La Crosse Technology WS-3502 Bedienungsanleitung

TOUCH SCREEN WEATHER STATION

(WIND AND AIR PRESSURE) WS-3502

Operation Manual

Table of Contents

1 ..................... General

2 ......................Important Touch Screen Operating Notes generally

applicable

3 ..................... Putting into Operation

3.1 ............... Wiring the System

3.2 ............... Power Supply

3.2.1 ......... Batteries

3.2.2 ......... AC/DC Mains Adapter

3.2.3 ......... Cable Connection

3.3 ............... System Start

3.4 ............... Placement

4 ..................... Setting Up

5 ..................... Display of stored Min/Max Values and Alarm Value Settings

6 ..................... Radio Controlled DCF77 Clock

7 ..................... Weather Tendency

8 ..................... Air Pressure History

9 ..................... Operating and Setting of various Functions

9.1 ............... Air Pressure

10 ................... Additional Information to Wind Function

10.1 ............. Operating and Setting of Wind Direction Function

11 ................... Operating and Setting of Backlight, Buzzer and Alarm

History Functions

11.1 ............. EL Backlight

11.2 ............. Buzzer

11.3 ............. Alarm History

12 ................... PC Connection

12.1 ............. Data Storage

12.2 ............. Data Recall

12.3 ............. Connections and Software

13 ................... Technical Data

13.1 ............. Outdoor Data

13.2 ............. Data Transmission by 433 MHz Signal and Cable

13.3 ............. Time alarm

13.4 ............. Power Supply

13.5 ............. PC Connection

13.6 ............ Dimensions

14 ................... Liability Disclaimer

1 General

Important Note:

Before inserting batteries into the units, please

carefully read the operation manual.

The shipping content of the Touch Screen Weather Station WS-3502

includes a Base Station (Receiver), a Relay Transmitter (433 MHz

Transmitter), one Wind Sensor, the respective Connecting Cables, an

AC/DC Mains Adapter and a PC Software Package on CD-ROM.

The Base Station is equipped with a Touch Screen LCD Monitor and

allows the display of a vast variety of time and weather data thanks to

a comprehensive menu (from top to bottom):

•Radio Controlled Time (Time)

•Calendar (Date)

•Weather Forecast (Tendency)

•Air Pressure and Air Pressure History (Pressure, Pressure

History)

•Wind

Furthermore on the information text display (located at the bottom of

the LCD), a number of additional data can be set up.

Note:

On the information text display, The max and min of current air

pressure, wind speed, and the maximum wind gust will be shown from

time to time. In case the set up menu is selected, the information in the

text display will be temporarily replaced by the menu operating steps.

As an important feature, the Weather Station allows by means of

the cable and software included the readout of all measured time

and weather data in the form of complete history data sets, their

processing and graphic presentation on a PC as well as their

publication on Internet Web Sites.

2 Important Touch Screen Operating Notes generally

applicable

•All actions and functions of the Weather Station are activated on

the Touch Screen by slightly touching (not pressing!) the

switching areas appearing in star (٭) symbols (only in the text

section at the bottom of the LCD) or the displayed values.

•In all modes, the setting of functions, values and units is

performed by use of the switching areas ٭ON٭or ٭OFF٭, ٭UP٭or

٭DOWN٭or by direct unit selection.

•Advancing to any next menu step with ٭NEXT٭, leaving or

terminating all respective modes with ٭EXIT٭.

•Every programming step activated by touching a switching area

on the Touch Screen is being acknowledged by an acoustic signal

(with buzzer switched ON).

•If during any process previously activated by use of the Touch

Screen no further action is activated for about 30 seconds the

active process is automatically terminated and switched back to

the normal display mode (automatic time out).

Alarm history

selection key

Time section

Weather

Tendency

section

Date section

Pressure

Histor

section

Pressure

section

Wind direction / Wind

eed / Wind

ust

Backlight section

Buzzer selection

Text Display

(Set up Display)

Alarm-On symbol

for time alarm

Alarm-On symbol

for pressure

Alarm-On symbol for wind

speed/ gust/ wind direction

Symbol showing Storm-

warnin

alarm is On

Note: The presence of the "Alarm-On icon" in the section means that

the particular alarm has been enabled.

