIN/MAX RESET key to

activate the snooze function. The alarm will stop and re-activate

after the snooze interval of 10 minutes.

2. To stop the alarm completely, press any keys other than the

MIN/MAX RESET key.

WEATHER FORECAST AND TENDENCY

THE WEATHER FORECASTING ICONS :

There are 3 weather icons in the second section of LCD which can be

displayed in any of the following combinations :

Rainy

Cloudy with

sunny intervals

Sunny

Andere Handbücher für DCF-77

Inhaltsverzeichnis

Andere La Crosse Technology Wetterstation Handbücher

La Crosse Technology

La Crosse Technology WS-2310TWC Technisches Datenblatt

La Crosse Technology

La Crosse Technology WS-9021U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS6207 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 327-1417BW Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology 308-145 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-2317 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9004U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WW85784 Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology Wireless Weather Station Abmessungen

La Crosse Technology

La Crosse Technology WS-3502 Bedienungsanleitung

La Crosse Technology

La Crosse Technology M76171 Abmessungen

La Crosse Technology

La Crosse Technology WS-9630U-IT-CA Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-7034U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9133U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology 512-811-BBB Bedienungsanleitung

La Crosse Technology

La Crosse Technology S85814V2 Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology 308-1415V3 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 308-1451 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-2814U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-7091 Bedienungsanleitung

La Crosse Technology

La Crosse Technology Bonus Station Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9625U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology 308A-146 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 308-2408FR Abmessungen

Beliebte Wetterstation Handbücher anderer Marken

Auriol

Auriol AHFL 433 A1 Bedienungsanleitung

Hyundai

Hyundai WS 2202 Bedienungsanleitung

NexSens

NexSens G2-HYDROMET Bedienungsanleitung

IROX

IROX HBVR761 UV-X Bedienungsanleitung

ADE

ADE WS 1711 Bedienungsanleitung

Auriol

Auriol z29592 Bedienungsanleitung

Auriol

Auriol 296289 Bedienungsanleitung

Hyundai

Hyundai WS 2266 Bedienungsanleitung

Ventus

Ventus W177 Bedienungsanleitung

National Geographic

National Geographic VA Colour RC Bedienungsanleitung

Levenhuk

Levenhuk Discovery Report WA40 Bedienungsanleitung

Instant Transmission

Instant Transmission MA 10410 Bedienungsanleitung

Lutron Electronics

Lutron Electronics PHB-318 Bedienungsanleitung

WAREMA

WAREMA EWFS Weather station eco Bedienungsanleitung

TFA

TFA 30.3013.IT Bedienungsanleitung

Oregon Scientific

Oregon Scientific RMR966PA Bedienungsanleitung

Alecto

Alecto WS-1200 Bedienungsanleitung

Oregon Scientific

Oregon Scientific Alizé BAR266 Bedienungsanleitung