Mercia Garden Products 01OAOSB0702PB-V2 Bedienungsanleitung

For Assistance Please

Contact Customer Care on

01636 880514

2mm Drill bit

Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

All building’s should be erected by two

adults

For ease of assembly, you must pilot

drill all screw holes and ensure all

screw heads are countersunk.

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY

- Check the pack and make sure you have all the parts listed.

- When you are ready to start, make sure you have the right tools at hand

(not supplied) including a Phillips screwdriver, Stanley knife, wood saw,

step ladder and drill with 2mm bit.

- Ensure there is plenty of space and a clean dry area for assembly.

TIMBER

As with all natural materials, timber can be aected during various weather

conditions. For the duration of heavy or extended periods of rain, swelling of the

wood panels may occur. Warping of the wood may also occur during excessive

dry spells due to an interior moisture loss. Unfortunately, these processes cannot

be avoided but can be helped. It is suggested that the outdoor building is

sprayed with water during extended periods of warm sunshine and sheltered as

much as possible during rain or snow.

Our buildings are pre treated with a water based treatment**; this only helps to

protect the product during transit and for upto 3 months against mould. To

validate your guarantee and ensure longevity of the product, it is ESSENTIAL the

building is treated with a wood preserver within the rst three months of

assembly and thereafter in accordance with the manufactures recommenda-

tions. Care must be taken to ensure the product is placed on a suitable base.

BUILDING A BASE

When thinking about where the building and base is going to be constructed:

Ensure that there will be access to all sides for maintenance work and annual

treatment.

Whilst all products manufactured are made to the

highest standards of Safety and in the case of childrens

products independently tested to EN71 level, we cannot

accept responsibility for your safety whilst erecting or

using this product.

Mercia Garden Products Limited, Sutton On Trent, Newark, Nottinghamshire, NG23 6QN

www.merciagardenproducts.co.uk

CAUTION

Every eort has been made during the

manufacturing process to eliminate the

prospect of splinters on rough surfaces

of the timber. You are strongly advised

to wear gloves when working with or

handling rough sawn timer.

Ensure the base is level and is built on rm ground, to prevent distortion. Refer

to diagrams for the base dimensions, The base should be slightly smaller than

the external measurement of the building, i.e. The cladding should overlap the

base, creating a run o for water. It is also recommended that the oor be at

least 25mm above the surrounding ground level to avoid ooding.

TYPES OF BASE

- Concrete 75mm laid on top of 75mm hard-core.

- Slabs laid on 50mm of sharp sand.

P 1

01OAOSB0702PB-V2

**Protim Aquatan T5 (621)**

Your building has been treated with Aquatan.

Aquatan is a water-based concentrate which is diluted with water, the

building as been treated by the correct application of Aquatan

solution and then allowed to dry. Aquatan is a decorative nish to

colour the wood, which is applied industrially to timber fence panels

and garden buildings. Aquatan undiluted contains: boric acid,

sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl

sulphosuccinat and alcohols: 2, 4, 6-trichlorophenol.

Overall Dimensions:

Length = 0cm

Width = 0cm

Height = 0cm

Base Dimensions:

Length = 0cm

Width = 0cm

Before assembly

please make sure you have a

suitable base ready to erect your

building

MADE IN GREAT BRITAIN

123

Front Gable Back Gable Side Panel

Panel Extension

10 11 12

Floor

Small Side Panel

Floor Extension Small Roof Extension Roof Extension

Small Panel

Extension

Roof Small Roof

Door

Fixing Kit

Large Fascia - 1410mm QTY 2

Roof Eave Framing - 1795mm QTY 2

Ridge Bar - 2047mm QTY 1

Large Strip - 1662mm QTY 3

Small Strip - 1529mm QTY 3

Large Truss Arm - 1267mm QTY 1

Door Strip - 1590mm QTY 2

P 2

Please retain product label and instructions for future reference

Small Fascia - 1000mm QTY 2

Small Truss Arm - 852mm QTY 1

Roof Eave Framing - 596mm QTY 2

Fascia Block - 140mm QTY 1

Truss Support Block - 140mm QTY 2

Centre Truss Support- 350mm QTY 1

Support Block- 495mm QTY 3

Diamond Finial - QTY 2 Pad bolt

Corner Bracing

Felt

Nail Bag

50mm Screw x 53

40mm Screw x 22

30mm Screw x 121

Felt Tacks x 100

Remove transportation blocks

from the bottom of each panel

before beginning assembly. Each

Panel should have two blocks.

Assembly

T-Hinge x3

Position the floor and floor

extension as shown in the

diagram so that the floors are

flush to each other. Fix using 10x

50mm screws alternate the

fixing position along the length

of the floors.

50mm

screw x5

Step 1

5 x 50mm Screws

1mm

Fix the T-hinge to the door

using 30mm screws ensuring

that the screws go through

to the door framing.

27 x 30mm Screws

Step 2

Attach the door strips to the

inside of the door aperture

using 30mm screws.

17 17

5 x 50mm Screws

P 3

Please retain product label and instructions for future reference

Position the panels so there is equal spacing

between the floor and cladding on all 4 sides

Step 3 DO NOT SECURE THE BUILDING TO

THE FLOOR UNTIL AFTER THE

ROOF HAS BEEN FITTED.

Fix the back gable to the panel

extension with 50mm screws

as shown in diagram.