3 Putting into Operation

At first it is to decide whether battery supply or mains supply (AC/DC

mains adapter included) will be used to operate the system. Both

methods allow the connection of the Relay Transmitter and Base

Station by cable or by 433 MHz radio signal.

Note: When putting the Weather Station into operation it is important

to carry out in close proximity (e.g. on a table) a complete wiring

and set up of the system in the configuration of its prospective

use. This step will lead to test all components for correct

AC/ DC adapter

PC COM Port cable

RelayTransmitter

operation before placing and mounting them at their final

destinations.

3.1 Wiring the System

Independently of the final power supply mode, the fixed cable of the

Wind Sensor has first to be connected to the Relay Transmitter by

plugging it into the marked receptacle.

Wireless

Transmission

Direct cable

connection

The direct cable connection of Relay Transmitter and Base Station can

be used in the following cases:

•the flexibility of 433 MHz radio transmission is not needed

•data transmission absolutely free of any environmental

interferences is wanted.

3.2 Power Supply

The provision of power to the Weather Station can be performed by

using batteries or by AC/DC mains adapter.

3.2.1 Batteries:

•First insert two Type C 1.5 V batteries into the battery

compartment of the Relay Transmitter.

•Immediately following this insert three Type AA 1.5V batteries into

the battery compartment of the Touch Screen Weather Station.

Please help in the preservation of the environment and

return used batteries to an authorized depot.

3.2.2 AC/DC Mains Adapter:

•First insert two Type C 1.5 V batteries into the battery

compartment of the Relay Transmitter.

•Immediately following this connect the AC/DC mains adapter to

the Base Station and then plug it into a regular mains outlet.

Note: In both cases, it is important to respect this order of succession

since the transmitter will send an identification code which has

to be received and stored by the Base Station within the first

few minutes of operation.

After doing this, full operation of the entire Weather Station System is

ensured.

3.2.3 Cable Connection:

One further feature of the direct cable connection mentioned in Item

3.1 above is that in case of AC/DC adapter operation, power is

provided not only to the Base Station but to the Relay Transmitter as

well by just this AC/DC adapter.

Note: System operation with cable connection while at the same time

providing power to the Base Station solely by batteries is not

recommended because of the considerably higher power

consumption. The batteries may however remain in the unit for

emergency supply in case of a power failure.

A change from cable operation to 433 MHz radio transmission

or vice versa is possible in any case since the Weather Station

will recognize this change and will automatically switch to the

appropriate operating mode.

3.3 System Start

After inserting the batteries respectively connecting the AC/DC adapter

the LCD of the Weather Station will for a few seconds display all LCD

segments for checking.

Immediately after this, the unit will enter the so called play mode

during which for about 15 minutes all measured and received weather

data are being switched through, updated and displayed. During this

time period there will be no reception of the DCF77 time information.

Note: The play mode phase allows the user of the Weather Station to

check all cables for correct connection and all components for

correct operation. The latter will be possible by manually turning

the wind-gauge, moving the weather-vane, etc.

After completing the play mode, the Touch Screen Weather Station will

automatically switch to the normal display mode from which all further

settings can be carried out by the user. At this point of time the unit will

also automatically start reception of the DCF77 time information.

Important Note:

Reception of the radio-controlled time information will only take

place after completion of the play mode (approx. 15 minutes). In

case the user wants to start the system without waiting for

completion of the play mode it can be terminated prematurely by

touching the TIME display once in the upper left corner of the

LCD.

Prior to manual setting or reception of radio-controlled time

information there will be no recording of weather history data.

3.4 Placement

After the Weather Station has been checked for correct operation with

regard to the above points and found fit, the mounting of the system

components can take place. It must be ensured however that all

components work properly together at their chosen mounting or

standing locations. If e.g. there appear to be problems with the 433

MHz radio transmission they can mostly be overcome by slightly

moving the mounting locations.