50mm

screw x3 42

3 x 50mm Screws

Step 4

Fix the side panel using 3 x

50mm screws passing thorugh

the framing of each panel.

50mm

screw x3 3 x 50mm Screws

Step 5

Fix the small panel extension

and small side panel using

the same method from steps 3

and 4.

50mm

screw x6

6 x 50mm Screws

Fix the front gable using the

same method from step 3.

Step 6

50mm

screw x6

6 x 50mm Screws

P 4

Please retain product label and instructions for future reference

Step 7

Line the support block up with the gable

framing, use 40mm screws to x.

Place the ridge bar on top of the

support block and using corner

braces x with 30mm screws.

40mm

screw

30mm

screw

8 x 30mm Screws

8 x 40mm Screws

Step 8

Position the large truss arm

where the side panels and

extensions meet, sloping down

to the building side, fix with a

50mm screw.

Align the small truss arm in

the same position on the

opposite side of the ridge bar

and fix with a 50mm screw put

in at an angle.

ENSURE SUPPORT BARS

ARE MANUALLY SUP-

PORTED UNTIL FIXED AT

BOTH ENDS

50mm

screw x2

2 x 50mm Screws

Step 9

Fix the truss support blocks to the

side panel framing with 2 x 50mm

screws. Position the block at the

top of the framing with the angle

pointing upwards into the building,

aligning the block centrally along

the join between the side panels

with one screw in each panel.

Fix the support bar to the block

using 1 x 50mm screw.

Fix roof support block with 2 x

50mm screws.

24 24

50mm

screw x8

8 x 50mm Screws

Step 10

Fix a roof eave to the

appropriate roof sheet

using 30mm screws.

Position the roof sheets

on the building and x to

the ridge bar, truss and

the sides of the building

using 30mm screws.

30mm

screw

x54

54 x 30mm Screws

P 5

Please retain product label and instructions for future reference

Step 11

Fix the support block

between the apex of the roof

ush with the edge of the

roof sheets using 30mm

screws.

Fix the fascia block in the

middle of the the large roof

sheet ush with the edge

using 30mm screws.

30mm

screw

4 x 30mm Screws

Step 12

Cut the felt into 3 sheets and

lay onto roof as shown in

diagram ensuring there is a

50mm overhang around the

sides.

Fix using felt tacks at 100mm

intervals

Felt

tacks x100

100 x Felt Tacks

Fix fascias and diamond nials

using 40mm screws to the roof eave

framing, fascia blocks and support

block. Pre drill holes to avoid

splitting. Ensure to trap the felt

between the fascia and building.

40mm

screw

x14

Step 13

14 x 40mm Screws

Step 14

Once the roof section

is secured x the panels

to the oor using 8 x

50mm screws, ensure

that the building is

square before attaching

to the oor.

50mm

screw

x20

20 x 50mm Screws

P 6

Please retain product label and instructions for future reference

Step 15

Fix cover strips in

position as shown in

diagram, use 3 x30mm

screws equally spaced

per trim. 30mm

screw

x18

16 16

18 x 30mm Screws

Step 16

Fix pad bolt with 6x30mm

screws to horizontal brace of

the door.

Then fix the pad bolt retainer

to the door gable using

4x30mm screws.

30mm

screw

x10

It is ESSENTIAL that you apply wood treat-

ment immediately after the building has

been assembled.

10 x 30mm Screws

Andere Mercia Garden Products Gartenhaus Handbücher

Mercia Garden Products

Mercia Garden Products 01DTOVAX1006DDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 0644AXNE0656LBDDHGSD1SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 02BRAM0806-V3-PEFC Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DDPENT1408-V3 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0644RANE4535FGDD2TW1SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0644CVNE0403HGDD3SW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 010VLPA0305SDNW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02DTSHOA0705LFD3WBF-V1-PEFC Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01GRO0806DD-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTSHPMOW4803-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTGRO0705-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03WES1208-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0806SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03TGCORSE0409-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03BRN0705-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTSHRAX0806SDNW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTSHAX0306DDNW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01SHPWOR1210DDOW-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0628LOG127-V5 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03DTSHCR0909GD4TW-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02RSE0505-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0304SDNW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01TDM0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01SHPSTR0402-V1 Gebrauchsanweisung

Beliebte Gartenhaus Handbücher anderer Marken

Lemeks

Lemeks Palmako PA120-5930-6 Installationshandbuch

Rion

Rion Hobby Gardener Bedienungsanleitung

Gartenhaus-King

Gartenhaus-King Valery Bedienungsanleitung

Select

Select ISAAC E9682 Bedienungsanleitung

Palmako

Palmako Saale Bedienungsanleitung

Lemeks

Lemeks Palmako Kira EL16-3623 Installationshandbuch

Palmako

Palmako Roger FR44-5953-2 Bedienungsanleitung

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Bedienungsanleitung

G21

G21 Boston 882 Bedienungsanleitung

Lemeks

Lemeks Palmako Grace PM56-4529 Installationshandbuch

Shire

Shire Salcey Bedienungsanleitung

Rutland County

Rutland County Burley 6ft Bedienungsanleitung

Palmako

Palmako Roger 27,7 Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5930-9 Installationshandbuch

Lemeks

Lemeks Palmako PM70-6436 Installationshandbuch

Lemeks

Lemeks Palmako PM56-4435 Installationshandbuch

Lemeks

Lemeks 106214 Installationshandbuch

POD

POD Camping 480 Bedienungsanleitung