Note: Commonly the radio communication between receiver and

transmitter in the open field reaches distances of max. 100

metres approximately, provided there are no interfering

obstacles such as buildings, trees, vehicles, high voltage lines,

etc.

Radio interferences as they are created by PC screens, radios

or TV sets can in bad cases entirely cut off radio

communication. Please take this into consideration when

choosing standing or mounting locations.

4 Setting Up:

Note: Because of the default settings already determined by the

manufacturer, it may not be necessary for the majority of users

to carry out – apart from the Relative Air Pressure (see further

down) - any further basic settings. Changes however can easily

be made if desired.

For basic settings the following menu is started by touching the Touch

Screen in the center of the text display (last two lines on the LCD).

Touching the ٭SETUP٭display will enter the setup mode.

The basic settings can now be performed in the following order:

LCD Contrast →Contrast can be set in 8 steps from 0 to 7 (Default

4).

Time Zone →Time Zones can be set in the range from -12 to +12

hours (Default 0 hours for Central Europe).

DCF77 Radio Controlled Clock (RCC) →ON/OFF. In setting “OFF“

the clock is operating as a normal Quartz clock (Default RCC ON).

Inhaltsverzeichnis

Andere La Crosse Technology Wetterstation Handbücher

La Crosse Technology

La Crosse Technology WS-2510 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9210U Bedienungsanleitung

La Crosse Technology

La Crosse Technology 9245 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 308-1414Bv3 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9065TWC Bedienungsanleitung

La Crosse Technology

La Crosse Technology S85814V2 Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology 328-1415 Installationsanleitung

La Crosse Technology

La Crosse Technology C75747-AU Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-2310 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-7047U Bedienungsanleitung

La Crosse Technology

La Crosse Technology 061317 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS6205 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 327-1414W Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology WS-2811U-IT Technisches Datenblatt

La Crosse Technology

La Crosse Technology WS-7136U Bedienungsanleitung

La Crosse Technology

La Crosse Technology Wireless Temperature Station Bedienungsanleitung

La Crosse Technology

La Crosse Technology 79400 Bedienungsanleitung

La Crosse Technology

La Crosse Technology S77925V2 Bedienungsanleitung

La Crosse Technology

La Crosse Technology S98642 Betriebsanleitung

La Crosse Technology

La Crosse Technology WS-9065TWC Bedienungsanleitung

La Crosse Technology

La Crosse Technology CA80550 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS6826 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-2315AL Bedienungsanleitung

La Crosse Technology

La Crosse Technology 327-1417BW Abmessungen

Beliebte Wetterstation Handbücher anderer Marken

Auriol

Auriol AHFL 433 A1 Bedienungsanleitung

Hyundai

Hyundai WS 2202 Bedienungsanleitung

NexSens

NexSens G2-HYDROMET Bedienungsanleitung

IROX

IROX HBVR761 UV-X Bedienungsanleitung

ADE

ADE WS 1711 Bedienungsanleitung

Auriol

Auriol z29592 Bedienungsanleitung

Auriol

Auriol 296289 Bedienungsanleitung

Hyundai

Hyundai WS 2266 Bedienungsanleitung

Ventus

Ventus W177 Bedienungsanleitung

National Geographic

National Geographic VA Colour RC Bedienungsanleitung

Levenhuk

Levenhuk Discovery Report WA40 Bedienungsanleitung

Instant Transmission

Instant Transmission MA 10410 Bedienungsanleitung

Lutron Electronics

Lutron Electronics PHB-318 Bedienungsanleitung

WAREMA

WAREMA EWFS Weather station eco Bedienungsanleitung

TFA

TFA 30.3013.IT Bedienungsanleitung

Oregon Scientific

Oregon Scientific RMR966PA Bedienungsanleitung

Alecto

Alecto WS-1200 Bedienungsanleitung

Oregon Scientific

Oregon Scientific Alizé BAR266 Bedienungsanleitung